參數資料
型號: TPA0222PWPG4
廠商: TEXAS INSTRUMENTS INC
元件分類: 音頻控制
英文描述: 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PDSO24
封裝: GREEN, PLASTIC, HTSSOP-24
文件頁數: 22/37頁
文件大小: 969K
代理商: TPA0222PWPG4
www.ti.com
INPUT MUX OPERATION
ROUT+
21
R
MUX
RHPIN
RLINEIN
+
23
20
8
RIN
ROUT 16
+
SE/BTL
15
Volume
Control
Volume
Control
2
HP/LINE
CIRHP
0.47
F
Right
Headphone
Input Signal
CIRLINE
0.47
F
Right Line
Input Signal
CRIN
0.47
F
PC-BEEP OPERATION
TPA0222
SLOS285B – NOVEMBER 1999 – REVISED NOVEMBER 2004
Figure 48. TPA0312 Example Input MUX Circuit
The TPA0222 offers the capability for the designer to use separate headphone inputs (RHPIN, LHPIN) and line
inputs (RLINEIN, LLINEIN). The inputs can be different if the input signal is single-ended. If using a differential
input signal, the inputs must be the same because the inputs share a common RIN, LIN. Although the typical
application in Figure 48 shows the input mux control signal HP/LINE tied to SE/BTL, that configuration is not
required. The input mux can be used to select between two inputs that are used in both SE and BTL modes.
If using the TPA0222 with a single-ended input, the RIN and LIN terminals must be tied through a capacitor to
ground, as shown in Figure 42. RIN and LIN must not be tied to bypass or an offset occurs on the output causing
the device to pop when turning on and off.
Input coupling capacitors can be eliminated when using differential inputs, but are used to obtain maximum
output power. If the input capacitors are eliminated, the dc offset must match the voltage on BYPASS or the
output power is limited.
The PC-BEEP input allows a system beep to be sent directly from a computer through the amplifier to the
speakers with few external components. The input is activated automatically. When the PC-BEEP input is active,
both of the LINEIN and HPIN inputs are deselected and both the left and right channels are driven in BTL mode
with the signal from PC-BEEP. The gain from the PC-BEEP input to the speakers is fixed at 0.3 V/V and is
independent of the volume setting. When the PC-BEEP input is deselected, the amplifier returns to the previous
operating mode and volume setting. Furthermore, if the amplifier is in shutdown mode, activating PC-BEEP takes
the device out of shutdown and outputs the PC-BEEP signal, then returns the amplifier to shutdown mode.
The preferred input signal is a square wave or pulse train with an amplitude of 1.5 Vpp or greater. To be
accurately detected, the signal must have a minimum of 1.5 Vpp amplitude, rise and fall times of less than 0.1 s
and a minimum of 8 rising edges. When the signal is no longer detected, the amplifier returns to its previous
operating mode and volume setting.
29
相關PDF資料
PDF描述
TPA0222PWPR 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PDSO24
TPA0222PWP 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PDSO24
TPA0222PWPRG4 2 CHANNEL(S), VOLUME CONTROL CIRCUIT, PDSO24
TPA0223DGQR 2 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO10
TPA0223DGQRG4 2 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO10
相關代理商/技術參數
參數描述
TPA0222PWPR 功能描述:音頻放大器 St 2W Aud Pwr Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA0222PWPRG4 功能描述:音頻放大器 St 2W Aud Pwr Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA0223 制造商:TI 制造商全稱:Texas Instruments 功能描述:2-W MONO AUDIO POWER AMPLIFIER WITH HEADPHONE DRIVE
TPA0223DGQ 功能描述:音頻放大器 2W Mono Aud Pwr Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel
TPA0223DGQG4 功能描述:音頻放大器 2W Mono Aud Pwr Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel