參數資料
型號: TPS40100RGER
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: 2 A SWITCHING CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PQCC24
封裝: GREEN, PLASTIC, QFN-24
文件頁數: 39/39頁
文件大?。?/td> 762K
代理商: TPS40100RGER
www.ti.com
f Switching Frequency kHz
R
T
iming
Resistance
k
100
300
100
150
200
250
350
300
350
200
450
550
400
250
500
150
fSW Switching Frequency kHz
R
T
iming
Resistance
k
250
100
50
350
300
400
500
450
600
550
125
75
225
175
200
150
Selecting an Inductor Value
L +
VIN * VOUT
VOUT
VIN fSW DI
(H)
(2)
Selecting the Output Capacitance
TPS40100
SLUS601–MAY 2005
APPLICATION INFORMATION (continued)
TIMING RESISTOR
vs
SWITCHING FREQUENCY
(250 kHz to 600 kHz)
(100 kHz to 350 kHz)
Figure 1.
Figure 2.
The inductor value determines the ripple current in the output capacitors and has an effect on the achievable
transient response. A large inductance decreases ripple current and output voltage ripple, but is physically larger
than a smaller inductance at the same current rating and limits output current slew rate more that a smaller
inductance would. A lower inductance increases ripple current and output voltage ripple, but is physically smaller
than a larger inductance at the same current rating. For most applications, a good compromise is selecting an
inductance value that gives a ripple current between 20% and 30% of the full load current of the converter. The
required inductance for a given ripple current can be found from:
where
L is the inductance value (H)
VIN is the input voltage to the converter (V)
VOUT is the output voltage of the converter (V)
fSW is the switching frequency chosen for the converter (Hz)
I is the peak-to-peak ripple current in the inductor (A)
The required value for the output capacitance depends on the output ripple voltage requirements and the ripple
current in the inductor, as well as any load transient specifications that may exist.
The output voltage ripple depends directly on the ripple current and is affected by two parameters from the
output capacitor: total capacitance and the capacitors equivalent series resistance (ESR). The output ripple
voltage (worst case) can be found from:
9
相關PDF資料
PDF描述
TPS54610QPWPRG4Q1 12 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28
TPS62240DRVRG4 2.25 MHz 300 mA Step Down Converter in 2x2SON/TSOT23 Package
TPS62240DRVTG4 2.25 MHz 300 mA Step Down Converter in 2x2SON/TSOT23 Package
TPS62240DRVT 2.25 MHz 300 mA Step Down Converter in 2x2SON/TSOT23 Package
TPS62242DRV 2.25 MHz 300 mA Step Down Converter in 2x2SON/TSOT23 Package
相關代理商/技術參數
參數描述
TPS40100RGERG4 功能描述:DC/DC 開關控制器 Wide In Range Sync Buck for Sequencing RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS40100RGET 功能描述:DC/DC 開關控制器 Wide In Range Sync Buck for Sequencing RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS40100RGETG4 功能描述:DC/DC 開關控制器 Wide In Range Sync Buck for Sequencing RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS40101 制造商:TI 制造商全稱:Texas Instruments 功能描述:MIDRANGE INPUT SYNCHRONOUS BUCK CONTROLLER WITH ADVANCED SEQUENCING AND OUTPUT MARGINING
TPS40101RGER 功能描述:DC/DC 開關控制器 Mid Range Input Synch Buck Cntrlr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK