參數資料
型號: TDA9812T
廠商: NXP SEMICONDUCTORS
元件分類: 接收器
英文描述: Multistandard VIF-PLL and FM-PLL/AM demodulator
中文描述: AUDIO/VIDEO DEMODULATOR, PDSO28
封裝: PLASTIC, SO-32
文件頁數: 17/32頁
文件大小: 272K
代理商: TDA9812T
1995 Mar 21
17
Philips Semiconductors
Preliminary specification
Multistandard VIF-PLL and
FM-PLL/AM demodulator
TDA9812
Notes
1.
2.
Values of video and sound parameters are decreased at V
P
= 4.5 V.
This parameter is not tested during production and is only given as application information for designing the television
receiver.
Loop bandwidth BL = 60 kHz (natural frequency f
n
= 15 kHz; damping factor d = 2; calculated with sync level within
gain control range). Resonance circuit of VCO: Q
0
> 50; C
ext
= 8.2 pF
±
0.25 pF; C
int
8.5 pF (loop voltage
approximately 2.7 V).
Temperature coefficient of external LC-circuit is equal to zero.
V
i IF
= 10 mV RMS;
f = 1 MHz (VCO frequency offset related to picture carrier frequency); white picture video
modulation.
V
i IF
signal for nominal video signal.
Offset current measured between pin 7 and half of supply voltage (V
P
= 2.5 V) under the following conditions: no
input signal at VIF input (pins 1 and 2) and VIF amplifier gain at minimum (V
28
= V
P
). Due to sample-and-hold mode
of the FPLL in L standard, the leakage current of the loop filter capacitor (C = 220 nF) should not exceed 500 nA.
Measurements taken with SAW filter G1962 (sound shelf: 20 dB); loop bandwidth BL = 60 kHz.
a) Modulation VSB; sound carrier OFF; f
video
> 0.5 MHz.
b) Sound carrier ON; SIF SAW filter L9453; f
video
= 10 kHz to 10 MHz.
The 7 dB buffer gain accounts for 1 dB loss in the sound trap. Buffer output signal is typical 2 V (p-p), in event of
CVBS video amplifier output typical 1 V (p-p). If no sound trap is applied a 330
resistor must be connected from
output to input (from pin 21 to pin 22).
10. The leakage current of the AGC capacitor should not exceed 1
μ
A at B/G standard respectively 10 nA current at
L standard. Larger currents will increase the tilt.
11. S/N is the ratio of black-to-white amplitude to the black level noise voltage (RMS value, pin 10). B = 5 MHz weighted
in accordance with “CCIR 567”
3.
4.
5.
6.
7.
8.
9.
Standard switch (pin 9);
see also Table 2
V
9
DC potential voltage for
preferred settings
input voltage for negative
standard
input voltage for negative
standard
input voltage for positive
standard
LOW level input current
B/G standard; note 25
2.8
V
P
V
negative AGC OFF
1.3
2.3
V
L standard
0
0.8
V
I
IL
V
9
= 0 V
190
250
310
μ
A
L/L accent switch (pin 11)
V
11
DC potential voltage for
L standard VCO frequency
switching
L standard
L/L accent standard and
alignment
LOW level input current
note 25
2.8
V
P
2.0
V
V
I
IL
V
11
= 0 V
150
200
250
μ
A
SYMBOL
PARAMETER
CONDITIONS
MIN.
TYP.
MAX.
UNIT
相關PDF資料
PDF描述
TDA9813T VIF-PLL with QSS-IF and dual FM-PLL demodulator(帶QSS-IF和雙路FM-PLL解調器的VIF-PLL)
TDA9814T Multistandard VIF-PLL with QSS-IF and dual FM-PLL/AM demodulator(帶QSS-IF和雙路FM-PLL/AM解調器的多標準VIF-PLL)
TDA9814 Multistandard VIF-PLL with QSS-IF and dual FM-PLL/AM demodulator
TDA9815 Multistandard/MAC VIF-PLL with QSS-IF and dual FM-PLL/AM demodulator(帶QSS-IF和雙路FM-PLL/AM解調器的多標準/媒體存取控制 VIF-PLL)
TDA9817 Single/Multistandard VIF/SIF-PLL and FM-PLL/AM demodulator(單一/多標準的VIF/SIF-PLL and FM-PLL/AM解調器)
相關代理商/技術參數
參數描述
TDA9813T 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:VIF-PLL with QSS-IF and dual FM-PLL demodulator
TDA9814 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Multistandard VIF-PLL with QSS-IF and dual FM-PLL/AM demodulator
TDA9814T 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Multistandard VIF-PLL with QSS-IF and dual FM-PLL/AM demodulator
TDA9815 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Multistandard/MAC VIF-PLL with QSS-IF and dual FM-PLL/AM demodulator
TDA9816M 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Multistandard multimedia IF-PLL and FM radio demodulator