- 您現在的位置：買賣IC網 > PDF目錄361500 > TK732XX (TOKO Inc.) Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection PDF資料下載
參數資料
| 型號： | TK732XX |
| 廠商： | TOKO Inc. |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection |
| 中文描述： | 無電容，NMOS管，150mA的低壓差穩壓器的反向電流保護 |
| 文件頁數： | 11/16頁 |
| 文件大?。?/td> | 117K |
| 代理商： | TK732XX |
January 1999 TOKO, Inc.
Page 11
TK732xx
3)
4)
Plot P
D1
against 25
°
C
Connect P
D1
to the point corresponding to the 150
°
C
with a straight line.
In design, take a vertical line from the maximum
operating temperature (e.g., 75
°
C) to the derating
curve.
Read off the value of P
D
against the point at which the
vertical line intersects the derating curve. This is taken
as the maximum power dissipation, D
PD
.
5)
6)
The maximum operating current is:
I
OUT
= (D
PD
/ (V
IN(MAX)
-
V
OUT
)
SOT-23L-8 POWER DISSIPATION CURVE
VIN
RIPK
CONTROL
GND
GND
VOUT
DEFINITIONS AND TERMS (CONT.)
0 50 100 150
TA (
°
C)
P
0
450
750
150
300
600
MOUNTED AS
SHOWN
FREE AIR
INPUT-OUTPUT CAPACITORS
The output capacitor is necessary for stable operation.
The regulator may oscillate if the output capacitor is too
small or missing. The output capacitor size is determined
by load, transient response and external transistor used.
Evaluation in the circuit is recommended to ensure
performance requirements are satisfied. A minimum of 4.7
μ
F is necessary for stability, with twice that value
recommended. The minimum recommended input
capacitor is 1
μ
F. Problems do not occur with larger values
of capacitance. However, extremely low ESR may result in
unstable operation. Thus, the use of large value ceramic
capacitors is not recommended on the output.
BOARD LAYOUT
SOT-23L-8 BOARD LAYOUT
APPLICATION INFORMATION
相關PDF資料 |
PDF描述 |
|---|---|
| TK75001 | PWM CONTROLLER |
| TK75001D | PWM CONTROLLER |
| TK75001DIMG | PWM CONTROLLER |
| TK75002 | ERROR SIGNAL ISOLATOR |
| TK75002D | ERROR SIGNAL ISOLATOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TK7408 | 制造商:Tekmos 功能描述:IC, PLCC-44 |
| TK75 | 制造商:ALTECH 制造商全稱:Altech corporation 功能描述:POLYCARBONATE ENCLOSURE TK 75 |
| TK7500 | 功能描述:沖壓機與沖模 FRM W/4 DIES & CASE RoHS:否 制造商:Souriau 大小: 產品:Dies 類型:Crimping 描述/功能: |
| TK75001 | 制造商:TOKO 制造商全稱:TOKO, Inc 功能描述:PWM CONTROLLER |
| TK75001D | 制造商:TOKO 制造商全稱:TOKO, Inc 功能描述:PWM CONTROLLER |
發布緊急采購，3分鐘左右您將得到回復。