參數資料
型號: TPS40130RHB
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: SWITCHING CONTROLLER, 1200 kHz SWITCHING FREQ-MAX, PQCC32
封裝: PLASTIC, QFN-32
文件頁數: 3/38頁
文件大?。?/td> 950K
代理商: TPS40130RHB
www.ti.com
Current Sensing and Balancing (U1, U9 and U18)
PowerGood
15
18
+
TPS40130DBT
0.616 V
0.784 V
FB
PGOOD
PGOOD window
comparator
Optional components for
hysteresis
VOUT
VPU
RA
CA
RBIAS
10 k
10 k
UDG05078
R
A + RBIAS
V
PU * VFB
1.3
0.16
V
FB
* 1
(1)
SLUS602B – JUNE 2004 – REVISED SEPTEMBER 2005
FUNCTIONAL DESCRIPTION (continued)
The controller employs peak current mode control scheme, thus naturally provides certain degree of current
balancing. With current mode, the level of current feedback should comply with certain guidelines depending on
duty factor known as “slope compensation” to avoid the sub-harmonic instability. This requirement can prohibit
achieving a higher degree of phase current balance. To avoid the controversy, a separate current loop that
forces phase currents to match is added to the proprietary control scheme. This effectively provides high degree
of current sharing independent of the controller’s small signal response and is implemented in U9, ICTLR.
High bandwidth current amplifiers, U1 and U18 can accept as an input voltage either the voltage drop across
dedicated precise current sense resistors, or inductor’s DCR voltage derived by an RC network, or thermally
compensated voltage derived from the inductor’s DCR. The wide range of current sense arrangements ease the
cost/complexity constrains and provides superior performance compared to controllers utilizing the low-side
MOSFET current sensing. The current sense amplifier inputs must not exceed 4 V. See the Inductor DCR
Current Sense section for more information on selecting component values for the R-C network.
The PGOOD pin indicates when the inputs and output are within their specified ranges of operation. Also
monitored are the EN/SYNC and SS pins. PGOOD has high impedance when indicating inputs and outputs are
within specified limits and is pulled low to indicate an out-of-limits condition. Some applications may require
hysteresis on the PGOOD signal to avoid a PGOOD signal bounce. A simple method to achieve this (and
thereby eliminate any PGOOD signal bounce) is to add a small resistor (RA) and capacitor (CA) between the FB
pin and the PGOOD pin. See Figure 3 for implementation.
Figure 3. Adding Hysteresis to the PGOOD Signal
To select RA and CA, the following criteria can be used.
VPU and the PGOOD pull-up voltage and VFB is the TPS40130 internal reference voltage. The factor 1.3 in
Equation 1 provides a margin for robustness.
11
相關PDF資料
PDF描述
TPS40140RHHTG4 0.1 A DUAL SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC36
TPS40140RHHT 0.1 A DUAL SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC36
TPS40140RHHR 0.1 A DUAL SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC36
TPS40180RGERG4 0.05 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC24
TPS40190DRCRG4 SWITCHING CONTROLLER, 360 kHz SWITCHING FREQ-MAX, PDSO10
相關代理商/技術參數
參數描述
TPS40130RHBR 功能描述:DC/DC 開關控制器 2-Ch Multiphase Buck DC/DC w/Int Drvr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS40130RHBRG4 功能描述:DC/DC 開關控制器 2-Ch Multiphase Buck DC/DC w/Int Drvr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS40130RHBT 功能描述:DC/DC 開關控制器 2-Ch Multiphase Buck DC/DC w/Int Drvr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS40130RHBTG4 功能描述:DC/DC 開關控制器 2-Ch Multiphase Buck DC/DC w/Int Drvr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS40131 制造商:TI 制造商全稱:Texas Instruments 功能描述:TWO-PHASE, SYNCHRONOUS BUCK CONTROLLER WITH INTEGRATED MOSFET DRIVERS