- 您現在的位置：買賣IC網 > PDF目錄69498 > TNY266PG (POWER INTEGRATIONS INC) 0.56 A SWITCHING REGULATOR, 140 kHz SWITCHING FREQ-MAX, PDIP7 PDF資料下載
參數資料
| 型號： | TNY266PG |
| 廠商： | POWER INTEGRATIONS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.56 A SWITCHING REGULATOR, 140 kHz SWITCHING FREQ-MAX, PDIP7 |
| 封裝： | 0.300 INCH, LEAD FREE, PLASTIC, MS-001-AB, DIP-8 |
| 文件頁數： | 20/22頁 |
| 文件大小： | 760K |
| 代理商： | TNY266PG |
Rev. H 02/09
7
TNY263-268
www.powerint.com
Figure 14. 2.5 W Constant Voltage, Constant Current Battery Charger with Universal Input (85-265 VAC).
PI-2706-021809
+ 5 V
500 mA
RTN
D1
1N4005
C1
3.3
μF
400 V
Fusible
RF1
8.2
Ω
C3
0.1
μF
C7
10
μF
10 V
85-265
VAC
L1
2.2 mH
D2
1N4005
D3
1N4005
D4
1N4005
R2
200 k
Ω
U2
LTV817
D5
1N5819
Shield
L2
3.3
μH
C5
330
μF
16 V
C2
3.3
μF
400 V
C6
100
μF
35 V
R7
100
Ω
R4
1.2
Ω
1/2 W
Q1
2N3904
R8
270
Ω
VR1
BZX79-
B3V9
3.9 V
U1
TNY264
C3
2.2 nF
D6
1N4937
R6
1
Ω
1/2 W
T1
R1
1.2 k
Ω
1
8
4
5
R3
22
Ω
R9
47
Ω
C8 680 pF
Y1 Safety
TinySwitch-II
D
S
BP
EN/UV
reducing the no-load power consumption and improving full-
load efciency.
Current Limit Operation
Each switching cycle is terminated when the DRAIN current
reaches the current limit of the TinySwitch-II. Current limit
operation provides good line ripple rejection and relatively
constant power delivery independent of input voltage.
BYPASS Pin Capacitor
The BYPASS pin uses a small 0.1
μF ceramic capacitor for
decoupling the internal power supply of the TinySwitch-II.
Application Examples
The TinySwitch-II is ideal for low cost, high efciency power
supplies in a wide range of applications such as cellular phone
chargers, PC standby, TV standby, AC adapters, motor
control, appliance control and ISDN or a DSL network
termination. The 132 kHz operation allows the use of a low
cost EE13 or EF12.6 core transformer while still providing good
efciency. The frequency jitter in TinySwitch-II makes it
possible to use a single inductor (or two small resistors for
under 3 W applications if lower efciency is acceptable) in
conjunction with two input capacitors for input EMI ltering.
The auto-restart function removes the need to oversize the
output diode for short circuit conditions allowing the design to
be optimized for low cost and maximum efciency. In charger
applications, it eliminates the need for a second optocoupler
and Zener diode for open loop fault protection. Auto-restart
also saves the cost of adding a fuse or increasing the power
rating of the current sense resistors to survive reverse battery
conditions. For applications requiring undervoltage lock out
(UVLO), such as PC standby, the TinySwitch-II eliminates
several components and saves cost. TinySwitch-II is well
suited for applications that require constant voltage and
constant current output. As TinySwitch-II is always powered
from the input high voltage, it therefore does not rely on bias
winding voltage. Consequently this greatly simplies designing
chargers that must work down to zero volts on the output.
2.5 W CV/CC Cell-Phone Charger
As an example, Figure 14 shows a TNY264 based 5 V,
0.5 A, cellular phone charger operating over a universal input
range (85 VAC to 265 VAC). The inductor (L1) forms a π-lter
in conjunction with C1 and C2. The resistor R1 damps
resonances in the inductor L1. Frequency jittering operation of
TinySwitch-II allows the use of a simple π-lter described
above in combination with a single low value Y1-capacitor (C8)
to meet worldwide conducted EMI standards. The addition of
a shield winding in the transformer allows conducted EMI to be
met even with the output capacitively earthed (which is the
worst case condition for EMI). The diode D6, capacitor C3
and resistor R2 comprise the clamp circuit, limiting the leakage
inductance turn-off voltage spike on the TinySwitch-II DRAIN
pin to a safe value. The output voltage is determined by the
sum of the optocoupler U2 LED forward drop (~1 V), and Zener
diode VR1 voltage. Resistor R8 maintains a bias current
through the Zener diode to ensure it is operated close to the
Zener test current.
相關PDF資料 |
PDF描述 |
|---|---|
| TNY265PG | 0.44 A SWITCHING REGULATOR, 140 kHz SWITCHING FREQ-MAX, PDIP7 |
| TNY277PG | 0.481 A SWITCHING REGULATOR, PDIP7 |
| TNY279PG | 0.695 A SWITCHING REGULATOR, PDIP7 |
| TNY376GN | 0.496 A SWITCHING REGULATOR, 280 kHz SWITCHING FREQ-MAX, PDSO7 |
| TNY378GN-TL | 0.779 A SWITCHING REGULATOR, 280 kHz SWITCHING FREQ-MAX, PDSO7 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TNY266PN | 功能描述:交流/直流開關轉換器 9.5W 85-265 VAC 15W/230 VAC RoHS:否 制造商:STMicroelectronics 輸出電壓:800 V 輸入/電源電壓（最大值）:23.5 V 輸入/電源電壓（最小值）:11.5 V 開關頻率:115 kHz 電源電流:1.6 mA 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:SSO-10 封裝:Reel |
| TNY266PN-TL | 制造商:POWERINT 制造商全稱:Power Integrations, Inc. 功能描述:Enhanced, Energy Efficient, Low Power Off-line Switcher |
| TNY266PTL | 制造商:POWERINT 制造商全稱:Power Integrations, Inc. 功能描述:Enhanced, Energy Efficient, Low Power Off-line Switcher |
| TNY267 | 制造商:POWERINT 制造商全稱:Power Integrations, Inc. 功能描述:Generic PCB for DVD Player using TinySwitch-II |
| TNY267G | 功能描述:IC OFFLINE SWIT OTP OCP HV 8SMD RoHS:否 類別:集成電路 (IC) >> PMIC - AC-DC 轉換器，離線開關 系列:TinySwitch®-II 標準包裝:1 系列:FPS™ 輸出隔離:隔離 頻率范圍:61kHz ~ 73kHz 輸入電壓:8 V ~ 26 V 輸出電壓:650V 功率（瓦特）:12W 工作溫度:-40°C ~ 115°C 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-MDIP 包裝:Digi-Reel® 其它名稱:FSL206MRBNFSDKR |
發布緊急采購，3分鐘左右您將得到回復。