- 您現在的位置：買賣IC網 > PDF目錄361459 > TISP4180F3 (Power Innovations International, Inc.) SYMMETRICAL TRANSIENT VOLTAGE SUPPRESSORS PDF資料下載
參數資料
| 型號： | TISP4180F3 |
| 廠商： | Power Innovations International, Inc. |
| 英文描述： | SYMMETRICAL TRANSIENT VOLTAGE SUPPRESSORS |
| 中文描述： | 對稱瞬態電壓抑制器 |
| 文件頁數： | 7/12頁 |
| 文件大小： | 326K |
| 代理商： | TISP4180F3 |
7
MARCH 1994 - REVISED SEPTEMBER 1997
TISP4125F3, TISP4150F3, TISP4180F3
SYMMETRICAL TRANSIENT
VOLTAGE SUPPRESSORS
P R O D U C T I N F O R M A T I O N
APPLICATIONS INFORMATION
electrical characteristics
The electrical characteristics of a TISP are strongly dependent on junction temperature, T
J
. Hence a
characteristic value will depend on the junction temperature at the instant of measurement. The values given
in this data sheet were measured on commercial testers, which generally minimise the temperature rise
caused by testing. Application values may be calculated from the parameters’ temperature curves, the power
dissipated and the thermal response curve (Z
θ
).
lightning surge
wave shape notation
Most lightning tests, used for equipment verification, specify a unidirectional sawtooth waveform which has an
exponential rise and an exponential decay. Wave shapes are classified in terms of peak amplitude (voltage
or current), rise time and a decay time to 50% of the maximum amplitude. The notation used for the wave
shape is
amplitude, rise time/decay time
. A 50A, 5/310 μs wave shape would have a peak current value of
50 A, a rise time of 5 μs and a decay time of 310 μs. The TISP surge current graph comprehends the wave
shapes of commonly used surges.
generators
There are three categories of surge generator type, single wave shape, combination wave shape and circuit
defined. Single wave shape generators have essentially the same wave shape for the open circuit voltage
and short circuit current (e.g. 10/1000 μs open circuit voltage and short circuit current). Combination
generators have two wave shapes, one for the open circuit voltage and the other for the short circuit current
(e.g. 1.2/50 μs open circuit voltage and 8/20 μs short circuit current) Circuit specified generators usually
equate to a combination generator, although typically only the open circuit voltage waveshape is referenced
(e.g. a 10/700 μs open circuit voltage generator typically produces a 5/310 μs short circuit current). If the
combination or circuit defined generators operate into a finite resistance the wave shape produced is
intermediate between the open circuit and short circuit values.
current rating
When the TISP switches into the on-state it has a very low impedance. As a result, although the surge wave
shape may be defined in terms of open circuit voltage, it is the current wave shape that must be used to
assess the required TISP surge capability. As an example, the CCITT IX K17 1.5 kV, 10/700 μs surge is
changed to a 38 A, 5/310 μs waveshape when driving into a short circuit. Thus the TISP surge current
capability, when directly connected to the generator, will be found for the CCITT IX K17 waveform at 310 μs
on the surge graph and not 700 μs. Some common short circuit equivalents are tabulated below:
Any series resistance in the protected equipment will reduce the peak circuit current to less than the
generators’ short circuit value. A 2 kV open circuit voltage, 50 A short circuit current generator has an
effective output impedance of 40
(2000/50)
.
If the equipment has a series resistance of 25
then the
surge current requirement of the TISP becomes 31 A (2000/65) and not 50 A.
STANDARD
OPEN CIRCUIT
VOLTAGE
SHORT CIRCUIT
CURRENT
CCITT IX K17
CCITT IX K20
RLM88
VDE 0433
FTZ R12
1.5 kV, 10/700 μs
1 kV, 10/700 μs
1.5 kV, 0.5/700 μs
2.0 kV, 10/700 μs
2.0 kV, 10/700 μs
38 A, 5/310 μs
25 A, 5/310 μs
38 A, 0.2/310 μs
50 A, 5/200 μs
50 A, 5/310 μs
相關PDF資料 |
PDF描述 |
|---|---|
| TISP4125F3 | SYMMETRICAL TRANSIENT VOLTAGE SUPPRESSORS |
| TISP4150F3 | SYMMETRICAL TRANSIENT VOLTAGE SUPPRESSORS |
| TISP4180 | SYMMETRICAL TRANSIENT VOLTAGE SUPPRESSORS |
| TISP4180LP | SYMMETRICAL TRANSIENT VOLTAGE SUPPRESSORS |
| TISP4220H3LM | BIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TISP4180F3DR | 功能描述:硅對稱二端開關元件 RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA |
| TISP4180F3DRS | 制造商:Bourns Inc 功能描述: |
| TISP4180F3DR-S | 功能描述:硅對稱二端開關元件 RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA |
| TISP4180F3LM | 功能描述:硅對稱二端開關元件 RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA |
| TISP4180F3LMFR | 功能描述:硅對稱二端開關元件 RoHS:否 制造商:Bourns 轉折電流 VBO:40 V 最大轉折電流 IBO:800 mA 不重復通態電流: 額定重復關閉狀態電壓 VDRM:25 V 關閉狀態漏泄電流（在 VDRM IDRM 下）: 保持電流（Ih 最大值）:50 mA 開啟狀態電壓:5 V 關閉狀態電容 CO:120 pF 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AA |
發布緊急采購，3分鐘左右您將得到回復。