- 您現在的位置：買賣IC網 > PDF目錄69509 > TPS40210QDGQRQ1 (TEXAS INSTRUMENTS INC) SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO10 PDF資料下載
參數資料
| 型號： | TPS40210QDGQRQ1 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封裝： | GREEN, PLATSIC, MSOP-10 |
| 文件頁數： | 5/41頁 |
| 文件大?。?/td> | 999K |
| 代理商： | TPS40210QDGQRQ1 |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁
T
8
10
2
7
4
6
9
2
SW
T
SW
T
1
R
5.8
10
f
C
8
10
f
1.4
10
f
1.5
10
1.7
10
C
4
10
C
-
=
+
+
-
+
-
+
1
RC
150 mV
S
Q
R
+
8
5
VDD
GND
R
RC
C
RC
CLK
External Frequency
Synchronization
(optional)
V
IN
TPS40210/11
UDG-08063
www.ti.com
SLVS861D – AUGUST 2008 – REVISED APRIL 2010
Setting the Oscillator Frequency
The oscillator frequency is determined by a resistor and capacitor connected to the RC pin of the TPS40210. The
capacitor is charged to a level of approximately VVDD/20 by current flowing through the resistor and is then
discharged by a transistor internal to the TPS40210. The required resistor for a given oscillator frequency is
found from either Figure 1 or Equation 5.
where
RT is the timing resistance in k
f SW is the switching frequency in kHz
CT is the timing capacitance in pF
(5)
For most applications, a capacitor in the range of 68 pF to 120 pF gives the best results. Resistor values should
be limited to between 100 k
and 1 M as well. If the resistor value falls below 100 k, decrease the capacitor
size and recalculate the resistor value for the desired frequency. As the capacitor size decreases below 47 pF,
the accuracy of Equation 5 degrades, and empirical means may be needed to fine tune the timing component
values to achieve the desired switching frequency.
Synchronizing the Oscillator
The TPS40210 and TPS40211 can be synchronized to an external clock source. Figure 20 shows the functional
diagram of the oscillator. When synchronizing the oscillator to an external clock, the RC pin must be pulled below
150 mV for 20 ns or more. The external clock frequency must be higher than the free running frequency of the
converter as well. When synchronizing the controller, if the RC pin is held low for an excessive amount of time,
erratic operation may occur. The maximum amount of time that the RC pin should be held low is 50% of a
nominal output pulse, or 10% of the period of the synchronization frequency.
Under circumstances where the duty cycle is less than 50%, a Schottky diode connected from the RC pin to an
external clock may be used to synchronize the oscillator. The cathode of the diode is connected to the RC pin.
The trip point of the oscillator is set by an internal voltage divider to be 1/20 of the input voltage. The clock signal
must have an amplitude higher than this trip point. When the clock goes low, it allows the reset current to restart
the RC ramp, synchronizing the oscillator to the external clock. This provides a simple single-component method
for clock synchronization.
Figure 20. Oscillator Functional Diagram
Copyright 2008–2010, Texas Instruments Incorporated
13
Product Folder Link(s): TPS40210-Q1 TPS40211-Q1
相關PDF資料 |
PDF描述 |
|---|---|
| TPS40304DRCT | SWITCHING CONTROLLER, 660 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS40303DRCT | SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS40304DRCR | SWITCHING CONTROLLER, 660 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS40422RHAT | DUAL SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, QCC40 |
| TPS40422RHAR | DUAL SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, QCC40 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS40210SHKK | 功能描述:電流型 PWM 控制器 Wide Inp Range Crnt Mode Boost Contrlr RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| TPS40210SKGD1 | 功能描述:電流型 PWM 控制器 Wide Inp Range Crnt Mode Boost Contrlr RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| TPS40211 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:4.5-V TO 52-V INPUT CURRENT MODE BOOST CONTROLLER |
| TPS40211DGQ | 功能描述:LED照明驅動器 Wide Input Rnge Crnt Mode Boost Cntrlr RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| TPS40211DGQ | 制造商:Texas Instruments 功能描述:DC/DC Controllers (External Switch) IC 制造商:Texas Instruments 功能描述:IC, BOOST CONTROLLER, MSOP-10 |
發布緊急采購，3分鐘左右您將得到回復。