- 您現在的位置：買賣IC網 > PDF目錄374950 > SVFD1D226M (NEC Corp.) Surface mount resin molded chip with Built-in fuse, Low blow-out current 2A PDF資料下載
參數資料
| 型號： | SVFD1D226M |
| 廠商： | NEC Corp. |
| 英文描述： | Surface mount resin molded chip with Built-in fuse, Low blow-out current 2A |
| 中文描述： | 表面貼裝模壓內置保險絲芯片樹脂，低擊出電流2A |
| 文件頁數： | 12/16頁 |
| 文件大?。?/td> | 142K |
| 代理商： | SVFD1D226M |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁
12
SV/F SERIES
DATA SHEET EC0003EJ3V1DS00
2. Built-in-fuse characteristics
The briefing of the built-in-fuse characteristics is that:
(1) Fuse may not work under some environmental conditions.
(2) When the built fuse blows, slight smoking may occur.
(3) Fuse blowout data is as shown on page 10.
(4) The ESR (equivalent series resistance) is larger than the conventional tantalum capacitor by the built-in-
fuse resistance.
Taking notice the above, refer to the following in detail for reliable circuit design.
3. Series resistance
As shown in Figure 1, reliability is increased by inserting a series resistance of at least 3
/V into circuits
where current flow is momentary (switching circuits, charge/discharge circuits, etc).
If the capacitor is in a low-impedance circuit, the voltage applied to the capacitor should be less than 1/2 to
1/3 of the DC rated voltage.
4. Ripple voltage
The sum of DC voltage and peak ripple voltage should not exceed the rated DC rated voltage of the capacitor.
0.1
1
Frequency (kHz)
Figure 2 Permissible ripple voltage vs. frequency
10
0.1
1
10
R
100
100
35 V
25 V
20 V
16 V
10 V
Case : B2, @ 25
C
0.1
1
Frequency (kHz)
10
0.1
1
10
R
100
100
50 V
35 V
25 V
Case : C, D2,D
@ 25
C
10 V
Figure 2 is based on an ambient temperature of 25
C. For higher temperature, permissible ripple voltage shall
be derated as follows.
Permissible voltage at 50
C = 0.7
×
permissible voltage at 25
C
Permissible voltage at 85
C = 0.5
×
permissible voltage at 25
C
Permissible voltage at 125
C = 0.3
×
permissible voltage at 25
C
10
1
M
0.1
0.1
1
Series Resistance (
/V)
Figure 1 Effects of series resistance
10
100
相關PDF資料 |
PDF描述 |
|---|---|
| SVFD1E106M | Surface mount resin molded chip with Built-in fuse, Low blow-out current 2A |
| SVG-2066 | 500MHz - 2200MHz 6-Bit Variable Gain Amp |
| SVG-2066Z | 500MHz - 2200MHz 6-Bit Variable Gain Amp |
| SVHB21A105K | SURFACE MOUNT RESIN MOLDED TANTALUM CHIP CAPACITORS HIGH RELIABILITY |
| SVHD21D156M | SURFACE MOUNT RESIN MOLDED TANTALUM CHIP CAPACITORS HIGH RELIABILITY |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SVG-100A483AAT | 制造商:CALIBER 制造商全稱:Caliber Electronics Inc. 功能描述:14 Pin and 6 Pin / SMD / HCMOS / VCXO Oscillator |
| SVG-100A483ABT | 制造商:CALIBER 制造商全稱:Caliber Electronics Inc. 功能描述:14 Pin and 6 Pin / SMD / HCMOS / VCXO Oscillator |
| SVG-100A483ACT | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:14 Pin and 6 Pin / SMD / HCMOS / VCXO Oscillator |
| SVG-100A483ADT | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:14 Pin and 6 Pin / SMD / HCMOS / VCXO Oscillator |
| SVG-100A483AT | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:14 Pin and 6 Pin / SMD / HCMOS / VCXO Oscillator |
發布緊急采購，3分鐘左右您將得到回復。