- 您現在的位置：買賣IC網 > PDF目錄10423 > TPA0233DGQG4 (Texas Instruments)IC AMP AUDIO PWR 2W MONO 10MSOP PDF資料下載
參數資料
| 型號： | TPA0233DGQG4 |
| 廠商： | Texas Instruments |
| 文件頁數： | 5/26頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP AUDIO PWR 2W MONO 10MSOP |
| 標準包裝： | 80 |
| 類型： | AB 類 |
| 輸出類型： | 1-通道（單聲道），帶立體聲耳機 |
| 在某負載時最大輸出功率 x 通道數量： | 2W x 1 @ 4 歐姆; 92mW x 2 @ 32 歐姆 |
| 電源電壓： | 2.5 V ~ 5.5 V |
| 特點： | 消除爆音；關閉 |
| 安裝類型： | 表面貼裝 |
| 供應商設備封裝： | 10-MSOP-PowerPad |
| 封裝/外殼： | 10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 |
| 包裝： | 管件 |
| 配用： | 296-10813-ND - EVAL MOD AUDIO AMP FOR TPA0233 |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
TPA0233
2W MONO AUDIO POWER AMPLIFIER
WITH HEADPHONE DRIVE
SLOS278D JANUARY 2000 REVISED NOVEMBER 2002
13
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
power supply decoupling, C(S)
The TPA0233 is a high-performance CMOS audio amplifier that requires adequate power supply decoupling
to ensure the output total harmonic distortion (THD) is as low as possible. Power supply decoupling also
prevents oscillations for long lead lengths between the amplifier and the speaker. The optimum decoupling is
achieved by using two capacitors of different types that target different types of noise on the power supply leads.
For higher frequency transients, spikes, or digital hash on the line, a good low equivalent-series-resistance
(ESR) ceramic capacitor, typically 0.1
F placed as close as possible to the device VDD lead, works best. For
filtering lower-frequency noise signals, a larger aluminum electrolytic capacitor of 10
F or greater placed near
the audio power amplifier is recommended.
midrail bypass capacitor, C(BYP)
The midrail bypass capacitor (C(BYP)), is the most critical capacitor and serves several important functions.
During start-up or recovery from shutdown mode, C(BYP) determines the rate at which the amplifier starts up.
The second function is to reduce noise produced by the power supply caused by coupling into the output drive
signal. This noise is from the midrail generation circuit internal to the amplifier, which appears as degraded
PSRR and THD+N.
Bypass capacitor (C(BYP)), values of 0.47-F to 1-F ceramic or tantalum low-ESR capacitors are
recommended for the best THD and noise performance.
output coupling capacitor, C(C)
In the typical single-supply stereo configuration, an output coupling capacitor (C(C)) is required to block the dc
bias at the output of the amplifier, thus preventing dc currents in the load. As with the input coupling capacitor,
the output coupling capacitor and impedance of the load form a high-pass filter governed by equation 6.
(6)
f
c(high) +
1
2
pR
L
C
(C)
3 dB
fc
The main disadvantage, from a performance standpoint, is the load impedances are typically small, which drives
the low-frequency corner higher, degrading the bass response. Large values of C(C) are required to pass low
frequencies into the load. Consider the example where a C(C) of 330 F is chosen and loads vary from 3 ,
4
, 8 , 32 , 10 k, to 47 k. Table 1 summarizes the frequency response characteristics of each
configuration.
Table 1. Common Load Impedances vs Low Frequency Output Characteristics in Stereo (SE) Mode
RL
C(C)
Lowest Frequency
3
330
F
161 Hz
4
330
F
120 Hz
8
330
F
60 Hz
32
330
F
15 Hz
10,000
330
F
0.05 Hz
47,000
330
F
0.01 Hz
相關PDF資料 |
PDF描述 |
|---|---|
| VI-JN2-MX | CONVERTER MOD DC/DC 15V 75W |
| ADS7864Y/250G4 | IC 12BIT 500KHZ 6CH ADC 48-TQFP |
| VI-JN1-MX | CONVERTER MOD DC/DC 12V 75W |
| VI-2NX-IU | CONVERTER MOD DC/DC 5.2V 200W |
| GRM43RR72A124KA01L | CAP CER 0.12UF 100V 10% X7R 1812 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA0233DGQR | 功能描述:音頻放大器 Mono Class-AB w/Ster Hdphn Drv Summed Inp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA0233DGQRG4 | 功能描述:音頻放大器 Mono Class-AB w/Ster Hdphn Drv Summed Inp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA0233EVM | 功能描述:音頻 IC 開發工具 TPA0233 Eval Mod RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| TPA0233G | 制造商:ON Semiconductor 功能描述:THY T0220 SPECIAL SCR |
| TPA0234G | 功能描述:SCR THY C77 SPECIAL SCR RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。