- 您現在的位置：買賣IC網 > PDF目錄372216 > SPX116S-3.3 Low Dropout Voltage Three Terminal Regulator PDF資料下載
參數資料
| 型號： | SPX116S-3.3 |
| 英文描述： | Low Dropout Voltage Three Terminal Regulator |
| 中文描述： | 低壓差三端穩壓器 |
| 文件頁數： | 5/6頁 |
| 文件大?。?/td> | 95K |
| 代理商： | SPX116S-3.3 |
SPX116
Rev. 8/21/01
SPX116 Low Dropout Voltage Three Terminal Regulator
Copyright 2001 Sipex Corporation
4
APPLICATION INFORMATION
The SPX116 requires an output capacitor for device stability.
The value required varies greatly depending upon the
application circuit and other factors. The high frequency
characteristics of electrolytic capacitors depend greatly on the
type and also on the manufacturer. Sometimes only bench
testing is the only means to determine the proper capacitor
type and value. Stability can be obtained with a tantalum or
ceramic capacitor value of 4.7
μ
F or greater.
Another critical point of electrolytic characteristics is its
performance over temperature. The SPX116 is designed to
operate starting at -40
°
C which may not be true in the case of
electrolytic. Higher temperatures generally no problem. The
electrolytic. type in aluminum will freeze around -30
°
C. This
could cause an oscillation at output of regulator. At a lower
temperature requirement by many applications the capacitor
should maintain its performance. So as a result, for an
application which regulator junction temperature does not
exceed 25
°
C, the output capacitor can be reduced by the
factor of two over the value needed for the entire
temperature range.
In most applications the SPX116 is operating at few
milliamps. In these applications the output capacitance can
be further reduced. For example, when the regulator is
running at 10mA output current the output capacitance
value is half compared to the same regulator that is running
at 100mA. The value decreases with higher output voltages,
since the internal loop gain is reduced.
The worst case occurs at the lower temperature and
maximum operating currents, the entire circuit and the
electrolytic, should be cooled down to the minimum
temperature. The minimum of 0.6 volts required at the input
of regulator above the output to keep the power dissipation
and die heating to its minimum. After the value for the
capacitor has been determined for actual use, the value
should be doubled.
相關PDF資料 |
PDF描述 |
|---|---|
| SPX116S-3.5 | Low Dropout Voltage Three Terminal Regulator |
| SPX116M1 | Low Dropout Voltage Three Terminal Regulator |
| SPX116N-3.0 | Low Dropout Voltage Three Terminal Regulator |
| SPX116N-3.3 | Low Dropout Voltage Three Terminal Regulator |
| SPX116N-3.5 | Low Dropout Voltage Three Terminal Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SPX1187-003 | 制造商:Honeywell Sensing and Control 功能描述: |
| SPX1189002 | 制造商:HONEYWELL 功能描述:Infrared Sensors 制造商:Honeywell Sensing and Control 功能描述:Infrared Sensors |
| SPX1189-002 | 功能描述:光電傳感器 INFRARED SENSORS RoHS:否 制造商:Omron Industrial 感應方式:Retroreflective 感應距離:2 m 光源:Infrared LED 放大器類型: 連接:Prewired Cable 輸出配置:Light ON |
| SPX1189003 | 制造商:HONEYWELL 功能描述:Infrared Sensors 制造商:Honeywell Sensing and Control 功能描述:Infrared Sensors |
| SPX1189-003 | 功能描述:液位傳感器 0.5 to 3.0 mW/cm2 IR COMPONENT 10 deg RoHS:否 制造商:Honeywell 連接方法:3 Pin Connector 電流額定值:60 mA 輸出類型:NPN 端口類型: 壓力范圍:0 bar to 25 bar 描述/功能:Fiber Optics and Liquid Level Sensor |
發布緊急采購，3分鐘左右您將得到回復。