- 您現在的位置：買賣IC網 > PDF目錄98203 > TDA8929T/N1,118 (NXP SEMICONDUCTORS) 2 CHANNEL, AUDIO AMPLIFIER, PDSO24 PDF資料下載
參數資料
| 型號： | TDA8929T/N1,118 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 2 CHANNEL, AUDIO AMPLIFIER, PDSO24 |
| 封裝： | PLASTIC, SO-24 |
| 文件頁數： | 2/36頁 |
| 文件大?。?/td> | 479K |
| 代理商： | TDA8929T/N1,118 |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
2001 Dec 11
10
Philips Semiconductors
Preliminary specication
Controller class-D audio amplier
TDA8929T
8.3.3
START-UP SAFETY TEST
During the start-up sequence, when pin MODE is switched
from standby to mute, the condition at the output terminals
of the power stage are checked. These are the same lines
as the feedback inputs of the controller. In the event of a
short-circuit of one of the output terminals to VDD or VSS
the start-up procedure is interrupted and the system waits
for non-shorted outputs. Because the test is done before
enabling the power stages, no large currents will flow in the
event of a short-circuit. This system protects against
short-circuits at both sides of the output filter to both supply
lines. When there is a short-circuit from the outputs of the
power stage to one of the supply lines, before the
demodulation filter, it will also be detected by the start-up
safety test. Practical use from this test feature can be
found in detection of short-circuits on the printed-circuit
board.
Remark: this test is only operational prior to or during the
start-up sequence, and not during normal operating.
8.4
Differential audio inputs
For a high common mode rejection and a maximum
flexibility of application, the audio inputs are fully
differential. By connecting the inputs anti-parallel the
phase of one of the channels is inverted, so that a load can
be connected between the two output filters. In this case
the system operates as a mono BTL amplifier (see Fig.5).
Also in the stereo single-ended configuration it is
recommended to connect the two differential inputs in
anti-phase. This has advantages for the current handling
of the power supply at low signal frequencies.
handbook, full pagewidth
MGW185
TDA8929T
REL1
SW1
EN1
EN2
SW2
OUT1
SGND
OUT2
REL2
IN1
+
Vi
IN1
IN2
+
IN2
CONTROLLER
POWER
STAGE
Fig.5 Mono BTL application.
相關PDF資料 |
PDF描述 |
|---|---|
| TDA8932TW | 25 W, 1 CHANNEL, AUDIO AMPLIFIER, PDSO32 |
| TDA8933BTW/N2,512 | 20.6 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO32 |
| TDA8942P/N1,112 | 1.5 W, 2 CHANNEL, AUDIO AMPLIFIER, PDIP16 |
| TDA8944AJ | 7 W, 2 CHANNEL, AUDIO AMPLIFIER, PZIP17 |
| TDA8946AJ | 15 W, 2 CHANNEL, AUDIO AMPLIFIER, PZIP17 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA8931 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Power comparator 1 X 20 W |
| TDA8931T | 功能描述:校驗器 IC 1 CHAN CLASS D AMP 1X15W RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel |
| TDA8931T/N1,112 | 功能描述:校驗器 IC 1 CHAN CLASS D AMPLIFIER 1X15W RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel |
| TDA8931T/N1,118 | 功能描述:校驗器 IC 1 CHAN CLASS D AMPLIFIER 1X15W RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel |
| TDA8931T-T | 功能描述:校驗器 IC 1 CHAN CLASS D AMP 1X15W RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。