參數資料
型號: TMS320GB
廠商: Texas Instruments, Inc.
英文描述: Adjustable 1.24-16V ±0.5% Tolerance, 0.05-20mA Shunt Regulator; Package: TO-92 (TO-226) 5.33mm Body Height; No of Pins: 3; Container: Tape and Reel; Qty per Container: 2000
中文描述: 第二代數字信號處理器
文件頁數: 43/123頁
文件大?。?/td> 1205K
代理商: TMS320GB
www.ti.com
TMS320F2808, TMS320F2806
TMS320F2801, UCD9501
Digital Signal Processors
SPRS230F–OCTOBER 2003–REVISED SEPTEMBER 2005
Table 3-14. PLLCR Register Bit Definitions
SYSCLKOUT
(CLKIN)
(2)
OSCCLK/2
OSCCLK
(OSCCLK*1)/2
(OSCCLK*2)/2
(OSCCLK*3)/2
(OSCCLK*4)/2
(OSCCLK*5)/2
(OSCCLK*6)/2
(OSCCLK*7)/2
(OSCCLK*8)/2
(OSCCLK*9)/2
(OSCCLK*10)/2
reserved
PLLCR[DIV]
(1)
PLLSTS[CLKINDIV]
0000 (PLL bypass)
0000 (PLL bypass)
0001
0010
0011
0100
0101
0110
0111
1000
1001
1010
1011-1111
0
1
0
0
0
0
0
0
0
0
0
0
0
(1)
(2)
This register is EALLOW protected.
CLKIN is the input clock to the CPU. SYSCLKOUT is the output
clock from the CPU. The frequency of SYSCLKOUT is the same as
CLKIN.
CAUTION
PLLSTS[CLKINDIV] can be set to 1 only if PLLCR is 0x0000. PLLCR should not be
changed once PLLSTS[CLKINDIV] is set.
The PLL-based clock module provides two modes of operation:
Crystal-operation - This mode allows the use of an external crystal/resonator to provide the time base
to the device.
External clock source operation - This mode allows the internal oscillator to be bypassed. The device
clocks are generated from an external clock source input on the X1 or the XCLKIN pin.
Table 3-15. Possible PLL Configuration Modes
SYSCLKOUT
(CLKIN)
OSCCLK/2
PLL MODE
REMARKS
PLLSTS[CLKINDIV]
Invoked by the user setting the PLLOFF bit in the PLLSTS register. The PLL block
is disabled in this mode. This can be useful to reduce system noise and for low
power operation. The PLLCR register must first be set to 0x0000 (PLL Bypass)
before entering this mode. The CPU clock (CLKIN) is derived directly from the
input clock on either X1/X2, X1 or XCLKIN.
PLL Bypass is the default PLL configuration upon power-up or after an external
reset (XRS). This mode is selected when the PLLCR register is set to 0x0000 or
while the PLL locks to a new frequency after the PLLCR register has been
modified. In this mode, the PLL itself is bypassed but the PLL is not turned off.
Achieved by writing a non-zero value n into the PLLCR register. Upon writing to the
PLLCR the device will switch to PLL Bypass mode until the PLL locks.
0
PLL Off
1
OSCCLK
0
OSCCLK/2
PLL Bypass
1
OSCCLK
PLL Enable
0
OSCCLK*n/2
3.6.1.3
Loss of Input Clock
In PLL-enabled and PLL-bypass mode, if the input clock OSCCLK is removed or absent, the PLL will still
issue a "limp-mode" clock. The limp-mode clock continues to clock the CPU and peripherals at a typical
frequency of 1-5 MHz. Limp mode is not specified to work from power-up, only after input clocks have
been present initially. In PLL bypass mode, the limp mode clock from the PLL is automatically routed to
the CPU if the input clock is removed or absent.
Functional Overview
43
相關PDF資料
PDF描述
TMS320LC545B FIXED-POINT DIGITAL SIGNAL PROCESSORS
TMS320LC546B 1A, 52kHz (250kHz Max) Current Mode PWM Control Circuit with 8.4V UVLO Threshold and 48% Max Duty Cycle; Package: SOIC 14 LEAD; No of Pins: 14; Container: Rail; Qty per Container: 55
TMS320LC54x 1A, 52kHz (250kHz Max) Current Mode PWM Control Circuit with 16V UVLO Threshold and 96% Max Duty Cycle; Package: SOIC-8 Narrow Body; No of Pins: 8; Container: Rail; Qty per Container: 98
TMS320LC5x 1A, 52kHz (250kHz Max) Current Mode PWM Control Circuit with 16V UVLO Threshold and 96% Max Duty Cycle; Package: 8 LEAD PDIP; No of Pins: 8; Container: Rail; Qty per Container: 50
TMS320LC5X 1A, 52kHz (250kHz Max) Current Mode PWM Control Circuit with 16V UVLO Threshold and 96% Max Duty Cycle; Package: SOIC-8 Narrow Body; No of Pins: 8; Container: Rail; Qty per Container: 98
相關代理商/技術參數
參數描述
TMS320-JTAG 功能描述:仿真器/模擬器 DSP JTAG FOR PROG & EMULATION RoHS:否 制造商:Blackhawk 產品:System Trace Emulators 工具用于評估:C6000, C5000, C2000, OMAP, DAVINCI, SITARA, TMS470, TMS570, ARM 7/9, ARM Cortex A8/R4/M3 用于:XDS560v2
TMS320-JTAG-USB 功能描述:JTAG調試器 DSP USB JTAG FOR XDS100 SOFTWARE RoHS:否 制造商:Olimex Ltd. 產品:JTAG In-Circuit Debuggers 工具用于評估:MSP430 Flash MCUs 用于:MSP430 Kick Start, MSPGCC 核心:MSP430 接口類型:JTAG, USB 工作電源電壓:12 V
TMS320LBC51PQA57 功能描述:數字信號處理器和控制器 - DSP, DSC DSP RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
TMS320LBC51PZ 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述:
TMS320LBC51PZ57 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述: