- 您現在的位置：買賣IC網 > PDF目錄385859 > SPX2946U3-3.3 500mA Low Drop Out Voltage Regulator with Shutdown PDF資料下載
參數資料
| 型號： | SPX2946U3-3.3 |
| 英文描述： | 500mA Low Drop Out Voltage Regulator with Shutdown |
| 中文描述： | 500mA的低壓差與關斷穩壓器 |
| 文件頁數： | 4/11頁 |
| 文件大?。?/td> | 101K |
| 代理商： | SPX2946U3-3.3 |
4
Rev. B Date:01/20/04
SPX2945 400mA Low Dropout Voltage Regulator with Shutdown
Copyright 2004 Sipex Corporation
SPX2945 - 5.0V BLOCK DIAGRAM
FEEDBACK
INPUT
OUTPUT
UNREGULATED DC
SHUTDOWN
GROUND
ERROR
______
5V TAP
SENSE
5V at 400mA
MAX
TO CMOS OR
TTL
REFERENCE
ERROR DETECTION
COMPARATOR
ERROR
AMPLIFIER
1.23V
FROM
CMOS OR
TTL
+
+
_
+
+
+
+
60 mV
3
7
8
1
2
6
5
4
.
60k
330k
180k
.
.
1
μ
F
_
External Capacitors
The stability of the SPX2945 requires a 2.2
μ
F or
greater capacitor between output and ground.
Oscillation could occur without this capacitor.
Most types of tantalum or aluminum electrolytic
works fine here. For operations of below -25
°
C
solid tantalum is recommended since the many
aluminum types have electrolytes that freeze at
about -30
°
C. The ESR of about 5
or less and
resonant frequency above 500kHz are the most
important parameters in the value of the capaci-
tor. The capacitor value can be increased with-
out limit.
At lower values of output current, less output
capacitance is required for stability. For the
currents below 10mA the value of the capacitor
can be reduced to 0.5
μ
F and 0.15
μ
F for 1mA.
More output capacitance needed for the 8-pin
version at voltages below 5V since it runs the
error amplifier at lower gain. At worst case
4.7
μ
F or greater must be used for the condition
of 250mA load at 1.23V output.
The SPX2945, unlike other low dropout regu-
lators will remain stable and in regulation with
no load in addition to the internal voltage di-
vider. This feature is especially important in
applications like CMOS RAM keep-alive.
If there is more than 10 inches of wire between
the input and the AC filter capacitor, or if a
battery is used as the input, then a 0.1
μ
F tanta-
lum or aluminum electrolytic capacitor should
be placed from the input to the ground.
Instability can occur if there is stray capaci-
tance to the SPX2945 feedback terminal (pin 7).
This could cause more problems when using a
higher value of external resistors to set the
output voltage.
This problem can be fixed by adding a 100pF
capacitor between output and feedback and
increasing the output capacitor to at least 3.3
μ
F.
APPLICATION INFORMATION
相關PDF資料 |
PDF描述 |
|---|---|
| SPX2946U3-5.0 | 500mA Low Drop Out Voltage Regulator with Shutdown |
| SPX2946U5-3.3 | 500mA Low Drop Out Voltage Regulator with Shutdown |
| SPX2946U5-5.0 | 500mA Low Drop Out Voltage Regulator with Shutdown |
| SPX2946T3-5.0 | 500mA Low Drop Out Voltage Regulator with Shutdown |
| SPX2946T5-3.3 | 500mA Low Drop Out Voltage Regulator with Shutdown |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SPX2946U3-5.0 | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:500mA Low Drop Out Voltage Regulator with Shutdown |
| SPX2946U5-3.3 | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:500mA Low Drop Out Voltage Regulator with Shutdown |
| SPX2946U5-5.0 | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:500mA Low Drop Out Voltage Regulator with Shutdown |
| SPX2947S | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:500mA Low Drop Out Voltage Regulator with Shutdown |
| SPX2947T3 | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:500mA Low Drop Out Voltage Regulator with Shutdown |
發布緊急采購，3分鐘左右您將得到回復。