- 您現在的位置：買賣IC網 > PDF目錄373529 > T5754 (Atmel Corp.) UHF ASK/FSK TRANSMITTER PDF資料下載
參數資料
| 型號： | T5754 |
| 廠商： | Atmel Corp. |
| 英文描述： | UHF ASK/FSK TRANSMITTER |
| 中文描述： | 超高頻ASK / FSK發射器 |
| 文件頁數： | 5/13頁 |
| 文件大小： | 215K |
| 代理商： | T5754 |
5
T5754
4511F–RKE–07/04
Output Matching and Power
Setting
The output power is set by the load impedance of the antenna. The maximum output
power is achieved with a load impedance of Z
Load,opt
= (166 + j223)
. There must be a
low resistive path to V
S
to deliver the DC current.
The delivered current pulse of the power amplifier is 9 mA and the maximum output
power is delivered to a resistive load of 465
if the 1.0 pF output capacitance of the
power amplifier is compensated by the load impedance.
An optimum load impedance of:
Z
Load
= 465
|| j/(2
× π
1.0 pF) = (166 + j223)
thus results for the maximum output
power of 7.5 dBm.
The load impedance is defined as the impedance seen from the T5754’s ANT1, ANT2
into the matching network. Do not confuse this large signal load impedance with a small
signal input impedance delivered as input characteristic of RF amplifiers and measured
from the application into the IC instead of from the IC into the application for a power
amplifier.
Less output power is achieved by lowering the real parallel part of 465
where the
parallel imaginary part should be kept constant.
Output power measurement can be done with the circuit of Figure 5. Note that the com-
ponent values must be changed to compensate the individual board parasitics until the
T5754 has the right load impedance Z
Load,opt
= (166 + j223)
. Also the damping of the
cable used to measure the output power must be calibrated out.
Figure 5.
Output Power Measurement
Application Circuit
For the supply-voltage blocking capacitor C
3
a value of 68 nF/X7R is recommended
(see Figure 6 on page 6 and Figure 7 on page 7). C
1
and C
2
are used to match the loop
antenna to the power amplifier where C
1
typically is 8.2 pF/NP0 and C
2
is 6 pF/NP0
(10 pF + 15 pF in series); for C
2
two capacitors in series should be used to achieve a
better tolerance value and to have the possibility to realize the Z
Load,opt
by using stan-
dard valued capacitors.
C
1
forms together with the pins of T5754 and the PCB board wires a series resonance
loop that suppresses the 1
st
harmonic, hence the position of C
1
on the PCB is important.
Normally the best suppression is achieved when C
1
is placed as close as possible to the
Pins ANT1 and ANT2.
The loop antenna should not exceed a width of 1.5 mm, otherwise the Q-factor of the
loop antenna is too high.
L
1
([50 nH to 100 nH) can be printed on PCB. C
4
should be selected that the XTO runs
on the load resonance frequency of the crystal. Normally, a value of 12 pF results for a
15 pF load-capacitance crystal.
~
~
ANT2
ANT1
R
in
50
Power
meter
C
1
= 1n
L
1
= 33n
C
2
= 2.2p
Z
Lopt
V
S
Z = 50
相關PDF資料 |
PDF描述 |
|---|---|
| T5754-6AQ | UHF ASK/FSK TRANSMITTER |
| T5760 | UHF ASK/FSK Receiver |
| T5760-TG | UHF ASK/FSK Receiver |
| T5761 | UHF ASK/FSK Receiver |
| T5761-TG | UHF ASK/FSK Receiver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| T5754_07 | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:UHF ASK/FSK Transmitter |
| T5754-6AP | 功能描述:IC TRANSMITTER 429-439MHZ 8TSSOP RoHS:否 類別:RF/IF 和 RFID >> RF 發射器 系列:- 標準包裝:4,000 系列:- 頻率:310MHz ~ 440MHz 應用:- 調制或協議:UHF，ASK 數據傳輸率 - 最大:20 kBaud 功率 - 輸出:1dBm ~ 5dBm 電流 - 傳輸:10mA 數據接口:PCB，表面貼裝 天線連接器:PCB，表面貼裝 存儲容量:- 特點:- 電源電壓:2.2 V ~ 4 V 工作溫度:-40°C ~ 85°C 封裝/外殼:16-LSSOP（0.154"，3.90mm 寬） 包裝:帶卷 (TR) |
| T5754-6APJ | 功能描述:射頻發射器 ASK/FSK Transmitter 429 - 439 MHz RoHS:否 制造商:Micrel 類型:ASK Transmitter 封裝 / 箱體:SOT-23-6 工作頻率:300 MHz to 450 MHz 封裝:Reel |
| T5754-6APJ 71 | 制造商:Atmel Corporation 功能描述: |
| T5754-6AQ | 功能描述:IC TX 429-439MHZ ASK/FSK 8TSSOP RoHS:否 類別:RF/IF 和 RFID >> RF 發射器 系列:- 標準包裝:4,000 系列:- 頻率:310MHz ~ 440MHz 應用:- 調制或協議:UHF，ASK 數據傳輸率 - 最大:20 kBaud 功率 - 輸出:1dBm ~ 5dBm 電流 - 傳輸:10mA 數據接口:PCB，表面貼裝 天線連接器:PCB，表面貼裝 存儲容量:- 特點:- 電源電壓:2.2 V ~ 4 V 工作溫度:-40°C ~ 85°C 封裝/外殼:16-LSSOP（0.154"，3.90mm 寬） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。