參數資料
型號: STCN75M2E
廠商: 意法半導體
元件分類: 溫度/濕度傳感器
英文描述: Digital temperature sensor and thermal watchdog
中文描述: 數字溫度傳感器和熱看門狗
文件頁數: 19/35頁
文件大?。?/td> 194K
代理商: STCN75M2E
STCN75
Functional description
19/35
3.3
Serial interface
Writing to and reading from the STCN75 registers is accomplished via the two-wire serial
interface protocol which requires that one device on the bus initiates and controls all READ
and WRITE operations. This device is called the “master” device. The master device also
generates the SCL signal which provides the clock signal for all other devices on the bus.
These other devices on the bus are called “slave” devices. The STCN75 is a slave device
(see
Table 9
). Both the master and slave devices can send and receive data on the bus.
During operations, one data bit is transmitted per clock cycle. All operations follow a
repeating, nine-clock-cycle pattern that consists of eight bits (one byte) of transmitted data
followed by an acknowledge (ACK) or not acknowledge (NACK) from the receiving device.
Note:
There are no unused clock cycles during any operation, so there must not be any breaks in
the data stream and ACKs/NACKs during data transfers. Consequently, having too few clock
cycles can lead to incorrect operation if an inadvertent 8-bit READ from a 16-bit register
occurs. So, the entire word must be transferred out regardless of the superflous trailing
zeroes.
Table 9.
3.4
2-wire bus characteristics
The bus is intended for communication between different ICs. It consists of two lines: a bi-
directional data signal (SDA) and a clock signal (SCL). Both the SDA and SCL lines must be
connected to a positive supply voltage via a pull-up resistor.
The following protocol has been defined:
Data transfer may be initiated only when the bus is not busy.
During data transfer, the data line must remain stable whenever the clock line is High.
Changes in the data line, while the clock line is High, will be interpreted as control
signals.
Accordingly, the following bus conditions have been defined (see
Figure 5 on page 20
):
3.4.1
Bus not busy
Both data and clock lines remain High.
3.4.2
Start data transfer
A change in the state of the data line, from high to Low, while the clock is High, defines the
START condition.
3.4.3
Stop data transfer
A change in the state of the data line, from Low to High, while the clock is High, defines the
STOP condition.
STCN75 serial bus slave addresses
MSB
LSB
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
1
0
0
1
A2
A1
A0
R/W
相關PDF資料
PDF描述
STCN75M2F Digital temperature sensor and thermal watchdog
STCS1 1.5 A max constant current LED driver
STCS1PHR 1.5 A max constant current LED driver
STCS1PUR 1.5 A max constant current LED driver
STD100NH02L-1 N-channel 24V - 0.0042ohm - 60A - DPAK - IPAK STripFET TM II Power MOSFET
相關代理商/技術參數
參數描述
STCN75M2F 功能描述:板上安裝溫度傳感器 Digital Temp Snsr Thermal Watchdog RoHS:否 制造商:Omron Electronics 輸出類型:Digital 配置: 準確性:+/- 1.5 C, +/- 3 C 溫度閾值: 數字輸出 - 總線接口:2-Wire, I2C, SMBus 電源電壓-最大:5.5 V 電源電壓-最小:4.5 V 最大工作溫度:+ 50 C 最小工作溫度:0 C 關閉: 安裝風格: 封裝 / 箱體: 設備功能:Temperature and Humidity Sensor
ST-COAX-REMOTES 制造商:Black Box Corporation 功能描述:SOHOTEST Replacement Coax Remotes, #1 5
STCOMPATABLEFIBREOPTICCONN 制造商:3M Electronic Products Division 功能描述:ST(R) II compatible fibre connector plug
ST-COVER 功能描述:熔絲座 FUSE COVER ASSEMBLY RoHS:否 制造商:Littelfuse 產品: 電流額定值:30 A 電壓額定值:1000 VDC 極數:1 系列: 安裝風格:DIN Rail 端接類型: 軸類型: 工作溫度范圍:
STCP0E65FF 制造商:Sola/Hevi-Duty 功能描述:Surge Suppressor; Data Line CAT 5/6 Ethernet TVSS FEM-FEM 制造商:Sola/Hevi-Duty 功能描述:DATA LINE SURGE SUPPRESSOR; Series:STC-PoE; Suppressor Type:Data Line / Mains; No. of Outlets:1; Outlet Type:RJ45; Voltage Rating:60VDC; Output Current:300mA; Response Time:1ns; Connector Type:RJ45; Connector Type A:RJ45 Jack ;RoHS Compliant: Yes