參數資料
型號: TPS55010RTET
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: SWITCHING REGULATOR, PQCC16
封裝: 3 X 3 MM, GREEN, PLASTIC, WQFN-16
文件頁數: 4/40頁
文件大小: 1417K
代理商: TPS55010RTET
RT/CLK
TPS55010
Clock
Source
PLL
RT
RT/CLK
TPS55010
Hi-Z
Clock
Source
PLL
RT
SLVSAV0A
– APRIL 2011 – REVISED JUNE 2011
Figure 21. Synchronizing to a System Clock
Overcurrent Protection
The TPS55010 implements a cycle by cycle current limit. During each switching cycle the high side switch
current is compared to the voltage on the COMP pin. When the instantaneous switch current intersects the
COMP voltage, the high side switch is turned off. During overcurrent conditions that pull the output voltage low,
the error amplifier responds by driving the COMP pin high, increasing the switch current. The error amplifier
output is clamped internally. This clamp functions as a switch current limit.
Reverse Overcurrent Protection
The TPS55010 implements low side current protection by detecting the voltage across the low side MOSFET.
When the converter sinks current through its low side FET, the control circuit turns off the low side MOSFET if
the reverse current is more than 4.5 A
FAULT Pin
The Fault pin output is an open drain MOSFET. The output is pulled low when the VSENSE voltage is below
91% or rising above 108% of the nominal internal reference voltage. It is recommended to use a pull-up resistor
between the values of 1k
Ω and 100kΩ to a voltage source that is 6 V or less. The Fault pin is in a valid state
once the VIN input voltage is greater than 1.6 V. The FAULT pin is pulled low, if the input UVLO or thermal
shutdown is asserted, or the EN pin is pulled low.
Thermal Shutdown
The device implements an internal thermal shutdown to protect itself if the junction temperature exceeds 171
°C.
The thermal shutdown forces the device to stop switching when the junction temperature exceeds the thermal
trip threshold. Once the die temperature decreases below 159
°C, the device reinitiates the power up sequence
by discharging the SS pin to below 40 mV. The thermal shutdown hysteresis is 12
°C.
OPERATION OF THE Fly-Buck
CONVERTER
Figure 22 shows a simplified schematic and the two primary operational states of the Fly-Buck converter. The
power supply is a variation of a Flyback converter and consists of a half bridge power stage SHS and SLS,
transformer, primary side capacitor, diode and output capacitor. The output voltage is regulated indirectly by
using the primary side capacitor voltage, VPRI, as feedback. The Fly-Buck is a portmanteau of flyback and buck
since the transformer is connected as a flyback converter and the input to output voltage relationship is similar to
a buck derived converter, assuming the converter is operating in steady state and the transformer has negligible
leakage inductance.
The CPRI and LPRI are charged by the input voltage source VIN during the time the high side switch SHS is on.
During this time, diode D1 is reversed biased and the load current is supplied by output capacitor CO.
12
Copyright
2011, Texas Instruments Incorporated
相關PDF資料
PDF描述
TPS55383PWP 7 A DUAL SWITCHING CONTROLLER, 300 kHz SWITCHING FREQ-MAX, PDSO16
TPS55386PWPR 7 A DUAL SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO16
TPS5625PWPRG4 2 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO28
TPS5615PWP 2 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO28
TPS5618PWPR 2 A SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO28
相關代理商/技術參數
參數描述
TPS55065EVM 功能描述:電源管理IC開發工具 TPS55065EVM Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
TPS55065QPWPRQ1 功能描述:直流/直流開關調節器 Auto Buck/Boost Switching Reg. RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS5510D 制造商:Texas Instruments 功能描述:
TPS5510P 制造商:Texas Instruments 功能描述:
TPS5511D 制造商:Rochester Electronics LLC 功能描述:- Bulk