- 您現在的位置：買賣IC網 > PDF目錄385861 > SSM2304CPZ-REEL7 (ANALOG DEVICES INC) Single Audio Amplifier PDF資料下載
參數資料
| 型號： | SSM2304CPZ-REEL7 |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | Single Audio Amplifier |
| 中文描述： | 1.8 W, 2 CHANNEL, AUDIO AMPLIFIER, QCC16 |
| 封裝： | 3 X 3 MM, LEAD FREE, MO-220VEED-2, LFCSP-16 |
| 文件頁數： | 12/19頁 |
| 文件大?。?/td> | 362K |
| 代理商： | SSM2304CPZ-REEL7 |
SSM2304
Preliminary Technical Data
APPLICATION NOTES
OVERVIEW
The SSM2304 stereo Class-D audio amplifier features a filterless
modulation scheme that greatly reduces the external components
count, conserving board space and thus reducing systems cost.
The SSM2304 does not require an output filter, but instead relies
on the inherent inductance of the speaker coil and the natural
filtering of the speaker and human ear to fully recover the audio
component of the square-wave output. While most Class-D ampli-
fiers use some variation of pulse-width modulation (PWM), the
SSM2304 uses a Σ-Δ modulation to determine the switching
pattern of the output devices. This provides a number of important
benefits. Σ-Δ modulators do not produces a sharp peak with
many harmonics in the AM frequency band, as pulse-width
modulators often do. Σ-Δ modulation provides the benefits of
reducing the amplitude of spectral components at high frequencies;
that is, reducing EMI emission that might otherwise be radiated
by speakers and long cable traces. The SSM2304 also offers
protection circuits for overcurrent and temperature protection.
GAIN SELECTION
The SSM2304 has a pair of internal resistors which set a 18dB of
default gain of the amplifier.
It is possible to adjust the SSM2304 gain by using external resistors
at the input. To set a gain lower than 18 dB refer to
Error!
Reference source not found.
for differential input
configuration and
Error! Reference source not found.
for
single-ended configuration. The external gain configuration is
calculated as
External Gain Settings
= 300k/(37.5k+Rext)
The gain pin is not connected internally, therefore its external
connection is not required.
POP-AND-CLICK SUPPRESSION
Voltage transients at the output of audio amplifiers can occur when
shutdown is activated or deactivated. Voltage transients as low
as 10 mV can be heard as an audio pop in the speaker. Clicks
and pops can also be classified as undesirable audible transients
generated by the amplifier system, therefore as not coming from
the system input signal. Such transients can be generated when
the amplifier system changes its operating mode. For example, the
following can be sources of audible transients: system power-up/
power-down, mute/unmute, input source change, and sample rate
change. The SSM2304 has a pop-and-click suppression architecture
that reduces this output transients, resulting in noiseless activation
and deactivation.
EMI NOISE
The SSM2304 uses a proprietary modulation and spread-
spectrum technology to minimize EMI emissions from the
device. Figure 28 shows SSM2304 EMI emission starting from
100 kHz to 30 MHz. Figure 29 shows SSM2304 EMI emission
from 30 kHz to 2 GHz. These figures clearly describe the SSM2304
EMI behavior as being well below the FCC regulation values,
starting from 100 kHz and passing beyond 1 GHz of frequency.
Although the overall EMI noise floor is slightly higher, frequency
spurs from the SSM2304 are greatly reduced.
70
0
0.1
100
FREQUENCY (MHz)
L
60
50
40
30
20
10
1
10
= HORIZONTAL
= VERTICAL
= REGULATION VALUE
0
Figure 28. EMI Emissions from SSM2304
70
0
10
10k
FREQUENCY (MHz)
L
60
50
40
30
20
10
100
1k
= HORIZONTAL
= VERTICAL
= REGULATION VALUE
0
Figure 29. EMI Emissions from SSM2304
The measurements for Figure 28 and Figure 29 were taken with
a 1 kHz input signal, producing 0.5 W output power into an 8 Ω
load from a 3.6 V supply. Cable length was approximately 5 cm.
The EMI was detected using a magnetic probe touching the 2”
output trace to the load.
相關PDF資料 |
PDF描述 |
|---|---|
| SSOP-A54 | SSOP-A54 |
| SSTU32865 | 1.8 V 28-bit 1:2 registered buffer with parity for DDR2 RDIMM |
| SSTU32865EG | Linear Voltage Regulator IC; Leaded Process Compatible:No; Peak Reflow Compatible (260 C):No |
| SSTUA32864 | Linear Voltage Regulator IC; Package/Case:8-MSOP; Current Rating:250mA; Leaded Process Compatible:No; Output Voltage Max:1.8V; Peak Reflow Compatible (260 C):No; Reel Quantity:2500; Voltage Regulator Type:Low Dropout (LDO) |
| SSTUA32864EC | Linear Voltage Regulator IC; Package/Case:8-MSOP; Current Rating:250mA; Leaded Process Compatible:No; Output Voltage Max:2.5V; Peak Reflow Compatible (260 C):No; Reel Quantity:2500; Voltage Regulator Type:Low Dropout (LDO) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SSM2304N | 制造商:SSC 制造商全稱:Silicon Standard Corp. 功能描述:N-CHANNEL ENHANCEMENT-MODE POWER MOSFET |
| SSM2304Z-EVAL | 功能描述:EVAL BOARD FOR SSM2304Z RoHS:否 類別:編程器，開發系統 >> 評估板 - 音頻放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
| SSM2305 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Filterless High Efficiency Mono 2.8 W Class-D Audio Amplifier |
| SSM2305AGN | 制造商:SSC 制造商全稱:Silicon Standard Corp. 功能描述:P-channel Enhancement-mode Power MOSFET |
| SSM2305CPZ-R2 | 功能描述:IC AMP AUDIO 2.8W MONO D 8LFCSP RoHS:是 類別:集成電路 (IC) >> 線性 - 音頻放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:DirectDrive® 類型:D 類 輸出類型:1-通道（單聲道），帶立體聲耳機 在某負載時最大輸出功率 x 通道數量:930mW x 1 @ 8 歐姆; 40mW x 2 @ 16 歐姆 電源電壓:2.7 V ~ 5.5 V 特點:消除爆音，差分輸入，I²C，靜音，關閉，音量控制 安裝類型:表面貼裝 供應商設備封裝:25-WLP（2.09x2.09） 封裝/外殼:25-WFBGA，WLCSP 包裝:帶卷 (TR) 其它名稱:MAX97000EWA+T-ND |
發布緊急采購，3分鐘左右您將得到回復。