參數資料
型號: TMS320C6415TBGLZA6
廠商: Texas Instruments
文件頁數: 97/146頁
文件大小: 0K
描述: IC FIXED-POINT DSP 532-FCBGA
標準包裝: 60
系列: TMS320C6414T/15T/16T
類型: 定點
接口: 主機接口,McBSP,PCI,UTOPIA
時鐘速率: 600MHz
非易失內存: 外部
芯片上RAM: 1.03MB
電壓 - 輸入/輸出: 3.30V
電壓 - 核心: 1.10V
工作溫度: -40°C ~ 105°C
安裝類型: 表面貼裝
封裝/外殼: 532-BFBGA,F(xiàn)CBGA
供應商設備封裝: 532-FCBGA(23x23)
包裝: 托盤
配用: TMDXEVM6452-ND - TMDXEVM6452
296-23038-ND - DSP STARTER KIT FOR TMS320C6416
TMS320C6414T, TMS320C6415T, TMS320C6416T
FIXEDPOINT DIGITAL SIGNAL PROCESSORS
SPRS226M NOVEMBER 2003 REVISED APRIL 2009
54
POST OFFICE BOX 1443
HOUSTON, TEXAS 772511443
Terminal Functions (Continued)
SIGNAL
TYPE
IPD/
DESCRIPTION
NAME
NO.
TYPE
IPD/
IPU
DESCRIPTION
UTOPIA SLAVE (ATM CONTROLLER) TRANSMIT INTERFACE (CONTINUED)
UXDATA7Y
AD10
UXDATA6Y
AD9
UXDATA5Y
AD8
8-bit Transmit Data Bus
Using the Transmit Data Bus, the UTOPIA Slave (on the rising edge of the UXCLK) transmits
UXDATA4Y
AE8
O/Z
8-bit Transmit Data Bus
Using the Transmit Data Bus, the UTOPIA Slave (on the rising edge of the UXCLK) transmits
the 8-bit ATM cells to the Master ATM Controller.
UXDATA3Y
AF9
O/Z
the 8-bit ATM cells to the Master ATM Controller.
When the UTOPIA peripheral is disabled (UTOPIA_EN [BEA11 pin] = 0), these pins are tied-
UXDATA2Y
AF7
When the UTOPIA peripheral is disabled (UTOPIA_EN [BEA11 pin] = 0), these pins are tied-
off.
UXDATA1Y
AE7
off.
UXDATA0Y
AD7
UTOPIA SLAVE (ATM CONTROLLER) RECEIVE INTERFACE
URCLKY
AD12
I
h
Source clock for UTOPIA receive driven by Master ATM Controller.
When the UTOPIA peripheral is disabled (UTOPIA_EN [BEA11 pin] = 0), this pin is tied-off.
URCLAVY
AF14
O/Z
Receive cell available status output signal from UTOPIA Slave.
0
indicates NO space is available to receive a cell from Master ATM Controller
1
indicates space is available to receive a cell from Master ATM Controller
When the UTOPIA peripheral is disabled (UTOPIA_EN [BEA11 pin] = 0), this pin is tied-off.
URENBY
AD15
I
UTOPIA receive interface enable input signal. Asserted by the Master ATM Controller to indi-
cate to the UTOPIA Slave to sample the Receive Data Bus (URDATA[7:0]) and URSOC signal
in the next clock cycle or thereafter.
When the UTOPIA peripheral is disabled (UTOPIA_EN [BEA11 pin] = 0), this pin is tied-off.
URSOCY
AB14
I
h
Receive Start-of-Cell signal. This signal is output by the Master ATM Controller to indicate to
the UTOPIA Slave that the first valid byte of the cell is available to sample on the 8-bit Receive
Data Bus (URDATA[7:0]).
When the UTOPIA peripheral is disabled (UTOPIA_EN [BEA11 pin] = 0), this pin is tied-off.
CLKX1/
URADDR4§
AB12
I/O/Z
McBSP1 [default] or UTOPIA receive address pins
As UTOPIA receive address pins URADDR[4:0] (I), UTOPIA_EN (BEA11 pin) = 1:
CLKS1/
URADDR3§
AC8
I
As UTOPIA receive address pins URADDR[4:0] (I), UTOPIA_EN (BEA11 pin) = 1:
5-bit Slave receive address input pins driven by the Master ATM Controller to identify and
select one of the Slave devices (up to 31 possible) in the ATM System.
CLKR1/
URADDR2§
AC10
I/O/Z
select one of the Slave devices (up to 31 possible) in the ATM System.
URADDR1 and URADDR0 pins are tied off when the UTOPIA peripheral is disabled
[UTOPIA_EN (BEA11 pin) = 0]
URADDR1Y
AF10
I
[UTOPIA_EN (BEA11 pin) = 0]
For the McBSP1 pin functions (UTOPIA_EN (BEA11 pin) = 0 [default]), see the
URADDR0Y
AE10
I
For the McBSP1 pin functions (UTOPIA_EN (BEA11 pin) = 0 [default]), see the
MULTICHANNEL BUFFERED SERIAL PORT 1 (McBSP1) section of this table.
I = Input, O = Output, Z = High impedance, S = Supply voltage, GND = Ground
IPD = Internal pulldown, IPU = Internal pullup. (These IPD/IPU signal pins feature a 30-k IPD or IPU resistor. To pull up a signal to the opposite
supply rail, a 1-k
resistor should be used.)
§ These pins are multiplexed pins. For more details, see the Device Configurations section of this data sheet.
hExternal pulldowns required: If UTOPIA is selected (BEA11 = 1) and these pins are connected to other devices, then a 10-k resistor must be
used to externally pull down each of these pins. If these pins are “no connects”, then only UXCLK and URCLK need to be pulled down and other
pulldowns are not necessary.
External pullups required: If UTOPIA is selected (BEA11 = 1) and these pins are connected to other devices, then a 10-k resistor must be used
to externally pull up each of these pins. If these pins are “no connects”, then the pullups are not necessary.
ΨThe C6414T device does not support the UTOPIA peripheral; therefore, these standalone UTOPIA pins are Reserved (leave unconnected, do
not connect to power or ground) with the exception of UXCLK and URCLK which should be connected to a 10-k
pulldown resistor (see the
square [
h] footnote).
相關PDF資料
PDF描述
VE-B3P-EU-S CONVERTER MOD DC/DC 13.8V 200W
R05P212D/P/R6.4 CONV DC/DC 2W 05VIN +/-12VOUT
AGM24DTBT CONN EDGECARD 48POS R/A .156 SLD
GMA50DTAS CONN EDGECARD 100PS R/A .125 SLD
TPSD107K016Y0125 CAP TANT 100UF 16V 10% 2917
相關代理商/技術參數
參數描述
TMS320C6415TBGLZA7 功能描述:數字信號處理器和控制器 - DSP, DSC Fixed-Pt Dig Sig Proc RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
TMS320C6415TBGLZA8 功能描述:數字信號處理器和控制器 - DSP, DSC Fixed-Pt Dig Sig Proc RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
TMS320C6415TBGLZW8 制造商:Texas Instruments 功能描述:
TMS320C6415TBZLZ1 功能描述:數字信號處理器和控制器 - DSP, DSC Fixed-Pt Dig Sig Proc RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
TMS320C6415TBZLZ6 功能描述:數字信號處理器和控制器 - DSP, DSC Fixed-Pt Dig Sig Proc RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT