參數資料
型號: Tiny12
廠商: Atmel Corp.
英文描述: 8-bit AVR Microcontroller with 1K Byte Flash
中文描述: 8位AVR微控制器,帶有1K字節閃存
文件頁數: 26/91頁
文件大?。?/td> 1137K
代理商: TINY12
26
ATtiny11/12
1006D–AVR–07/03
Bit 7 - Res: Reserved Bit
This bit is a reserved bit in the ATtiny11/12 and always reads as zero.
Bit 6 - INT0: External Interrupt Request 0 Enable
When the INT0 bit is set (one) and the I-bit in the Status Register (SREG) is set (one),
the external pin interrupt is enabled. The Interrupt Sense Control0 bits 1/0 (ISC01 and
ISC00) in the MCU general Control Register (MCUCR) define whether the external
interrupt is activated on rising or falling edge, on pin change, or low level of the INT0 pin.
Activity on the pin will cause an interrupt request even if INT0 is configured as an output.
The corresponding interrupt of External Interrupt Request 0 is executed from program
memory address $001. See also “External Interrupts.”
Bit 5 - PCIE: Pin Change Interrupt Enable
When the PCIE bit is set (one) and the I-bit in the Status Register (SREG) is set (one),
the interrupt on pin change is enabled. Any change on any input or I/O pin will cause an
interrupt. The corresponding interrupt of Pin Change Interrupt Request is executed from
program memory address $002. See also “Pin Change Interrupt.”
Bits 4..0 - Res: Reserved Bits
These bits are reserved bits in the ATtiny11/12 and always read as zero.
General Interrupt Flag
Register – GIFR
Bit 7 - Res: Reserved Bit
This bit is a reserved bit in the ATtiny11/12 and always reads as zero.
Bit 6 - INTF0: External Interrupt Flag0
When an edge on the INT0 pin triggers an interrupt request, the corresponding interrupt
flag, INTF0 becomes set (one). If the I-bit in SREG and the corresponding interrupt
enable bit, INT0 bit in GIMSK, are set (one), the MCU will jump to the interrupt vector.
The flag is cleared when the interrupt routine is executed. Alternatively, the flag can be
cleared by writing a logical one to it. The flag is always cleared when INT0 is configured
as level interrupt.
Bit 5 - PCIF: Pin Change Interrupt Flag
When an event on any input or I/O pin triggers an interrupt request, PCIF becomes set
(one). If the I-bit in SREG and the PCIE bit in GIMSK are set (one), the MCU will jump to
the interrupt vector at address $002. The flag is cleared when the interrupt routine is
executed. Alternatively, the flag can be cleared by writing a logical one to it.
Bits 4..0 - Res: Reserved Bits
These bits are reserved bits in the ATtiny11/12 and always read as zero.
Timer/Counter Interrupt Mask
Register – TIMSK
Bit
7
6
5
4
3
2
1
0
$3A
-
INTF0
PCIF
-
-
-
-
-
GIFR
Read/Write
R
R/W
R/W
R
R
R
R
R
Initial Value
0
0
0
0
0
0
0
0
Bit
7
6
5
4
3
2
1
0
相關PDF資料
PDF描述
TIP140 Complemetary Silicon Power Darlington Transistors(互補硅功率達林頓晶體管)
TIP142F TO-3P Fully Isolated Plastic Package Transistor CDIL
TIP145F TO-3P Fully Isolated Plastic Package Transistor CDIL
TIP140F TO-3P Fully Isolated Plastic Package Transistor CDIL
TIP141F TO-3P Fully Isolated Plastic Package Transistor CDIL
相關代理商/技術參數
參數描述
TINY88-15MZ 功能描述:8位微控制器 -MCU 8KB FLASH 12MHz AUTO RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
TINY-BWA 制造商:HCC Embedded 功能描述:TINY FILE SYSTEM FOR BYTE WRITABLE ARRAYS - Virtual or Non-Physical Inventory (Software & Literature)
TINY-RAM 制造商:HCC Embedded 功能描述:TINY FILE SYSTEM FOR RAM - Virtual or Non-Physical Inventory (Software & Literature)
TIOL1113DMWT 功能描述:IO LINK 制造商:texas instruments 系列:- 包裝:剪切帶(CT) 零件狀態:在售 類型:收發器 協議:I/O 鏈路 驅動器/接收器數:1/1 雙工:- 接收器滯后:750mV 數據速率:250kbps 電壓 - 電源:7 V ~ 36 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-VFDFN 裸露焊盤 供應商器件封裝:10-VSON(3x2.5) 標準包裝:1
TIOL1115DMWT 功能描述:IO-LINK DEVICE TRANSCEIVERS WITH 制造商:texas instruments 系列:- 包裝:剪切帶(CT) 零件狀態:在售 類型:收發器 協議:I/O 鏈路 驅動器/接收器數:1/1 雙工:- 接收器滯后:750mV 數據速率:250kbps 電壓 - 電源:7 V ~ 36 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-VFDFN 裸露焊盤 供應商器件封裝:10-VSON(3x2.5) 標準包裝:1