參數資料
型號: TDA2030AH
廠商: STMICROELECTRONICS
元件分類: 音頻/視頻放大
英文描述: 18 W, 1 CHANNEL, AUDIO AMPLIFIER, PZFM5
封裝: PENTAWATT-5
文件頁數: 15/15頁
文件大?。?/td> 1403K
代理商: TDA2030AH
Figure 18 : Power Distribution versus Frequency
Both active and passive filters can be used for
crossovers but today active filters cost significantly
less than a good passive filter using air cored
inductors and non-electrolytic capacitors. In addi-
tion, active filters do not suffer from the typical
defects of passive filters:
- power less
- increased impedance seen by the loudspeaker
(lower damping)
- difficulty of precise design due to variable loud-
speaker impedance.
Obviously, active crossovers can only be used if a
power amplifier is provided for each drive unit. This
makes it particularly interesting and economically
sound to use monolithic power amplifiers.
In some applications, complex filters are not really
necessary and simple RC low-pass and high-pass
networks (6dB/octave) can be recommended.
The result obtained are excellent because this is
the best type of audio filter and the only one free
from phase and transient distortion.
The rather poor out of band attenuation of single
RC filters means that the loudspeaker must operate
linearly well beyond the crossover frequency to
avoid distortion.
Figure 19 : Active Power Filter
A more effective solution, named "Active Power
Filter" by SGS-THOMSON is shown in Figure 19.
The proposed circuit can realize combined power
amplifiers and 12dB/octave or 18dB/octave high-
pass or low-pass filters.
In practice, at the input pins of the amplifier two
equal and in-phase voltages are available, as re-
quired for the active filter operation.
The impedance at the pin (-) is of the order of 100
,
while that of the pin (+) is very high, which is also
what was wanted.
The component values calculated for fc = 900Hz
using a Bessek 3rd order Sallen and Key structure
are :
C1 = C2 = C3
R1
R2
R3
22nF
8.2k
5.6k
33k
Using this type of crossover filter, a complete 3-way
60W active loudspeaker system is shown in Fig-
ure 20.
It employs 2nd order Buttherworth filters with the
crossover frequencies equal to 300Hz and 3kHz.
The midrange section consists of two filters, a high
pass circuit followed by a low pass network. With
VS = 36V the output power delivered to the woofer
is 25W at d = 0.06% (30W at d = 0.5%).
The power delivered to the midrange and the
tweeter can be optimized in the design phase
taking in account the loudspeaker efficiency and
impedance (RL = 4
to 8).
It is quite common that midrange and tweeter
speakers have an efficiency 3dB higher than-
woofers.
TDA2030A
9/15
相關PDF資料
PDF描述
TDA2030AV 18 W, 1 CHANNEL, AUDIO AMPLIFIER, PZFM5
TDA2030H 18 W, 1 CHANNEL, AUDIO AMPLIFIER, PZFM5
TDA2030V 18 W, 1 CHANNEL, AUDIO AMPLIFIER, PZFM5
TDA2040V 22 W, 1 CHANNEL, AUDIO AMPLIFIER, PZFM5
TDA2052H 60 W, 1 CHANNEL, AUDIO AMPLIFIER, PZFM7
相關代理商/技術參數
參數描述
TDA2030AL-TA5-T 制造商:UTC-IC 制造商全稱:UTC-IC 功能描述:18W HI-FI AUDIO AMPLIFIER AND 35W DRIVER
TDA2030AL-TB5-T 制造商:UTC-IC 制造商全稱:UTC-IC 功能描述:18W HI-FI AUDIO AMPLIFIER AND 35W DRIVER
TDA2030A-TA5-T 制造商:UTC-IC 制造商全稱:UTC-IC 功能描述:18W HI-FI AUDIO AMPLIFIER AND 35W DRIVER
TDA2030A-TB5-T 制造商:UTC-IC 制造商全稱:UTC-IC 功能描述:18W HI-FI AUDIO AMPLIFIER AND 35W DRIVER
TDA2030AV 功能描述:音頻放大器 18W Hi-Fi Amplifier RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel