- 您現在的位置：買賣IC網 > PDF目錄220077 > TPS2552DBV-1 (TEXAS INSTRUMENTS INC) 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO6 PDF資料下載
參數資料
| 型號： | TPS2552DBV-1 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 電源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO6 |
| 封裝： | PLASTIC, SOT-23, 6 PIN |
| 文件頁數： | 4/32頁 |
| 文件大小： | 2005K |
| 代理商： | TPS2552DBV-1 |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
FAULT RESPONSE
UNDERVOLTAGE LOCKOUT (UVLO)
ENABLE (EN OR EN)
THERMAL SENSE
SLVS841C – NOVEMBER 2008 – REVISED SEPTEMBER 2009...................................................................................................................................... www.ti.com
The FAULT open-drain output is asserted (active low) during an overcurrent, overtemperature or reverse-voltage
condition. The TPS2552/53 asserts the FAULT signal until the fault condition is removed and the device resumes
normal operation. The TPS2552-1/53-1 asserts the FAULT signal during a fault condition and remains asserted
while the part is latched-off. The FAULT signal is de-asserted once device power is cycled or the enable is
toggled and the device resumes normal operation. The TPS2552/53 and TPS2552-1/53-1 are designed to
eliminate false FAULT reporting by using an internal delay "deglitch" circuit for overcurrent (7.5-ms typ) and
reverse-voltage (4-ms typ) conditions without the need for external circuitry. This ensures that FAULT is not
accidentally asserted due to normal operation such as starting into a heavy capacitive load. The deglitch circuitry
delays entering and leaving fault conditions. Overtemperature conditions are not deglitched and assert the
FAULT signal immediately.
The undervoltage lockout (UVLO) circuit disables the power switch until the input voltage reaches the UVLO
turn-on threshold. Built-in hysteresis prevents unwanted on/off cycling due to input voltage drop from large
current surges.
The logic enable controls the power switch, bias for the charge pump, driver, and other circuits to reduce the
supply current. The supply current is reduced to less than 1-
A when a logic high is present on EN or when a
logic low is present on EN. A logic low input on EN or a logic high input on EN enables the driver, control circuits,
and power switch. The enable input is compatible with both TTL and CMOS logic levels.
The TPS2552/53 and TPS2552-1/53-1 have self-protection features using two independent thermal sensing
circuits that monitor the operating temperature of the power switch and disable operation if the temperature
exceeds recommended operating conditions. The TPS2552/53 device operates in constant-current mode during
an overcurrent conditions, which increases the voltage drop across power-switch. The power dissipation in the
package is proportional to the voltage drop across the power switch, which increases the junction temperature
during an overcurrent condition. The first thermal sensor turns off the power switch when the die temperature
exceeds 135°C (min) and the part is in current limit. Hysteresis is built into the thermal sensor, and the switch
turns on after the device has cooled approximately 10 °C.
The TPS2552/53 and TPS2552-1/53-1 also have a second ambient thermal sensor. The ambient thermal sensor
turns off the power-switch when the die temperature exceeds 155°C (min) regardless of whether the power
switch is in current limit and will turn on the power switch after the device has cooled approximately 10 °C. Both
the TPS2552/53 and TPS2552-1/53-1 families continue to cycle off and on until the fault is removed.
The open-drain fault reporting output FAULT is asserted (active low) immediately during an overtemperature
shutdown condition.
12
Copyright 2008–2009, Texas Instruments Incorporated
相關PDF資料 |
PDF描述 |
|---|---|
| TPS54614PWPRG4 | 12 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO28 |
| TPS3836H30DBVTG4 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO5 |
| TPS40050PWPRG4 | 0.2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16 |
| TPS60230RGTRG4 | 0.2 A SWITCHED CAPACITOR REGULATOR, 1250 kHz SWITCHING FREQ-MAX, PQCC16 |
| TC1303B-1D2EMFTR | 0.5 A SWITCHING REGULATOR, 2400 kHz SWITCHING FREQ-MAX, PDSO10 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS2552DBV1EVM-364 | 功能描述:交換機 IC 開發工具 TPS2552DBV1EVM-364 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:USB Power Switches 工具用于評估:MAX4984E 工作電源電壓:2.8 V to 5.5 V |
| TPS2552DBVEVM-364 | 功能描述:交換機 IC 開發工具 TPS2552DBVEVM-364 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:USB Power Switches 工具用于評估:MAX4984E 工作電源電壓:2.8 V to 5.5 V |
| TPS2552DBVR | 功能描述:電源開關 IC - USB Adj Crnt-Ltd Pwr- Dist Sw RoHS:否 制造商:Micrel 電源電壓-最小:2.7 V 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-8 封裝:Tube |
| TPS2552DBVR-1 | 功能描述:電源開關 IC - USB Adj Crnt-Ltd Pwr- Dist Sw RoHS:否 制造商:Micrel 電源電壓-最小:2.7 V 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-8 封裝:Tube |
| TPS2552DBVT | 功能描述:電源開關 IC - USB Adj Crnt-Ltd Pwr- Dist Sw RoHS:否 制造商:Micrel 電源電壓-最小:2.7 V 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。