- 您現在的位置：買賣IC網 > PDF目錄365782 > TDA9820 (NXP SEMICONDUCTORS) Multistandard/dual channel TV FM intercarrier sound demodulator(多標準/雙頻道TV FM內載波音解調器) PDF資料下載
參數資料
| 型號： | TDA9820 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 接收器 |
| 英文描述： | Multistandard/dual channel TV FM intercarrier sound demodulator(多標準/雙頻道TV FM內載波音解調器) |
| 中文描述： | AUDIO/VIDEO DEMODULATOR, PDIP16 |
| 封裝： | 0.300 INCH, PLASTIC, MO-001AE, SOT38-1, DIP-16 |
| 文件頁數： | 5/20頁 |
| 文件大?。?/td> | 155K |
| 代理商： | TDA9820 |
1996 Nov 20
5
Philips Semiconductors
Product specification
Multistandard/dual channel TV FM
intercarrier sound demodulator
TDA9820
FUNCTIONAL DESCRIPTION
The complete circuit consists of two separate channels,
each consisting of a limiter-amplifier, FM demodulator and
AF amplifier. Circuit operation is also described in Fig.1.
Source selector
The intercarrier signal is fed through external ceramic
band-pass filters which are tuned to the sound carrier
frequencies.
One of the four filtered sound carriers from
pins 1, 2, 3 or 16 is fed to limiter-amplifier 1 via the
appropriate electronic switch in the source selector.
The electronic switch of the sound carrier is selected by
the control unit (see Table 1).
The second sound carrier of the intercarrier signal is
directly fed from pin 15 to limiter-amplifier 2.
FM demodulators
Each limiter-amplifier is AC-coupled into a
FM demodulator. The integrated FM demodulator PLLs
are alignment-free. The FM demodulator outputs are
amplified to 500 mV (RMS value). High amplification and
DC error signals of the PLLs, which are superimposed on
the FM demodulator outputs, require DC decoupling at
pins 9 and 10 of the AF amplifier inputs.
Stereo channel separation adjustment (optional)
Optimal stereo channel separation is achieved by
adjusting V
AF1
(pin 8) and V
AF2
(pin 7) as follows:
1.
V
AF1
by a resistor in series with the DC decoupling
capacitor at pin 9
2.
V
AF2
by a variable resistor in series with the
DC decoupling capacitor on pin 10 to the same
voltage as V
AF1
.
Second sound carrier mute
The output of the second FM demodulator is muted when
the signal level (signal and/or noise) at pin 15 is less than
typically 0.5 mV (RMS value). This avoids an incorrect
stereo or dual sound identification when a mono signal is
transmitted. Therefore, with a mono transmission, there is
no audio output at pin 7. When the signal level at pin 15 is
greater than typically 1.0 mV (RMS value) mute is
switched off.
Control unit
The control unit selects the required sound standard
according to the voltages on pin 5 and pin 6. The control
unit performs the following:
1.
selects the free-running frequencies of VCO1 and
VCO2
2.
switches the source selector (the four possible
combinations are shown in Table 1).
Table 1
Logic table; note 1
Note
1.
In columns S1 and S2: 0 = LOW and 1 = HIGH.
STANDARD
S1
(PIN 5)
S2
(PIN 6)
FREQUENCY VCO1
(MHz)
FREQUENCY VCO2
(MHz)
SOURCE SELECTOR
CONNECTION
B/G
M
I
D/K
1
1
0
0
1
0
1
0
5.5
4.5
6.0
6.5
5.74
4.72
off
6.74
pin 1
pin 3
pin 16
pin 2
相關PDF資料 |
PDF描述 |
|---|---|
| TDA9820T | Multistandard/dual channel TV FM intercarrier sound demodulator |
| TDA9821 | dual channel TV FM intercarrier sound demodulator(雙頻道TV FM內載波音解調器) |
| TDA9830T | TV sound AM-demodulator and audio source switch |
| TDA9830 | TV sound AM-demodulator and audio source switch(電視聲音AM解調器和音頻源開關) |
| TDA9840T | DIODE 1SMC28AT3 TRANSZORB 1500W SMT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA9820T | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Multistandard/dual channel TV FM intercarrier sound demodulator |
| TDA9820T/V1,112 | 制造商:NXP Semiconductors 功能描述:MULTISTD TV FM SOUND DEMOD - Rail/Tube |
| TDA9821 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Dual channel TV FM intercarrier sound demodulator |
| TDA9829T | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Downconverter for DVB |
| TDA9830 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:TV sound AM-demodulator and audio source switch |
發布緊急采購，3分鐘左右您將得到回復。