參數資料
    型號: ST62E18CF1
    英文描述: 8-BIT MICROCONTROLLER ( MCU ) WITH OTP. ROM. FASTROM. A/D CONVERTER. 8-BIT AUTO-RELOAD TIMER. UART. OSG. SAFE RESET AND 20 PINS
    中文描述: 8位微控制器(MCU)的與檢察官辦公室。光盤。 FASTROM。的A / D轉換器。 8位自動重加載定時器。 UART的。業務支助。安全復位和20圖釘
    文件頁數: 7/82頁
    文件大?。?/td> 870K
    代理商: ST62E18CF1
    7/82
    ST62T18C/E18C
    1.2 PIN DESCRIPTIONS
    V
    and V
    . Power is supplied to the MCU via
    these two pins. V
    is the power connection and
    V
    SS
    is the ground connection.
    OSCin and OSCout.
    These pins are internally
    connected to the on-chip oscillator circuit. A quartz
    crystal, a ceramic resonator or an external clock
    signal can be connected between these two pins.
    The OSCin pin is the input pin, the OSCout pin is
    the output pin.
    RESET
    . The active-low RESET pin is used to re-
    start the microcontroller.
    TEST/V
    .
    The TEST must be held at V
    for nor-
    mal operation. If TEST pin is connected to a
    +12.5V level during the reset phase, the EPROM/
    OTP programming Mode is entered.
    NMI.
    The NMI pin provides the capability for asyn-
    chronous interruption, by applying an external non
    maskable interrupt to the MCU. Schmitt trigger
    characteristics. The user can select as option the
    availability of an on-chip pull-up at this pin.
    PA1-PA5.
    These 5 lines are organised as one I/O
    port (A). Each line may be configured under soft-
    ware control as inputs with or without internal pull-
    up resistors, input with interrupt generation and
    pull-up resistor, open-drain or push-pull outputs.
    PA3/ARTIMout and PA4/ARTIMin can be used re-
    spectively as output and input pins for the embed-
    ded 8-bit Auto-Reload Timer.
    In addition,
    PA1-PA5
    can sink 20mA for direct LED
    or TRIAC drive.
    PB4...PB6.
    These 3 lines are organised as one I/O
    port (B). Each line may be configured under soft-
    ware control as inputs with or without internal pull-
    up resistors, input with interrupt generation and
    pull-up resistor, open-drain or push-pull outputs,
    analog inputs for the A/D converter.
    PD4...PD7
    . These 4 lines are organised as one I/O
    port (portD). Each line may be configured under
    software control as input with or without internal
    pull-up resistor, input with interrupt generation and
    pull-up resistor, analog input open-drain or push-
    pull output. In addition, the pins PD5/TXD1 and
    PD4/RXD1 can be used as UART output (PD5/
    TXD1) or UART input (PD4/RXD1).
    TIMER
    . This is the TIMER 1 I/O pin. In input mode,
    it is connected to the prescaler and acts as ex-
    ternal timer clock or as control gate for the internal
    timer clock. In output mode, the TIMER pin outputs
    the data bit when a time-out occurs.The user can
    select as option the availability of an on-chip pull-
    up at this pin.
    7
    相關PDF資料
    PDF描述
    ST62E20BF1 8-BIT MICROCONTROLLER
    ST62E25BF1 8-BIT MICROCONTROLLER
    ST62E94F1 IC PSRAM 32MB 54-VFBGA
    ST62P18CB1 8-BIT MICROCONTROLLER ( MCU ) WITH OTP. ROM. FASTROM. A/D CONVERTER. 8-BIT AUTO-RELOAD TIMER. UART. OSG. SAFE RESET AND 20 PINS
    ST62P18CB3 8-BIT MICROCONTROLLER ( MCU ) WITH OTP. ROM. FASTROM. A/D CONVERTER. 8-BIT AUTO-RELOAD TIMER. UART. OSG. SAFE RESET AND 20 PINS
    相關代理商/技術參數
    參數描述
    ST62E18CG1 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microcontroller
    ST62E20 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:GANG PROGRAMMERS FOR ST62 MCU FAMILY
    ST62E20BB1/EPROM 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT MCUs WITH A/D CONVERTER, TWO TIMERS, OSCILLATOR SAFEGUARD & SAFE RESET
    ST62E20BB3/EPROM 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT MCUs WITH A/D CONVERTER, TWO TIMERS, OSCILLATOR SAFEGUARD & SAFE RESET
    ST62E20BB6/EPROM 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT MCUs WITH A/D CONVERTER, TWO TIMERS, OSCILLATOR SAFEGUARD & SAFE RESET