• <pre id="dlq5c"></pre>
      <pre id="dlq5c"><strike id="dlq5c"><pre id="dlq5c"></pre></strike></pre>
      參數資料
      型號: SP508CEB
      英文描述: Evaluation Board Manual
      中文描述: 評估板手冊
      文件頁數: 3/10頁
      文件大?。?/td> 72K
      代理商: SP508CEB
      rev. 7/7/03
      SP508 Evaluation Board Manual
      3
      Copyright 2003 Sipex Corporation
      SP508 EVALUATION BOARD
      Figure 2: RS-232 & EIA530 Connector (ISO 2110),
      DTE Connector
      σ
      DB-25 Male, DCE Connector
      σ
      DB-
      25 Female
      1
      13
      14
      25
      BOARD LAYOUT
      1. The SP508 Evaluation board takes ad-
      vantage of the products PCB friendly flow
      through pinout in its design as shown in
      Figure 1.
      2. The SP508 Evaluation Board has been
      designed to easily and conveniently provide
      access to all inputs and outputs under test.
      3. Figure 1 is a block diagram of the evalu-
      ation board showing the layout of the SP508
      Evaluation Board. The block diagram shows
      the location of the driver and receiver ac-
      cess points as well as the DIP switches, V
      CC
      ,
      GND and the DB-25 Connector.
      4. I/O Pinouts
      The SP508 Evaluation Board has been de-
      signed to easily and conveniently provide
      access to all inputs and outputs to the device
      under test. Position the Board with the DB-
      25 connector at the top and the Dip switches
      at the bottom. From this orientation , all
      driver inputs and outputs are on the right-
      hand side and all receiver inputs and out-
      puts are on the left-hand side eof the Board.
      4.1. Each Driver has probe points for the
      input and outputs. There is a ground buss to
      the right of the drive outputs for the addition
      of loads to the driver outputs and to jumper
      the V.35 that is associated with the SD, TT,
      and ST driver. Each V.35 driver has a
      separate ground for the V.35 termination
      network internal to the device.
      4.2. Each Receiver has probe points for the
      inputs and outputs. there is a ground buss
      to the left of the receiver outputs and a
      separate pin for the V.10 termination ground.
      5. At the bottom of the board is a series of
      six(6) DIP switches. The DIP switch on the
      far left is for D_LATCH and TERM_OFF.
      Each driver and receiver has its own indi-
      vidual enable pin. The DIP switches to
      control the enable pins are located as the
      top center bank of switches for the driver and
      the middle center bank of switches for the
      receiver. The bottom center set of DIP
      switches is for the 3 bit decoder and the
      loopback control pin. The right hand DIP
      switches allow the user to tie the ST driver
      outputs to the TxC receiver inputs and the
      RRC driver outputs to the RRT receiver
      inputs.
      6. Also located on the SP508 evaluation
      board are the four 10uf charge pump capaci-
      tors, a 10uf bypass capacitor for V
      CC
      and a
      50
      termination resistor.
      7. Table 1 shows the pinout of the DB-25
      connector used to connect to a communica-
      tion analyzer such as the TTC Firebird 6000.
      相關PDF資料
      PDF描述
      SP508 Rugged 40Mbps, 8 Channel Multiprotocol Transceiver with Programmable DCE/DTE and Termination Resistors(40Mbps差分傳輸速率,8通道多協議收發器(帶可編程DCE/DTE和終端電阻器))
      SP514 WAN Multi-Mode Serial Transceiver
      SP514CF WAN Multi-Mode Serial Transceiver
      SP516 20Mbps 7 Driver, 7 Receiver Multiprotocol Serial Transceiver with Termination Disable
      SP516CF 20Mbps 7 Driver, 7 Receiver Multiprotocol Serial Transceiver with Termination Disable
      相關代理商/技術參數
      參數描述
      SP508CF 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Rugged 20Mbps, 8 Channel Multi-Protocol Transceiver with Programmable DCE/DTE and Termination Resistors
      SP508CF-L 功能描述:外圍驅動器與原件 - PCI 20MBPS 8CH MULTI 0-70C RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
      SP508EB 制造商:SIPEX 制造商全稱:Sipex Corporation 功能描述:Evaluation Board Manual
      SP508ECF-L 制造商:Exar Corporation 功能描述:Octal Transmitter/Receiver RS-232/RS-449/RS-530 100-Pin LQFP 制造商:Exar Corporation 功能描述:SP508ECF-L 制造商:Exar Corporation 功能描述:IC, MULTIPROTOCOL TXRX, 20MBPS, LQFP-100; Device Type:Transceiver; IC Interface Type:RS232, RS449, EIA530, EIA530A; No. of Drivers:8; Supply Voltage Min:4.75V; Supply Voltage Max:5.25V; Driver Case Style:LQFP; No. of Pins:100 ;RoHS Compliant: Yes
      SP508EEF-L 制造商:Exar Corporation 功能描述:Octal Transmitter/Receiver RS-232/RS-449/RS-530 100-Pin LQFP 制造商:Exar Corporation 功能描述:SP508EEF-L 制造商:Exar Corporation 功能描述:IC, MULTIPROTOCOL TXRX, 20MBPS, LQFP-100; Device Type:Transceiver; IC Interface Type:RS232, RS449, EIA530, EIA530A; No. of Drivers:8; Supply Voltage Min:4.75V; Supply Voltage Max:5.25V; Driver Case Style:LQFP; No. of Pins:100 ;RoHS Compliant: Yes