- 您現在的位置：買賣IC網 > PDF目錄385946 > TPS3306 (Texas Instruments, Inc.) Dual Processor Supervisry Circuits With Power-Fall(帶電源故障比較器的雙監控電路) PDF資料下載
參數資料
| 型號： | TPS3306 |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | Dual Processor Supervisry Circuits With Power-Fall(帶電源故障比較器的雙監控電路) |
| 中文描述： | 雙處理器Supervisry電路的電源爾（帶電源故障比較器的雙監控電路） |
| 文件頁數： | 5/12頁 |
| 文件大?。?/td> | 186K |
| 代理商： | TPS3306 |
TPS3306-15, TPS3306-18, TPS3306-20, TPS3306-25, TPS3306-33
DUAL PROCESSOR SUPERVISORY CIRCUITS WITH POWER-FAIL
SLVS290 – APRIL 2000
5
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
detailed description (continued)
saving current while using the watchdog
The watchdog input is internally driven low during the first 7/8 of the watchdog time-out period, then momentarily
pulses high, resetting the watchdog counter. For minimum watchdog input current (minimum overall power consump-
tion), leave WDI low for the majority of the watchdog time-out period, pulsing it low-high-low once within 7/8 of the
watchdog time-out period to reset the watchdog timer. If instead WDI is externally driven high for the majority of the
time-out period, a current of 5 V/40 k
≈
125
μ
A can flow into WDI.
td
td
t(tout)
VDD
VIT
WDI
RESET
t
t
t
Figure 1. Watchdog Timing
power-fail comparator (PFI & PFO)
An additional comparator is provided to monitor voltages other than the nominal supply voltage. The power-fail-input
(PFI) will be compared with an internal voltage reference of 1.25 V. If the input voltage falls below the power-fail thresh-
old (V
PFI
) of typ. 1.25 V, the power-fail output (PFO) goes low. If it goes above 1.25 V plus about 10 mV hysteresis, the
output returns to high. By connecting 2 external resistors, it is possible to supervise any voltages above 1.25 V. The
sum of both resistors should be about 1 M
, to minimize power consumption and also to assure that the current in the
PFI pin can be neglected compared with the current through the resistor network. The tolerance of the external resis-
tors should be not more than 1% to ensure minimal variation of sensed voltage. If the power-fail comparator is unused,
connect PFI to ground and leave PFO
unconnected.
PFI
PFO
VCC
GND
TPS3306
V(SENSE)
R1
1%
R2
1%
VPFI,trip = 1.25 V
×
R1 + R2
R2
相關PDF資料 |
PDF描述 |
|---|---|
| TPS3307(中文) | Triple Processor Supervisors(三處理器監控器電路) |
| TPS3307 | Triple Processor Supervisors(三處理器監控器電路) |
| TPS3510(中文) | PC POWER SUPPLY SUPERVISORS(PC電源監控) |
| TPS3600D20(中文) | Battery-Backup Supervisory For Low Power Processors(電源電壓監視2.0V,用于低功率處理器,帶后備電池開關的監控器) |
| tps3606(中文) | Battery-Backup Supervisory For Low Power Processors(電源電壓監視3.3V,用于低功率處理器,帶后備電池開關的監控器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS3306-15 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:DUAL PROCESSOR SUPERVISORY CIRCUITS WITH POWER-FAIL |
| TPS3306-15D | 功能描述:監控電路 Dual-Processor with Power-Fail RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| TPS3306-15D | 制造商:Texas Instruments 功能描述:IC's |
| TPS3306-15DG4 | 功能描述:監控電路 Dual-Processor with Power-Fail RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| TPS3306-15DGK | 功能描述:監控電路 Dual-Processor with Power-Fail RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。