參數資料
型號: SP526CF
英文描述: WAN Multi-Mode Serial Transceiver
中文描述: 萬多模式串行收發器
文件頁數: 17/23頁
文件大?。?/td> 141K
代理商: SP526CF
17
Rev: B Date:7/7/04
SP526 Multi–Mode Serial Transceiver
Copyright 2004 Sipex Corporation
The third type of receiver is a differential which
supports RS-422/V.11 signals. This receiver
has a typical input impedance of 10K
and a
differential threshold of
±
0.3V, which complies
with the RS-422/V.11 specifications. Since the
characteristics of the RS-422 (V.11) receivers
are actually subsets of RS-485, the RS-422/
V.11 receivers can accept RS-485 signals.
However, these receivers cannot support 32
transceivers on the signal bus due to the lower
input impedance as specified in the RS-485
specifications. V.11 receivers are used in
RS-422, RS-449, EIA-530, EIA-530A and V.36
as Category I signals for receiving clock, data,
and some control line signals not covered
by Category II V.10 circuits. The differential
receivers can receive signals up to at least
10Mbps.
All four receivers include an enable line for
tri-state of the receiver output allowing
convenient half-duplex configurations. When
the enable lines are at a logic LOW ("0") active,
the receiver outputs are high impedance and will
be at approximately 10k
during tri-state.
All receivers include a fail-safe feature that
outputs a logic high when the receiver inputs are
open. For single-ended RS-232 receivers, there
are internal 5k
pull-down resistors on the
inputs which produces a logic high ("1") at the
receiver outputs. The single-ended RS-423
receivers produce a logic LOW ("0") on the
output when the inputs are open. This is due to
a pull-up device connected to the input. The
differential receivers have the same internal
pull-up device on the non-inverting input which
produces a logic HIGH ("1") at the receiver output.
Charge Pump
The charge pump is a
Sipex
–patented design
(U.S. 5,306,954) and uses a unique approach
compared to older less–efficient designs. The
charge pump still requires four external capaci-
tors, but uses a four–phase voltage shifting
technique to attain symmetrical 10V power
supplies. There is a free–running oscillator that
controls the four phases of the voltage shifting.
A description of each phase follows.
Phase 1
— V
charge storage —During this phase of
the clock cycle, the positive side of capacitors
C
and C
are initially charged to +5V. C
l
then switched to ground and the charge in C
transferred to C
+5V, the voltage potential across capacitor C
2
is
now 10V.
+
is
is
. Since C
+
is connected to
Phase 2
— V
transfer — Phase two of the clock
connects the negative terminal of C
to the V
SS
storage capacitor and the positive terminal of C
2
to ground, and transfers the generated –l0V to
C
. Simultaneously, the positive side of
capacitor C
is switched to +5V and the
negative side is connected to ground.
Phase 3
— V
charge storage — The third phase of the
clock is identical to the first phase — the charge
transferred in C
produces –5V in the negative
terminal of C
, which is applied to the negative
side of capacitor C
. Since C
voltage potential across C
2
is l0V.
+
is at +5V, the
C
1
+
-
-5V
V
CC
= +5V
+5V
C
2
-5V
C
4
+
C
3
+
-
-
-
+
V
DD
Storage Capacitor
V
SS
Storage Capacitor
Figure 30. Charge Pump — Phase 1
相關PDF資料
PDF描述
SP5301 Universal Serial Bus Transceiver
SP5301CN Universal Serial Bus Transceiver
SP5301CY Universal Serial Bus Transceiver
SP6120 Fixed Frequency, Voltage Mode, Synchronous PWM Controller(固定頻率,電壓模式同步PWM(脈寬調制控制器))
SP6122ACU-15 Low Voltage, Micro 8, PFET, Buck Controller Ideal for 1A to 5A, Small Footprint, DC-DC Power Converters
相關代理商/技術參數
參數描述
SP526CF-L 功能描述:外圍驅動器與原件 - PCI WAN Multi-Mode Serial RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
SP527A 制造商:Black Box Corporation 功能描述:DDS SURGE PROTECTOR RJ-45
SP527A-W1 制造商:Black Box Corporation 功能描述:1 YEAR WARRANTY FOR SP527A
SP527A-W3 制造商:Black Box Corporation 功能描述:3 YEAR WARRANTY FOR SP527A
SP529A 制造商:Black Box Corporation 功能描述:GIG IN-LINE SURGE PROTECTOR