- 您現在的位置：買賣IC網 > PDF目錄372457 > TN22 (意法半導體) STARTLIGHT(Application Specific Discretes A.S.D.⑩) PDF資料下載
參數資料
| 型號： | TN22 |
| 廠商： | 意法半導體 |
| 英文描述： | STARTLIGHT(Application Specific Discretes A.S.D.⑩) |
| 中文描述： | STARTLIGHT（專用分立建筑⑩） |
| 文件頁數： | 3/7頁 |
| 文件大?。?/td> | 158K |
| 代理商： | TN22 |
TN22
3/7
This thyristor has been designed for use as a fluo-
rescent tube starter switch.
An electronic starter circuit provides :
I
A pre-heating period during which a heating
current is applied to the cathode heaters.
I
One or several high voltage striking pulses
across the lamp.
TN22
R
S
STARTER CIRCUIT
CONTROLLER
(TIMER)
INDUCTANCE
BALLAST
FLUORESCENT
TUBE
AC
VOLTAGE
BASIC APPLICATION DIAGRAM
PRINCIPLE OF OPERATION
1/ Pre-heating
At rest the switch S is opened and when the mains
voltage is applied across the circuit a full wave rec-
tified current flows through the resistor R and the
TN22 gate : at every half-cycle when this current
reaches the gate triggering current (I
GT
) the thyris-
tor turns on.
When the device is turned on the heating current,
limited by the ballast choke, flows through the tube
heaters.
The pre-heating time is typically 2 or 3 seconds.
2/ Pulsing
At the end of the pre-heating phase the switch S is
turned on. At this moment :
If the current through the devices is higher than the
holding current (I
H
) the thyristor remains on until
the current falls below I
H
. Then the thyristor turns
off.
If the current is equal or lower than the holding cur-
rent the thyristor turns off instantaneously.
When the thyristor turns off the current flowing
through the ballast choke generates a high voltage
pulse. This overvoltage is clamped by the thyristor
avalanche characteristic (V
BR
).
Ifthelampisnotstruckafterthefirstpulse,thesys-
tem starts a new ignition sequence again.
3/ Steady state
When the lamp is on the running voltage is about
150V and the starter switch is in the off-state.
IMPLEMENTATION
The resistor R must be chosen to ensure a proper
triggering in the worst case (minimum operating
temperature) according to the specified gate trig-
gering current and the peak line voltage.
Switch S : This function can be realized with a gate
sensitive SCR type : P0130AA 1EA3
This component is a low voltage device (< 50V)
and the maximum current sunk through this switch
can reach the level of the thyristor holding current.
The pre-heating period can be determined by the
time
constant
of
a
capacitor-resistor
charged by the voltage drop of diodes used in se-
ries in the thyristor cathode.
circuit
相關PDF資料 |
PDF描述 |
|---|---|
| TN22-1200 | STARTLIGHT(Application Specific Discretes A.S.D.⑩) |
| TN22-1500 | STARTLIGHT(Application Specific Discretes A.S.D.⑩) |
| TN22-1500B | STARTLIGHT(Application Specific Discretes A.S.D.⑩) |
| TN22-1500B-TR | STARTLIGHT(Application Specific Discretes A.S.D.⑩) |
| TN22-1500H | STARTLIGHT(Application Specific Discretes A.S.D.⑩) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TN22.29 | 制造商:TEKO 功能描述:Bulk 制造商:TEKO 功能描述:ENCLOSURE TEKNET BLACK/GREY |
| TN22.29-AL | 制造商:OKW ENCLOSURES INC 功能描述:ENCLOSURE, ABS, BLACK/GRAY, 6.102 X 3.78 X 1.11 |
| TN22.30-AL | 制造商:OKW ENCLOSURES INC 功能描述:ENCLOSURE, ABS, WHITE/GRAY, 6.102 X 3.78 X 1.11 |
| TN22_05 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:STARTLIGHT |
| TN220K1HBK-0813P | 功能描述:鋁質電解電容器 - 帶引線 50V 22uF 10% 8x13mm RoHS:否 制造商:Kemet 引線類型: 電容:220 uF 容差:20 % 電壓額定值:25 V 工作溫度范圍: 端接類型:Radial 外殼直徑:8 mm 外殼長度:11 mm 引線間隔:5 mm 產品:General Purpose Electrolytic Capacitors 封裝:Bulk |
發布緊急采購，3分鐘左右您將得到回復。