參數資料
型號: TMS320C6711GGUA120
廠商: Texas Instruments, Inc.
元件分類: 數字信號處理
英文描述: FIXED-POINT DIGITAL SIGNAL PROCESSORS
中文描述: 定點數字信號處理器
文件頁數: 107/123頁
文件大小: 1205K
代理商: TMS320C6711GGUA120
www.ti.com
20
15
SPISIMO
SPISOMI
SPICLK
(clock polarity = 1)
SPICLK
(clock polarity = 0)
SPISIMO Data
Must Be Valid
SPISOMI Data Is Valid
19
16
14
13
12
SPISTE
(A)
TMS320F2808, TMS320F2806
TMS320F2801, UCD9501
Digital Signal Processors
SPRS230F–OCTOBER 2003–REVISED SEPTEMBER 2005
A.
In the slave mode, the SPISTE signal should be asserted low at least 0.5t
c(SPC)
(minimum) before the valid SPI clock
edge and remain low for at least 0.5t
c(SPC)
after the receiving edge (SPICLK) of the last data bit.
Figure 6-19. SPI Slave Mode External Timing (Clock Phase = 0)
Table 6-35. SPI Slave Mode External Timing (Clock Phase = 1)
(1)(2)(3)(4)
NO.
12
13
MIN
MAX
UNIT
ns
ns
ns
ns
ns
ns
ns
ns
ns
t
c(SPC)S
t
w(SPCH)S
t
w(SPCL)S
t
w(SPCL)S
t
w(SPCH)S
t
su(SOMI-SPCH)S
t
su(SOMI-SPCL)S
t
v(SPCH-SOMI)S
t
v(SPCL-SOMI)S
Cycle time, SPICLK
Pulse duration, SPICLK high (clock polarity = 0)
Pulse duration, SPICLK low (clock polarity = 1)
Pulse duration, SPICLK low (clock polarity = 0)
Pulse duration, SPICLK high (clock polarity = 1)
Setup time, SPISOMI before SPICLK high (clock polarity = 0)
Setup time, SPISOMI before SPICLK low (clock polarity = 1
Valid time, SPISOMI data valid after SPICLK low (clock polarity = 0)
Valid time, SPISOMI data valid after SPICLK high (clock polarity =
1)
Setup time, SPISIMO before SPICLK high (clock polarity = 0)
Setup time, SPISIMO before SPICLK low (clock polarity = 1)
Valid time, SPISIMO data valid after SPICLK high (clock polarity =
0)
Valid time, SPISIMO data valid after SPICLK low (clock polarity = 1)
8t
c(LCO)
0.5t
c(SPC)S
- 10
0.5t
c(SPC)S
- 10
0.5t
c(SPC)S
- 10
0.5t
c(SPC)S
- 10
0.125t
c(SPC)S
0.125t
c(SPC)S
0.75t
c(SPC)S
0.75t
c(SPC)S
0.5t
c(SPC)S
0.5t
c(SPC)S
0.5t
c(SPC)S
0.5t
c(SPC)S
14
17
18
21
t
su(SIMO-SPCH)S
t
su(SIMO-SPCL)S
t
v(SPCH-SIMO)S
35
35
ns
ns
ns
22
0.5t
c(SPC)S
t
v(SPCL-SIMO)S
0.5t
c(SPC)S
ns
(1)
(2)
(3)
The MASTER / SLAVE bit (SPICTL.2) is cleared and the CLOCK PHASE bit (SPICTL.3) is cleared.
t
= SPI clock cycle time = LSPCLK/4 or LSPCLK/(SPIBRR + 1)
Internal clock prescalers must be adjusted such that the SPI clock speed is limited to the following SPI clock rate:
Master mode transmit 25-MHz MAX, master mode receive 12.5-MHz MAX
Slave mode transmit 12.5-MHz MAX, slave mode receive 12.5-MHz MAX.
The active edge of the SPICLK signal referenced is controlled by the CLOCK POLARITY bit (SPICCR.6).
(4)
Electrical Specifications
107
相關PDF資料
PDF描述
TMS320C6211GGUA120 FIXED-POINT DIGITAL SIGNAL PROCESSORS
TMS320C6711GGUA100 FIXED-POINT DIGITAL SIGNAL PROCESSORS
TMS320C6211GGUA100 FIXED-POINT DIGITAL SIGNAL PROCESSORS
TMS320VC549GGU FIXED-POINT DIGITAL SIGNAL PROCESSOR
TMS320LC549GGU SENSOR, MINIATURE, NTC, 3K; Series:B578; Thermistor type:NTC; Resistance:3kR; Beta value:3988; Temperature, lower limit, beta value:25(degree C); Temperature, upper limit, beta value:100(degree C); Temp, op. max:155(degree C); Case RoHS Compliant: Yes
相關代理商/技術參數
參數描述
TMS320C6712CGDP150 制造商:Texas Instruments 功能描述:
TMS320C6712DGDP150 功能描述:數字信號處理器和控制器 - DSP, DSC Floating-Pt Dig Sig Proc RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
TMS320C6712DZDP150 功能描述:數字信號處理器和控制器 - DSP, DSC Floating-Pt Dig Sig Proc RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
TMS320C6712GFN100 功能描述:IC FLOATING POINT DSP 256-BGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - DSP(數字式信號處理器) 系列:TMS320C67x 標準包裝:2 系列:StarCore 類型:SC140 內核 接口:DSI,以太網,RS-232 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:1.436MB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:431-BFBGA,FCBGA 供應商設備封裝:431-FCPBGA(20x20) 包裝:托盤
TMS320C6713BGDP225 功能描述:數字信號處理器和控制器 - DSP, DSC Floating-Pt Dig Sig Processors RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT