- 您現在的位置：買賣IC網 > PDF目錄365669 > SNJ54LVTH543FK (Texas Instruments, Inc.) 3.3 V ABT OCTAL REGISTERED TRANSCEIVERS WITH 3 STATE OUTPUTS PDF資料下載
參數資料
| 型號： | SNJ54LVTH543FK |
| 廠商： | Texas Instruments, Inc. |
| 元件分類： | 通用總線功能 |
| 英文描述： | 3.3 V ABT OCTAL REGISTERED TRANSCEIVERS WITH 3 STATE OUTPUTS |
| 中文描述： | 3.3伏生根粉八路注冊三態輸出的收發器 |
| 文件頁數： | 2/14頁 |
| 文件大?。?/td> | 353K |
| 代理商： | SNJ54LVTH543FK |
SCBS704F AUGUST 1997 REVISED OCTOBER 2003
2
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
description/ordering information (continued)
The ’LVTH543 devices contain two sets of D-type latches for temporary storage of data flowing in either
direction. Separate latch-enable (LEAB or LEBA) and output-enable (OEAB or OEBA) inputs are provided for
each register, to permit independent control in either direction of data flow.
The A-to-B enable (CEAB) input must be low to enter data from A or to output data from B. If CEAB is low and
LEAB is low, the A-to-B latches are transparent; a subsequent low-to-high transition of LEAB puts the A latches
in the storage mode. With CEAB and OEAB both low, the 3-state B outputs are active and reflect the data present
at the output of the A latches. Data flow from B to A is similar, but requires using the CEBA, LEBA, and OEBA
inputs.
Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors
with the bus-hold circuitry is not recommended.
When V
CC
is between 0 and 1.5 V, the device is in the high-impedance state during power up or power down.
However, to ensure the high-impedance state above 1.5 V, OE should be tied to V
CC
through a pullup resistor;
the minimum value of the resistor is determined by the current-sinking capability of the driver.
This device is fully specified for hot-insertion applications using I
off
and power-up 3-state. The I
off
circuitry
disables the outputs, preventing damaging current backflow through the device when it is powered down. The
power-up 3-state circuitry places the outputs in the high-impedance state during power up and power down,
which prevents driver conflict.
FUNCTION TABLE
INPUTS
OUTPUT
B
CEAB
LEAB
OEAB
A
H
X
X
X
Z
X
X
H
X
Z
L
H
L
X
B0
L
L
L
L
L
L
L
L
H
H
A-to-B data flow is shown; B-to-A flow control is the
same, except that it uses CEBA, LEBA, and
OEBA.
Output level before the indicated steady-state
input conditions were established
相關PDF資料 |
PDF描述 |
|---|---|
| SNJ54LVTH543JT | 3.3 V ABT OCTAL REGISTERED TRANSCEIVERS WITH 3 STATE OUTPUTS |
| SNJ54LVTH543W | 3.3 V ABT OCTAL REGISTERED TRANSCEIVERS WITH 3 STATE OUTPUTS |
| SN74LVTH543DB | 3.3-V ABT OCTAL REGISTERED TRANSCEIVERS WITH 3-STATE OUTPUTS |
| SN74LVTH543DGV | 3.3-V ABT OCTAL REGISTERED TRANSCEIVERS WITH 3-STATE OUTPUTS |
| SN74LVTH543DGVR | 3.3 V ABT OCTAL REGISTERED TRANSCEIVERS WITH 3 STATE OUTPUTS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SNJ54LVTH573FK | 制造商:Texas Instruments 功能描述:Latch Transparent 3-ST 8-CH D-Type 20-Pin LCCC Tube |
| SNJ54LVTH574FK | 制造商:Texas Instruments 功能描述:Flip Flop D-Type Bus Interface Pos-Edge 3-ST 1-Element 20-Pin LCCC Tube 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| SNJ54S00J | 制造商:Texas Instruments 功能描述:2-INPUT NAND GATE |
| SNJ54S00W | 制造商:Texas Instruments 功能描述:NAND Gate 4-Element 2-IN Bipolar 14-Pin CFPAK Tube |
| SNJ54S02J | 制造商:Texas Instruments 功能描述:NOR Gate 4-Element 2-IN Bipolar 14-Pin CDIP Tube 制造商:Rochester Electronics LLC 功能描述:2-INPUT NOR GATE - Bulk |
發布緊急采購，3分鐘左右您將得到回復。