- 您現在的位置：買賣IC網 > PDF目錄385892 > SY87700AL (Micrel Semiconductor,Inc.) Low-Power, 3.3V, 32Mbps to 208Mbps AnyRate Clock and Data Recovery PDF資料下載
參數資料
| 型號： | SY87700AL |
| 廠商： | Micrel Semiconductor,Inc. |
| 英文描述： | Low-Power, 3.3V, 32Mbps to 208Mbps AnyRate Clock and Data Recovery |
| 中文描述： | 低功耗，3.3，32Mbps到208Mbps AnyRate時鐘和數據恢復 |
| 文件頁數： | 13/16頁 |
| 文件大?。?/td> | 643K |
| 代理商： | SY87700AL |
Micrel, Inc.
SY87700AL
Appendix A
Layout and General Suggestions
November 2006
13
M9999-111406-B
hbwhelp@micrel.com
or (408) 955-1690
1. Establish controlled impedance stripline, microstrip, or
coplanar construction techniques.
2. Signal paths should have approximately the same width
as the device pads.
3. All differential paths are critical timing paths, where
skew should be matched to within ±10ps.
4. Signal trace impedance should not vary more than
±5%. If in doubt, perform TDR analysis of all high-speed
signal traces.
5. Maintain compact filter networks as close to filter pins
as possible. Provide ground plane relief under filter path
to reduce stray capacitance. Be careful of crosstalk
coupling into the filter network.
6. Maintain low jitter on the REFCLK input. Isolate the
XTAL oscillator from power supply noise by adequately
decoupling. Keep XTAL oscillator close to device, and
minimize capacitive coupling from adjacent signals.
7. Higher speed operation may require use of
fundamental-tone (third-overtone typically has more
jitter) crystal-based oscillator for optimum performance.
Evaluate and compare candidates by measuring
TXCLK jitter.
8. All unused outputs must be terminated. To conserve
power, unused PECL outputs can be terminated with a
1k
resistor to V
EE
.
相關PDF資料 |
PDF描述 |
|---|---|
| SY87700ALHG | Low-Power, 3.3V, 32Mbps to 208Mbps AnyRate Clock and Data Recovery |
| SY87700ALZG | Low-Power, 3.3V, 32Mbps to 208Mbps AnyRate Clock and Data Recovery |
| SY87700LHG | 3.3V 32-175Mbps AnyRate CLOCK AND DATA RECOVERY |
| SY87700LHGTR | 3.3V 32-175Mbps AnyRate CLOCK AND DATA RECOVERY |
| SY87700LHITR | 3.3V 32-175Mbps AnyRate CLOCK AND DATA RECOVERY |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SY87700AL_09 | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:Low-Power, 3.3V, 32Mbps to 208Mbps AnyRate Clock and Data Recovery |
| SY87700ALHG | 功能描述:計時器和支持產品 3.3V 32Mbps-175 Mbps CDR (I Temp, Green/32 pin TQFP/bulk) RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel |
| SY87700ALHG TR | 功能描述:計時器和支持產品 3.3V 32Mbps-175Mbps CDR (I Temp, Green/32 pin TQFP/T+R) RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel |
| SY87700ALZG | 功能描述:計時器和支持產品 3.3V 32Mbps-175Mbps CDR (I Temp, Green/28 pin SOIC/bulk) RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel |
| SY87700ALZG TR | 功能描述:計時器和支持產品 3.3V 32Mbps-175Mbps CDR (I Temp, Green/28 pin SOIC/T+R) RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。