- 您現在的位置：買賣IC網 > PDF目錄69498 > TNY378GN (POWER INTEGRATIONS INC) 0.779 A SWITCHING REGULATOR, 280 kHz SWITCHING FREQ-MAX, PDSO7 PDF資料下載
參數資料
| 型號： | TNY378GN |
| 廠商： | POWER INTEGRATIONS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.779 A SWITCHING REGULATOR, 280 kHz SWITCHING FREQ-MAX, PDSO7 |
| 封裝： | LEAD FREE, PLASTIC, SMD-8/7 |
| 文件頁數： | 22/24頁 |
| 文件大小： | 998K |
| 代理商： | TNY378GN |
Rev. B 11/07
7
TNY375-380
www.powerint.com
reduced, and the clock frequency is reduced to half that at the
highest current limit level (Figure 8). At very light loads, the
current limit will be reduced even further (Figure 9). Only a small
percentage of cycles will occur to satisfy the power consumption
of the power supply. The response time of the ON/OFF control
scheme is very fast compared to PWM control. This provides
tight regulation and excellent transient response.
Power Up/Down
The TinySwitch-PK requires only a 0.1 μF capacitor on the
BYPASS/MULTI-FUNCTION pin to operate with standard
current limit. Because of its small size, the time to charge this
capacitor is kept to an absolute minimum, typically 0.6 ms. The
time to charge will vary in proportion to the BYPASS/MULTI-
FUNCTION pin capacitor value when selecting different current
limits. Due to the high bandwidth of the ON/OFF feedback,
there is no overshoot at the power supply output. When an
external resistor (4 MΩ) is connected from the power supply
positive DC input to the EN/UV pin, the power MOSFET
switching will be delayed during power-up until the DC line
voltage exceeds the threshold (100 V). Figures 10 and 11 show
the power-up timing waveform in applications with and without
an external resistor (4 MΩ) connected to the EN/UV pin.
During power-down, when an external resistor is used, the
power MOSFET will switch for 32 ms after the output loses
regulation. The power MOSFET will then remain off without any
glitches since the undervoltage function prohibits restart when
the line voltage is low.
Figure 12 illustrates a typical power-down timing waveform.
Figure 13 illustrates a very slow power-down timing waveform,
as in standby applications. The external resistor (4 MΩ) is
connected to the EN/UV pin in this case to prevent unwanted
restarts.
With the TNY375 and TNY376, no bias winding is needed to
provide power to the chip because it draws the power directly
from the DRAIN pin (see Functional Description above). This
eliminates the cost of a bias winding and associated
components. For the TNY377-380 or for applications that
require very low no-load power consumption (50 mW), a resistor
from a bias winding to the BYPASS/MULTI-FUNCTION pin can
provide the power to the chip. The minimum recommended
current supplied is I
S2 + IDIS.
The BYPASS/MULTI-FUNCTION
pin in this case will be clamped at 6.4 V. This method will
eliminate the power draw from the DRAIN pin, thereby reducing
the no-load power consumption and improving full-load
efciency.
Current Limit Operation
Each switching cycle is terminated when the DRAIN current
reaches the current limit of the device. Current limit operation
provides good line ripple rejection and relatively constant power
delivery independent of input voltage.
BYPASS/MULTI-FUNCTION Pin Capacitor
The BYPASS/MULTI-FUNCTION pin can use a ceramic
capacitor as small as 0.1 μF for decoupling the internal power
supply of the device. A larger capacitor size can be used to
adjust the current limit. A 1 μF BP/M pin capacitor will select a
lower current limit equal to the standard current limit of the next
smaller device, and a 10 μF BP/M pin capacitor will select a
higher current limit equal to the standard current limit of the next
larger device. The TNY375 and TNY376 MOSFETs do not have
the capability to match the current limit of the next larger
devices in the family. The current limit is therefore increased to
the maximum capability of their respective MOSFETs. The
higher current limit level of the TNY380 is set to 1105 mA typical.
The smaller current limit of the TNY375 is set to 325 mA.
相關PDF資料 |
PDF描述 |
|---|---|
| TNY379P | 2.9 A SWITCHING REGULATOR, 280 kHz SWITCHING FREQ-MAX, PDIP7 |
| TNY377P | 1.4 A SWITCHING REGULATOR, 280 kHz SWITCHING FREQ-MAX, PDIP7 |
| TNY376P | 0.8 A SWITCHING REGULATOR, 280 kHz SWITCHING FREQ-MAX, PDIP7 |
| TNY375P | 0.6 A SWITCHING REGULATOR, 280 kHz SWITCHING FREQ-MAX, PDIP7 |
| TOP244P-TL | 2.16 A SWITCHING REGULATOR, 140 kHz SWITCHING FREQ-MAX, PDIP7 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TNY378GN-TL | 功能描述:交流/直流開關轉換器 27 W (85-265 VAC) 34 W (230 VAC) RoHS:否 制造商:STMicroelectronics 輸出電壓:800 V 輸入/電源電壓（最大值）:23.5 V 輸入/電源電壓（最小值）:11.5 V 開關頻率:115 kHz 電源電流:1.6 mA 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:SSO-10 封裝:Reel |
| TNY378P | 制造商:POWERINT 制造商全稱:Power Integrations, Inc. 功能描述:Energy-Efficient, Off-Line Switcher With Enhanced Peak Power Performance |
| TNY378PN | 功能描述:接口 - 專用 27W (85-265 VAC) 34W (230 VAC) RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
| TNY379G | 制造商:POWERINT 制造商全稱:Power Integrations, Inc. 功能描述:Energy-Efficient, Off-Line Switcher With Enhanced Peak Power Performance |
| TNY379GN | 功能描述:交流/直流開關轉換器 31 W (85-265 VAC) 39 W (230 VAC) RoHS:否 制造商:STMicroelectronics 輸出電壓:800 V 輸入/電源電壓（最大值）:23.5 V 輸入/電源電壓（最小值）:11.5 V 開關頻率:115 kHz 電源電流:1.6 mA 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:SSO-10 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。