- 您現在的位置：買賣IC網 > PDF目錄359296 > TMS320C6211FN100 (Texas Instruments, Inc.) POT 500 OHM 1/4 RND CERM SL ST PDF資料下載
參數資料
| 型號： | TMS320C6211FN100 |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | POT 500 OHM 1/4 RND CERM SL ST |
| 中文描述： | 定點數字信號處理器 |
| 文件頁數： | 45/123頁 |
| 文件大?。?/td> | 1205K |
| 代理商： | TMS320C6211FN100 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁當前第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁
www.ti.com
3.7
Low-Power Modes Block
TMS320F2808, TMS320F2806
TMS320F2801, UCD9501
Digital Signal Processors
SPRS230F–OCTOBER 2003–REVISED SEPTEMBER 2005
In STANDBY mode, all peripherals are turned off on the device. The only peripheral that remains
functional is the watchdog. The WATCHDOG module will run off OSCCLK. The WDINT signal is fed to the
LPM block so that it can wake the device from STANDBY (if enabled). See Section
Section 3.7
,
Low-Power Modes Block, for more details.
In IDLE mode, the WDINT signal can generate an interrupt to the CPU, via the PIE, to take the CPU out of
IDLE mode.
In HALT mode, this feature cannot be used because the oscillator (and PLL) are turned off and hence so
is the WATCHDOG.
The low-power modes on the 280x are similar to the 240x devices.
Table 3-16
summarizes the various
modes.
Table 3-16. Low-Power Modes
MODE
LPMCR0(1:0)
OSCCLK
CLKIN
SYSCLKOUT
EXIT
(1)
XRS, Watchdog interrupt, any enabled
interrupt, XNMI
XRS, Watchdog interrupt, GPIO Port A
signal, debugger
(3)
, XNMI
IDLE
00
On
On
On
(2)
On
STANDBY
01
Off
Off
(watchdog still running)
Off
(oscillator and PLL turned off,
watchdog not functional)
XRS, GPIO Port A signal, XNMI,
debugger
(3)
HALT
1X
Off
Off
(1)
The Exit column lists which signals or under what conditions the low power mode will be exited. A low signal, on any of the signals, will
exit the low power condition. This signal must be kept low long enough for an interrupt to be recognized by the device. Otherwise the
IDLE mode will not be exited and the device will go back into the indicated low power mode.
The IDLE mode on the C28x behaves differently than on the 24x/240x. On the C28x, the clock output from the CPU (SYSCLKOUT) is
still functional while on the 24x/240x the clock is turned off.
On the C28x, the JTAG port can still function even if the CPU clock (CLKIN) is turned off.
(2)
(3)
The various low-power modes operate as follows:
IDLE Mode:
This mode is exited by any enabled interrupt or an XNMI that is recognized by
the processor. The LPM block performs no tasks during this mode as long as the
LPMCR0(LPM) bits are set to 0,0.
Any GPIO port A signal (GPIO[31:0]) can wake the device from STANDBY
mode. The user must select which signal(s) will wake the device in the
GPIOLPMSEL register. The selected signal(s) are also qualified by the OSCCLK
before waking the device. The number of OSCCLKs is specified in the LPMCR0
register.
Only the XRS and any GPIO port A signal (GPIO[31:0]) can wake the device
from HALT mode. The user selects the signal in the GPIOLPMSEL register.
STANDBY Mode:
HALT Mode:
NOTE
The low-power modes do not affect the state of the output pins (PWM pins included).
They will be in whatever state the code left them in when the IDLE instruction was
executed. See the
TMS320x280x System Control and Interrupts Reference Guide
(literature number SPRU712) for more details.
Functional Overview
45
相關PDF資料 |
PDF描述 |
|---|---|
| TMS320C6211FDA167 | TRIMPOT 50K OHM 3MM CERMET SMD |
| TMS320C6211FDA150 | FIXED-POINT DIGITAL SIGNAL PROCESSORS |
| TMS320C6711J167 | Hook-Up Wire; Conductor Size AWG:16; No. Strands x Strand Size:19 x 29; Jacket Color:Orange; Cable/Wire MIL SPEC:MIL-W-16878/1 Type B; Conductor Material:Copper; Jacket Material:Polyvinylchloride (PVC); Leaded Process Compatible:Yes RoHS Compliant: Yes |
| TMS320C6211J167 | Hook-Up Wire; Conductor Size AWG:16; No. Strands x Strand Size:19 x 29; Jacket Color:Red; Cable/Wire MIL SPEC:MIL-W-16878/1 Type B; Conductor Material:Copper; Jacket Material:Polyvinylchloride (PVC); Leaded Process Compatible:No RoHS Compliant: Yes |
| TMS320C6711J150 | Hook-Up Wire; Conductor Size AWG:16; No. Strands x Strand Size:19 x 29; Jacket Color:Red; Cable/Wire MIL SPEC:MIL-W-16878/1 Type B; Conductor Material:Copper; Jacket Material:Polyvinylchloride (PVC); Leaded Process Compatible:No RoHS Compliant: Yes |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TMS320C6211FN120 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:FIXED-POINT DIGITAL SIGNAL PROCESSORS |
| TMS320C6211FN150 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:FIXED-POINT DIGITAL SIGNAL PROCESSORS |
| TMS320C6211FN167 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:FIXED-POINT DIGITAL SIGNAL PROCESSORS |
| TMS320C6211FNA100 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:FIXED-POINT DIGITAL SIGNAL PROCESSORS |
| TMS320C6211FNA120 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:FIXED-POINT DIGITAL SIGNAL PROCESSORS |
發布緊急采購，3分鐘左右您將得到回復。