參數資料
型號: TPS5602IDBTR
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: 3 A DUAL SWITCHING CONTROLLER, 202.4 kHz SWITCHING FREQ-MAX, PDSO30
封裝: GREEN, PLASTIC, TSSOP-30
文件頁數: 5/27頁
文件大?。?/td> 949K
代理商: TPS5602IDBTR
TPS5602
DUAL, FAST, HIGH EFFICIENCY CONTROLLER FOR DSP POWER
SLVS217 – JUNE 1999
13
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
application for DSP power (continued)
output capacitor RMS current
Assuming the inductor ripple current totally goes through the output capacitor to ground, the RMS current in the
output capacitor can be calculated as:
Io(rms)
+ DI
12
Where Io(rms) is the maximum RMS current in the output capacitor (A);
I is the peak–to–peak inductor ripple
current (A).
Example:
I = 2 A, so Io(rms) = 0.58 A
input capacitor RMS current
Assuming the input ripple current totally goes into the input capacitor to the power ground, the RMS current in
the input capacitor can be calculated as:
Ii(rms)
+ Io
D
(1
* D) ) (1 * D)
D
Where Ii(rms) is the input RMS current in the input capacitor (A); Io is the output current (A); D is the duty cycle.
From the equation, it can be seen that the highest input RMS current usually occurs at lowest input voltage.
Example: Io = 5 A; D = 0.36
Then, Ii(rms) = 3.36 A
softstart
The softstart timing can be adjusted by selecting the softstart capacitor value. The equation is
Csoft = 2 × Tsoft
Where Csoft is the softstart capacitance (F); Tsoft is the start-up time pin (S).
Example: Tsoft = 5 ms, so Csoft = 0.01
F.
current protection
The current protection in TPS5602 is set using an internal current source and an external resistor to set up the
current limit. The sensed high side MOSFET drain-to-source voltage drop is compared to the set point; if the
voltage drop exceeds the limit, the internal oscillator is activated, and continuously resets the current limit until
the over-current condition is removed. The equation below should be used for calculating the external resistor
value for current protection:
Rclmt
+
Rds(on)
(Itrip
) Iind(p-p) 2)
0.000015
Where Rclmt is the external current limit resistor (R10, R11); Rds(on) is the high side MOSFET on resistance;
Itrip is the required current limit; lind(p-p) is the peak-to-peak output inductor current.
Example: Rds(on) = 10 m
, Itrip = 5 A, Lind = 2 A, so Rclmt = 4 k.
相關PDF資料
PDF描述
TPS561000PWP 1.4 A SWITCHING CONTROLLER, PDSO28
TPS56100PWPR 1.4 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO28
TPS56100PWPRG4 1.4 A SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO28
TPS56121DQPT SWITCHING CONTROLLER, 1100 kHz SWITCHING FREQ-MAX, PDSO22
TPS5615CPWP SWITCHING CONTROLLER, PDSO28
相關代理商/技術參數
參數描述
TPS5602IDBTRG4 功能描述:DC/DC 開關控制器 Dual Output Synch Buck Cntrlr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS56100EVM-128 功能描述:HIGH-PERFORMANCE SYNCHRONOUS BUC RoHS:是 類別:編程器,開發系統 >> 評估板 - DC/DC 與 AC/DC(離線)SMPS 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:True Shutdown™ 主要目的:DC/DC,步升 輸出及類型:1,非隔離 功率 - 輸出:- 輸出電壓:- 電流 - 輸出:1A 輸入電壓:2.5 V ~ 5.5 V 穩壓器拓?fù)浣Y(jié)構:升壓 頻率 - 開關:3MHz 板類型:完全填充 已供物品:板 已用 IC / 零件:MAX8969
TPS56100EVM-133 功能描述:HIGH-PERFORMANCE SYNCHRONOUS BUC RoHS:是 類別:編程器,開發系統 >> 評估板 - DC/DC 與 AC/DC(離線)SMPS 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:True Shutdown™ 主要目的:DC/DC,步升 輸出及類型:1,非隔離 功率 - 輸出:- 輸出電壓:- 電流 - 輸出:1A 輸入電壓:2.5 V ~ 5.5 V 穩壓器拓?fù)浣Y(jié)構:升壓 頻率 - 開關:3MHz 板類型:完全填充 已供物品:板 已用 IC / 零件:MAX8969
TPS56100PWP 功能描述:DC/DC 開關控制器 5 Bit Programmable Sync Buck Cont RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS56100PWPG4 功能描述:DC/DC 開關控制器 5 Bit Programmable Sync Buck Cont RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK