- 您現在的位置：買賣IC網 > PDF目錄385855 > SP6120BCY Low Voltage, AnyFETTM, Synchronous ,Buck Controller Ideal for 2A to 10A, High Performance, DC-DC Power Converters PDF資料下載
參數資料
| 型號： | SP6120BCY |
| 英文描述： | Low Voltage, AnyFETTM, Synchronous ,Buck Controller Ideal for 2A to 10A, High Performance, DC-DC Power Converters |
| 中文描述： | 低電壓，AnyFETTM，同步，降壓控制器適合2A至10A條，高性能，DC - DC電源轉換器 |
| 文件頁數： | 11/22頁 |
| 文件大?。?/td> | 304K |
| 代理商： | SP6120BCY |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁
11
Date: 5/25/04
SP6120B Low Voltage, AnyFET
TM
, Synchronous, Buck Controller Copyright 2004 Sipex Corporation
0V
0V
0A
0V
0V
0A
Continuous
GH, GL
Discontinuous
GH, GL
TIME
providing continuous current sensing and flex-
ible MOSFET selection. An internal, 10
μ
s filter
conditions the over current signal from tran-
sients generated during load steps. In addition,
because the over current inputs, ISP and ISN, are
capable of rail to rail operation, the SP6120B
provides excellent over current protection dur-
ing conditions where V
IN
approaches V
OUT
.
Zero Crossing Detection
In some applications, it may be undesirable to
have negative conduction current in the induc-
tor. This situation happens when the ripple cur-
rent in the inductor is higher than the load cur-
rent. Therefore, the SP6120B provides an option
for “discontinuous” operation. If the Program
Logic (see next section) is set for discontinuous
mode, then the Driver Logic looks at the Zero
Crossing Comparator and the state of the lower
gate driver. If the low side MOSFET was “on”
and V(ISP)-V(ISN) < 0 then the low side
MOSFET is immediately turned off and held off
until the high side MOSFET is turned “on”.
When the high side MOSFET turns “on” , the
Driver Logic is reset. The following figures
show continuous and discontinuous operation
for a converter with an NFET high
side MOSFET.
Discontinuous vs. Continuous Mode
The discontinuous mode is used when better
light load efficiency is desired, for example in
portable applications. Additionally, for power
supply sequencing in some applications the DC-
DC converter output is pre-charged to a voltage
through a switch at start-up, and discontinuous
operation would be required to prevent reverse
inductor current from discharging the pre-charge
voltage. The continuous mode is preferable for
lower noise and EMI applications since the
discontinuous mode can cause ringing of the
switch node voltage when it turns both switches
off. Another example where continuous mode
could be required is one where the inductor has
an extra winding used for an over-winding regu-
lator and thus continuous conduction is neces-
sary to produce this second output voltage.
Program Logic
The Program pin (PROG) of the SP6120B adds
a new level of flexibility to the design of DC/DC
converters. A 10
μ
A current flows either into or
out of the Program pin depending on the initial
potential presented to the pin. If no resistor is
present, the Program Logic simply looks at the
potential on the pin, sets the mode to “continu-
ous” and programs NFET or PFET high side
drive accordingly. If the 68k
resistor is present,
the voltage drop across the resistor signals the
SP6120B to put the Driver Logic in “discontinu-
ous” mode. With one pin and a 68k
resistor, the
SP6120B can be configured for a variety of
operating modes:
Over Current Protection: continued
相關PDF資料 |
PDF描述 |
|---|---|
| SP6120BEY | Low Voltage, AnyFETTM, Synchronous ,Buck Controller Ideal for 2A to 10A, High Performance, DC-DC Power Converters |
| SP6120CY | Low Voltage, AnyFETTM, Synchronous ,Buck Controller Ideal for 2A to 10A, High Performance, DC-DC Power Converters |
| SP6120HVEY | High Voltage, Synchronous ,Buck Controller Ideal for 2A to 20A, High Performance, DC-DC Power Converters |
| SP6120HVCY | CAPACITOR, F/TERM 6800PF 50V X8R 0805CAPACITOR, F/TERM 6800PF 50V X8R 0805; CAPACITANCE:6.8NF; VOLTAGE RATING, DC:50V; CAPACITOR DIELECTRIC TYPE:CERAMIC MULTI-LAYER; SERIES:08055F; TOLERANCE, :10%; TOLERANCE, -:10%; TEMP, OP. RoHS Compliant: Yes |
| SP6120EY | Low Voltage, AnyFETTM, Synchronous,Buck Controller Ideal for 2A to 10A, High Performance, DC-DC Power Converters |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SP6120BCY/TR | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Low Voltage, AnyFETTM, Synchronous ,Buck Controller Ideal for 2A to 10A, High Performance, DC-DC Power Converters |
| SP6120BCY-L | 功能描述:DC/DC 開關控制器 Low Voltage, AnyFET Synchronous, Cntrllr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| SP6120BCY-L/TR | 功能描述:DC/DC 開關控制器 Low Voltage, AnyFET Synchronous, Cntrllr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| SP6120BEY | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Low Voltage, AnyFETTM, Synchronous ,Buck Controller Ideal for 2A to 10A, High Performance, DC-DC Power Converters |
| SP6120BEY/TR | 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Low Voltage, AnyFETTM, Synchronous ,Buck Controller Ideal for 2A to 10A, High Performance, DC-DC Power Converters |
發布緊急采購，3分鐘左右您將得到回復。