- 您現在的位置：買賣IC網 > PDF目錄2018 > SY87700ALZG TR (Micrel Inc)IC CLOCK/DATA RECOVERY 28-SOIC PDF資料下載
參數資料
| 型號： | SY87700ALZG TR |
| 廠商： | Micrel Inc |
| 文件頁數： | 16/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC CLOCK/DATA RECOVERY 28-SOIC |
| 標準包裝： | 1,000 |
| 系列： | AnyRate® |
| 類型： | 時鐘和數據恢復（CDR），多路復用器 |
| PLL： | 是 |
| 主要目的： | 以太網，SONET/SDH，ATM 應用 |
| 輸入： | PECL |
| 輸出： | PECL |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 1:3 |
| 差分 - 輸入:輸出： | 是/是 |
| 頻率 - 最大： | 208Mbps |
| 電源電壓： | 3.15 V ~ 3.45 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-SOIC（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 28-SOIC |
| 包裝： | 帶卷 (TR) |
| 其它名稱： | SY87700ALZGTR SY87700ALZGTR-ND |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁
2011 Microchip Technology Inc.
DS25010C-page 9
MCP7940N
FIGURE 4-2:
ACKNOWLEDGE TIMING
4.1.2
DEVICE ADDRESSING AND OPERATION
A control byte is the first byte received following the
Start condition from the master device (Figure 4-2).
The control byte for accessing the SRAM and RTCC
registers are set to ‘1101111’. The RTCC registers and
the SRAM share the same address space.
The last bit of the control byte defines the operation to
be performed. When set to a ‘1’ a read operation is
selected, and when set to a ‘0’ a write operation is
selected. The next byte received defines the address of
the data byte (Figure 4-3). The upper address bits are
transferred first, followed by the Least Significant bits
(LSb).
Following the Start condition, the MCP7940N monitors
the SDA bus, checking the device type identifier being
transmitted. Upon receiving an ‘1101111’ code, the
slave device outputs an Acknowledge signal on the
SDA line. Depending on the state of the R/W bit, the
MCP7940N will select a read or write operation.
FIGURE 4-3:
ADDRESS SEQUENCE BIT ASSIGNMENTS
SCL
9
8
7
6
5
4
3
2
11
2
3
Transmitter must release the SDA line at this point
allowing the Receiver to pull the SDA line low to
acknowledge the previous eight bits of data.
Receiver must release the SDA line at this point
so the Transmitter can continue sending data.
Data from transmitter
SDA
Acknowledge
Bit
1
101
R/W
X
A
0
SRAM RTCC CONTROL BYTE
ADDRESS BYTE
CONTROL
CODE
111
X = Don’t Care
相關PDF資料 |
PDF描述 |
|---|---|
| SY87700LZI | IC CLOCK/DATA RECOVERY 28-SOIC |
| SY87700VHC | IC CLOCK/DATA RECOVERY 32-TQFP |
| SY87701ALZG | IC CLOCK/DATA RECOVERY 28-SOIC |
| SY87701LZI | IC CLOCK/DATA RECOVERY 28-SOIC |
| SY87701VZC | IC CLOCK/DATA RECOVERY 28-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SY87700L | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:3.3V 32-175Mbps AnyRate CLOCK AND DATA RECOVERY |
| SY87700L_06 | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:3.3V 32-175Mbps AnyRate CLOCK AND DATA RECOVERY |
| SY87700LHG | 功能描述:計時器和支持產品 3.3V 32Mbps-175Mbps CDR (I Temp, Green/32 pin TQFP/bulk) RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel |
| SY87700LHG TR | 功能描述:計時器和支持產品 3.3V 32Mbps-175Mbps CDR (I Temp, Green/32 pin TQFP/T+R) RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel |
| SY87700LHGTR | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:3.3V 32-175Mbps AnyRate CLOCK AND DATA RECOVERY Use lower-power SY87700AL for new designs |
發布緊急采購，3分鐘左右您將得到回復。