參數資料
型號： TLE7209R
廠商： INFINEON TECHNOLOGIES AG
元件分類： 運動控制電子
英文描述： STEPPER MOTOR CONTROLLER, PDSO20
封裝： PLASTIC, SOP-20
文件頁數： 31/31頁
文件大?。?/td> 484K
代理商： TLE7209R
TLE 7209R
Circuit Description
Final Datasheet
9
V2.5, 2004-may-25
2.4.1
Status-Flag (SF) Mode (DMS = GND)
2.4.1.1
SF output
In SF-mode, pin 2 is used as an open-drain output status-flag. The pin has to be pulled
to the logic supply voltage with a pull-up resistor, 47 kOhm recommended.
In case of any failure that leads to a shut-down of the outputs, the status-flag is set (e.g.
SF pin pulled to low). These failures are:
– Under Voltage on
VS
– Short circuit of OUT1 or OUT2 against
VS or GND
– Short circuit between OUT1 and OUT2
– Over-current
– Over-temperature
When EN or DIS disables the output stages, status flag SF is pulled low.
2.4.1.2
Fault storage and reset
– In case of Under-Voltage, the failure is not latched. As soon as
VS falls below the
under-Voltage detection threshold, the output stage switches in tristate and the status-
flag is set from high level to low-level. If the voltage has risen above the specified value
again, the output stage switches on again and the status-flag is reset to high-level.
The Under-Voltage failure is shown at the SF pin for
VS in the voltage range below the
detection threshold (typical 4.2V) down to 2.5V.
– In the SF-mode, all internal circuitry is supplied by the voltage on
VS. For that reason,
a loss of
VS supply voltage leads to a reset of all stored information (Power-ON-
Reset). This Power-ON-Reset occurs as soon as under-Voltage is detected on
VS
– In case of short circuit, over-current or over-temperature, the fault will be stored.
The output stage remains in tristate and the status-flag at low-level until the error is
reset by one of the following conditions: H -> L on DIS, L -> H on EN or Power-ON
Reset.
2.4.2
SPI-Mode (DMS = 5V)
2.4.2.1
SPI-Interface
The serial SPI interface establishes a communication link between TLE 7209R and the
systems microcontroller. The TLE 7209R always operates in slave mode whereas the
controller provides the master function. The maximum baud rate is 2 MBaud (200pF on
SDO).
By applying an active slave select signal at CSN the TLE 7209R is selected by the SPI
master. SDI is the data input (Slave In), SDO the data output (Slave Out). Via SCK
(Serial Clock Input) the SPI clock is provided by the master. In case of inactive slave
select signal (High) the data output SDO goes into tristate.
相關PDF資料
PDF描述
TLE7824G SPECIALTY ANALOG CIRCUIT, PDSO28
TLE8201R SPECIALTY CONSUMER CIRCUIT, PDSO36
TLE8242-2 SPECIALTY ANALOG CIRCUIT, PQFP64
TLE8366EV33 SWITCHING REGULATOR, PDSO8
TLE8366EV50 SWITCHING REGULATOR, PDSO8
相關代理商/技術參數
參數描述
TLE7230G 功能描述:電源開關 IC - 配電 8 CH LW-Side Switch RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5
TLE7230GNT 制造商:Infineon Technologies AG 功能描述:Power Switch Lo Side 1A 24-Pin DSO
TLE7230GS 功能描述:功率驅動器IC SPI DRVR Enhanced Relay CTRL RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube
TLE7230GSFUMA1 制造商:Infineon Technologies AG 功能描述:IC DRIVER SPI 8CH LS 24-SSOP
TLE7230GXUMA1 制造商:Infineon Technologies AG 功能描述:Power Switch Lo Side 1A 24-Pin DSO 制造商:Infineon Technologies AG 功能描述:MC RELAY + LED - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC SW SMART OCTAL LOWSIDE PDSO24
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*