SY89610L
77.75MHz to 694MHz Jitter Attenuator and
Low Phase Noise Frequency Synthesizer
Precision Edge is a registered trademark of Micrel, Inc.
Micrel Inc. 2180 Fortune Drive San Jose, CA 95131 USA tel +1 (408) 944-0800 fax + 1 (408) 474-1000 http://www.micrel.com
July 2008
M9999-071008-D
hbwhelp@micrel.com or (408) 955-1690
General Description
The SY89610L is a 3.3V, fully differential jitter attenuator
and frequency synthesizer that accepts a noise clock
between 19.44MHz and 694MHz, depending on I/O
frequency selection. The output provides an ultra-low
jitter clock frequency between 77.75MHz and 694MHz
covering SONET/SDH, Gigabit Ethernet, Fibre Channel,
SAS, SATA, and many other communication standards.
The output jitter of the SY89610L is typically 1psRMS. It
has a 1kHz to 10kHz programmable loop bandwidth to
accommodate different jitter attenuation applications
and PLL requirements. The auto-tune circuit enables
precision frequency calibration.
The differential input includes Micrel’s unique, 3-pin
input termination architecture that interfaces to LVPECL,
LVDS or CML differential signals, (AC- or DC-coupled)
as small as 100mV without any level-shifting or
termination resistor networks in the signal path. For AC-
coupled input interface applications, an on-board output
reference voltage (VREF-AC) is provided to bias the VT pin.
The outputs are compatible with 400mV typical swing
into 50 loads, with rise/fall times guaranteed to be less
than 250ps.
The SY89610L operates at 3.3V ±10% supply and the
output can accommodate 1.8V to 3.3V operation with
the dedicated output supply. The part is guaranteed to
operate over the full industrial temperature range
(–40°C to +85°C). The SY89610L is part of Micrel’s
Precision Edge
product line.
Datasheets and support documentation can be found on
Micrel’s web site at: www.micrel.com.
Precision Edge
Features
Accepts high jitter input clock signal and attenuates
it to provide Ultra-Low Jitter and Phase Noise clock
signal at the output
Output Frequency Range: 77.75MHz – 694MHz
Input Frequency Range: 19.44MHz – 694MHz
Phase Noise and Jitter performance:
– <2psRMS Output Jitter Gen (12kHz-20MHz)
– Low Phase Noise: -80dBc/Hz at 1kHz offset
CML compatible output signal
3-pin input accepts an AC- or DC-coupled
differential input (LVDS, LVPECL, and CML)
Unique, Auto-Tune circuitry enables precision
frequency calibration
Internal source termination to minimize round-trip
reflections
Programmable Loop Bandwidth: 1kHz-10kHz
Output Enable/disable function
Only one external component needed for LC VCO
(a filter capacitor)
Includes Loss of Lock (LOL) output pin
Includes Auto-tune Circuit for precision frequency
calibration
1.8V ±5% to 3.3V ±10% output power supply
3.3V ±10% power supply operation
Industrial temperature range: –40°C to +85°C
Available in 32-pin (5mm x 5mm) QFN package
Applications
Covers telecom/datacom/storage standards:
SONET/SDH
GbE and 10GbE LAN PHY (w/FEC)
1/2/4/8G Fibre Channel
High-end routers and switches
Telecom transmission equipment
High speed optical modules
Long haul transport