- 您現在的位置：買賣IC網 > PDF目錄372188 > SP6203ER-3-0 Low Noise, 300mA and 500mA CMOS LDO Regulators PDF資料下載
參數資料
| 型號： | SP6203ER-3-0 |
| 英文描述： | Low Noise, 300mA and 500mA CMOS LDO Regulators |
| 中文描述： | 低噪音，為300mA和500mA的CMOS LDO穩壓器 |
| 文件頁數： | 3/16頁 |
| 文件大小： | 697K |
| 代理商： | SP6203ER-3-0 |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
3
Date: Apr2-07 SP6203/SP6205 Low Noise, 300 and 500mA CMOS LDO Regulators 2007 Sipex Corporation
ELECTRiCAL SPECiFiCATiONS NOTES
Note 1:
Maximum power dissipation can be calculated using the formula:
P
= (T
- T
) /
e
, where T
is
the junction temperature, T
A
is the ambient temperature and
e
is the junction-to-ambient thermal resistance.
e
JC
is 6
°
C/W for this package
.
Exceeding the maximum allowable power dissipation will result in excessive die
temperature and the regulator will go into thermal shutdown mode.
e
is
191
°
C/W
for SOT-23-5, and is
59
°
C/W
for the -pin DFN. A part mounted on a PC board will deliver improved thermal performance based upon copper
surface area.
Note 2:
Output voltage temperature coefficient is defined as the worst case voltage change divided by the total
temperature range.
Note 3:
Regulation is measured at constant junction temperature using low duty cycle pulse testing. Changes in
output voltage due to heating effects are covered by the thermal regulation specification.
Note 4:
Dropout-voltage is defined as the input to output differential at which the output voltage drops 2% below its
nominal value measured at V differential.
Note 5:
Ground pin current is the regulator quiescent current. The total current drawn from the supply is the sum of
the load current plus the ground pin current.
Note 6:
Output noise voltage is defined within a certain bandwidth, namely 0Hz < BW < 00kHz. An external
bypass cap (0nF) from reference output (BYP pin) to ground significantly reduces noise at output.
Note 7:
Thermal regulation is defined as the change in output voltage at a time “t” after a change in power
dissipation is applied, excluding load and line regulation effects. Specifications are for a 300mA load pulse at V
IN
=
6V for t = ms.
Note 8:
The wake-up time (T
WU
) is defined as the time it takes for the output to start rising after enable is brought
high.
Note 9:
The total turn-on time is called the settling time (T
), which is defined as the condition when both the
output and the bypass node are within 2% of their fully enabled values when released from shutdown.
Note 10:
For output voltage versions requiring VIN to be lower than V, timing (T
ON
& T
OFF
) increases slightly.
(optional)
Cbyp
V
OUT
BYP
EN
VIN
GND
bandgap
reference
thermal shutdown
cur&
1.25V
R2
R1
ADJ
V
OUT
EN
V
IN
GND
bandgap
reference
thermal shutdown
curre&
1.25V
Low Noise Fixed Regulator - 5 Pin
Low Noise Adjustable Regulator - 5 Pin
FUNCTIONAL DIAGRAM
相關PDF資料 |
PDF描述 |
|---|---|
| SP6203ER-3-3 | Low Noise, 300mA and 500mA CMOS LDO Regulators |
| SP6205EM5 | Low Noise, 300mA and 500mA CMOS LDO Regulators |
| SP6205EM5-1-8 | Low Noise, 300mA and 500mA CMOS LDO Regulators |
| SP6205EM5-2-5 | Low Noise, 300mA and 500mA CMOS LDO Regulators |
| SP6205EM5-2-7 | Low Noise, 300mA and 500mA CMOS LDO Regulators |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SP6203ER-3-0/TR | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Low Noise, 300mA and 500mA CMOS LDO Regulators |
| SP6203ER-3-3 | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Low Noise, 300mA and 500mA CMOS LDO Regulators |
| SP6203ER-3-3/TR | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Low Noise, 300mA and 500mA CMOS LDO Regulators |
| SP6203ER-ADJ | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Low Noise, 300mA and 500mA CMOS LDO Regulators |
| SP6203ER-ADJ/TR | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Low Noise, 300mA and 500mA CMOS LDO Regulators |
發布緊急采購，3分鐘左右您將得到回復。