- 您現在的位置：買賣IC網 > PDF目錄361460 > TISP7082F3DR (Power Innovations International, Inc.) TRIPLE BIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS PDF資料下載
參數資料
| 型號： | TISP7082F3DR |
| 廠商： | Power Innovations International, Inc. |
| 英文描述： | TRIPLE BIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS |
| 中文描述： | 三重雙向可控硅過電壓保護器 |
| 文件頁數： | 14/22頁 |
| 文件大?。?/td> | 400K |
| 代理商： | TISP7082F3DR |
TISP7072F3,TISP7082F3
TRIPLEBIDIRECTIONALTHYRISTOROVERVOLTAGEPROTECTORS
MARCH 1994 - REVISED MARCH 2000
14
P R O D U C T I N F O R M A T I O N
The combination generator has three testing configurations; directly applied for testing between equipment
a.c. supply connections, applied via an external 10
resistor for testing between the a.c. supply connections
and ground, and applied via an external 40
resistor for testing all other lines. For unshielded unsymmetrical
data or signalling lines, the combination generator is applied via a 40
resistor either between lines or line to
ground. For unshielded symmetrical telecommunication lines, the combination generator is applied to all lines
via a resistor of n x 40
, where n is the number of conductors and the maximum value of external feed
resistance is 250
. Thus for four conductors n = 4 and the series resistance is 4 x 40 = 160
. For ten
conductors the resistance cannot be 10 x 40 = 400
and must be 250
. The combination generator is used
for short distance lines, long distance lines are tested with the 10/700 generator.
When the combination generator is used with a 40
, or more, external resistor, the current wave shape is not
8/20, but becomes closer to the open circuit voltage wave shape of 1.2/50. For example, a commercial
generator when used with 40
produced an 1.4/50 wave shape.
The wave shapes of 1.2/50 and 8/20 occur in other generators as well. British Telecommunication has a
combination generator with 1.2/50 voltage and 8/20 current wave shapes, but it has a fictive resistance of 1
.
ITU-T recommendation K.22 “Overvoltage resistibility of equipment connected to an ISDN T/S BUS” (05/95)
has a 1.2/50 generator option using only resistive and capacitive elements, Figure 19.
The K.22 generator produces a 1.4/53 open circuit voltage wave. Using 25
output resistors, gives a single
short circuit current output wave shape of 0.8/18 with 26 A/kV and a dual of 0.6/13 with 20 A/kV. These
current wave shapes are often rounded to 1/20 and 0.8/14.
There are 8/20 short circuit current defined generators. These are usually very high current, 10 kA or more
and are used for testing a.c. protectors, primary protection modules and some Gas Discharge Tubes.
impulse testing
To verify the withstand capability and safety of the equipment, standards require that the equipment is tested
with various impulse wave forms. The table in this section shows some common test values.
Manufacturers are being increasingly required to design in protection coordination. This means that each
protector is operated at its design level and currents are diverted through the appropriate protector e.g. the
primary level current through the primary protector and lower levels of current may be diverted through the
secondary or inherent equipment protection. Without coordination, primary level currents could pass through
the equipment only designed to pass secondary level currents. To ensure coordination happens with fixed
voltage protectors, some resistance is normally used between the primary and secondary protection (R1a
and R1b Figure 21). The coordination resistance values given in here apply to a 400 V (d.c. sparkover) gas
discharge tube primary protector and the appropriate test voltage when the equipment is tested with a
primary protector.
Figure 19.
C
2
30 nF
R
1
76
C
1
1 μF
R
2
13
SW
V
C
1 kV
K.22 1.2/50 GENERATOR
C
3
8 nF
C
4
8 nF
NOTE: SOME STANDARDS
REPLACE OUTPUT
CAPACITORS WITH
25
RESISTORS
相關PDF資料 |
PDF描述 |
|---|---|
| TISP7082F3P | TRIPLE BIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS |
| TISP7082F3SL | TRIPLE BIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS |
| TISP7125F3 | TRIPLE BIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS |
| TISP7380F3 | TRIPLE BIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS |
| TISP7180F3SL | TRIPLE BIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TISP7082F3DR-S | 功能描述:硅對稱二端開關元件 Low Volt Triple Elmt Bidirectional RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA |
| TISP7082F3D-S | 功能描述:硅對稱二端開關元件 Low Volt Triple Elmt Bidirectional RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA |
| TISP7082F3P | 功能描述:硅對稱二端開關元件 Low Volt Triple Elmt Bidirectional RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA |
| TISP7082F3PS | 制造商:Bourns Inc 功能描述: |
| TISP7082F3P-S | 功能描述:硅對稱二端開關元件 Low Volt Triple Elmt Bidirectional RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA |
發布緊急采購，3分鐘左右您將得到回復。