參數資料
型號： TPS54386PWP
廠商： TEXAS INSTRUMENTS INC
元件分類： 穩壓器
英文描述： 7 A DUAL SWITCHING CONTROLLER, 750 kHz SWITCHING FREQ-MAX, PDSO14
封裝： GREEN, PLASTIC, HTSSOP-14
文件頁數： 2/58頁
文件大?。?/td> 1773K
代理商： TPS54386PWP
www.ti.com
SLUS774B – AUGUST 2007 – REVISED OCTOBER 2007
TERMINAL FUNCTIONS (continued)
TERMINAL
I/O
DESCRIPTION
NAME
NO.
This pin configures the output startup mode. If the SEQ pin is connected to BP, then when Output 2 is
enabled, Output 1 is allowed to start after Output 2 has reached regulation; that is, sequential startup
where Output 1 is slave to Output 2. If EN2 is allowed to go high after the outputs have been operating,
then both outputs are disabled immediately, and the output voltages decay according to the load that is
present. For this sequence configuration, tie EN1 to ground.
If the SEQ pin is connected to GND, then when Output 1 is enabled, Output 2 is allowed to start after
Output 1 has reached regulation; that is, sequential startup where Output 2 is slave to Output 1. If EN1
is allowed to go high after the outputs have been operating, then both outputs are disabled immediately,
SEQ
10
I
and the output voltages decay according to the load that is present. For this sequence configuration, tie
EN2 to ground.
If left floating, Output 1 and Output 2 start ratio-metrically when both outputs are enabled at the same
time. They will soft start at a rate determined by their final output voltage and enter regulation at the
same time. If the EN1 and EN2 pins are allowed to operate independently, then the two outputs also
operate independently
NOTE: An internal two resistor (150-k
each) divider connects BP to SEQ and to GND. See the
Source (switching) output for Output 1 PWM. A snubber is recommended to reduce ringing on this
SW1
3
O
node. See SW Node Ringing for further information.
Source (switching) output for Output 2 PWM. A snubber is recommended to reduce ringing on this
SW2
12
O
node. See SW Node Ringing for further information.
Thermal Pad
-
This pad must be tied externally to a ground plane and the GND pin.
10
Copyright 2007, Texas Instruments Incorporated
Product Folder Link(s): TPS54383 TPS54386
相關PDF資料
PDF描述
TPS54383PWPG4 7 A DUAL SWITCHING CONTROLLER, 375 kHz SWITCHING FREQ-MAX, PDSO14
TPS54383PWPRG4 7 A DUAL SWITCHING CONTROLLER, 375 kHz SWITCHING FREQ-MAX, PDSO14
TPS54386PWPG4 7 A DUAL SWITCHING CONTROLLER, 750 kHz SWITCHING FREQ-MAX, PDSO14
TPS54521RHLT SWITCHING REGULATOR, PQCC14
TPS54550PWP 9.5 A SWITCHING REGULATOR, 700 kHz SWITCHING FREQ-MAX, PDSO16
相關代理商/技術參數
參數描述
TPS54386PWP 制造商:Texas Instruments 功能描述:DC/DC Controller
TPS54386PWPG4 功能描述:直流/直流開關調節器 3A Non-Synch Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS54386PWPR 功能描述:直流/直流開關調節器 DC/DC Controller RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS54386PWPRG4 功能描述:直流/直流開關調節器 3A Non-Synch Buck Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS54386PWPRQ1 制造商:TI 功能描述:DC/DC Controller
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*