- 您現在的位置：買賣IC網 > PDF目錄373562 > TC164-JRI3IM (Electronic Theatre Controls, Inc.) CHIP RESISTORS ARRAY PDF資料下載
參數資料
| 型號： | TC164-JRI3IM |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | CHIP RESISTORS ARRAY |
| 中文描述： | 貼片電阻陣列 |
| 文件頁數： | 5/7頁 |
| 文件大?。?/td> | 296K |
| 代理商： | TC164-JRI3IM |
www.yageo.com
Mar. 24, 2004 V.4
Chip Resistor Surface Mount
5
7
SERIES
TC
164
TYPE
TEST METHOD
ACCEPTANCE STANDARD
Formula
Temperature
Coefficient of
Resistance
(T.C.R.)
Measure resistance at
+25°C or specified room
temperature as R
1
, then
measure at –55°C or
+155°C respectively as R
2
.
Determine the
temperature coefficient of
resistance from the
following formula:
T.C.R. = ------------------------- ×10
6
(ppm/°C)
Where
t
1
=+25°C or specified room temperature
t
2
=–55°C or +155°C test temperature
R
1
=resistance at reference temperature in ohms
R
2
=resistance at test temperature in ohms
Refer to table 2
Thermal
Shock
At –55±3°C for 2 minutes and at +155±2°C for 2 minutes as one cycle. After 5
cycles, the specimen shall be stabilized at room temp.
Measure the resistance to determine
Δ
R/R(%) after one more hour.
±(1.0%+0.05
)
Low
Temperature
Operation
Place the specimen in a test chamber maintained at –65 (+0/–5)°C. After one hour
stabilization at this temperature, full rated working voltage shall be applied for 45
(+5/–0) minutes. Have15 (+5/–0 ) minutes after remove the voltage, the specimen
shall be removed from the chamber and stabilized at room temperature for 24 hrs.
Measure the resistance to determine
Δ
R/R(%).
±(1.0%+0.05
)
No visible damage
Short
Time
Overload
Apply 2.5 times of rated voltage but not exceeding the maximum overload voltage
for 5 seconds. Have the specimen stabilized at room temperature for 30 minutes
minimum.
Measure the resistance to determine
Δ
R/R(%).
±(2.0%+0.05
)
No visible damage
Insulation
Resistance
Place the specimen in the jig and apply a rated
continues overload voltage (R.C.O.V) for one
minute as shown.
Measure the insulation resistance.
Type
TC164
Voltage (DC)
100V
≥
10,000M
Dielectric
Withstand
Voltage
Place the specimen in the jig and apply a
specified value continuous overload voltage as
shown for one minute.
Type
TC164
Voltage (AC)
100Vrms
Breakdown voltage>
specification and without
open/short
Resistance
To Soldering
Heat
Immerse the specimen in the solder pot at 260±5°C. for 10±1 seconds. Have the
specimen stabilized at room temperature for 30 minutes minimum.
Measure the resistance to determine
R/R(%).
Δ
±(1.0%+0.05
)
No visible damage
R
–R
R
1
(t
2
–t
1
)
相關PDF資料 |
PDF描述 |
|---|---|
| TC1900 | 30 KHz - 12 GHz MMIC |
| TC1N4742A | 1 Watt DO-41 Hermetically Sealed Glass Zener Voltage Regulators |
| TC1N4732A | 1 Watt DO-41 Hermetically Sealed Glass Zener Voltage Regulators |
| TC1N4733A | 1 Watt DO-41 Hermetically Sealed Glass Zener Voltage Regulators |
| TC1N4734A | 1 Watt DO-41 Hermetically Sealed Glass Zener Voltage Regulators |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TC164-JR-SKE12L | 制造商:Yageo Corporation 功能描述: |
| TC164-JR-SKE6L | 制造商:Yageo Corporation 功能描述: |
| TC1682 | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:Inverting Charge Pump Voltage Doublers with Active High Shutdown |
| TC1682_05 | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:Inverting Charge Pump Voltage Doublers with Active High Shutdown |
| TC1682EUA | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:Inverting Charge Pump Voltage Doublers with Active High Shutdown |
發布緊急采購，3分鐘左右您將得到回復。