參數資料
型號: SI3210
廠商: Electronic Theatre Controls, Inc.
元件分類: Codec
英文描述: PROSLIC PROGRAMMABLE CMOS SLIC/CODEC WITH RINGING/BATTERY VOLTAGE GENERATION
中文描述: ProSLIC產品可編程的CMOS用戶接口/有振鈴編解碼器/電池電壓生成
文件頁數: 24/122頁
文件大?。?/td> 1950K
代理商: SI3210
Si3210/Si3211/Si3212
24
Preliminary Rev. 1.11
Power Monitoring and Line Fault Detection
In addition to reporting voltages and currents, the
ProSLIC continuously monitors the power dissipated in
each external bipolar transistor. Realtime output power
of any one of the six linefeed transistors can be read by
setting the Power Monitor Pointer (direct Register 76) to
point to the desired transistor and then reading the Line
Power Output Monitor (direct Register 77).
The realtime power measurements are low-pass filtered
and compared to a maximum power threshold.
Maximum power thresholds and filter time constants are
software programmable and should be set for each
transistor pair based on the characteristics of the
transistors used. Table 23 describes the registers
associated with this function. If the power in any
external transistor exceeds the programmed threshold,
a power alarm event is triggered. The ProSLIC sets the
Power Alarm register bit, generates an interrupt (if
enabled), and automatically enters the Open state (if
AOPN = 1).
This
feature
transistors from fault conditions and, combined with the
loop voltage and current monitors, allows diagnosis of
protects
the
external
the type of fault condition present on the line.
The value of each thermal low-pass filter pole is set
according to the equation:
where
τ
is the thermal time constant of the transistor
package, 4096 is the full range of the 12-bit register, and
800 is the sample rate in hertz. Generally
τ
= 3 seconds
for SOT223 packages and
τ
= 0.16 seconds for SOT23,
but check with the manufacturer for the package
thermal constant of a specific device. For example, the
power alarm threshold and low-pass filter values for Q5
and Q6 using a SOT223 package transistor are
computed as follows:
Thus, indirect Register 34 should be set to 150Dh.
Note:
The power monitor resolution for Q3 and Q4 is different
from that of Q1, Q2, Q5, and Q6.
Table 22. Measured Realtime Linefeed Interface Characteristics
Parameter
Measurement
Range
Resolution
Register
Bits
Location*
Loop Voltage Sense (V
TIP
– V
RING
)
–94.5 to +94.5 V
1.5 V
LVSP,
LVS[6:0]
Direct Register 78
Loop Current Sense
–80 to +80 mA
1.27 mA
LCSP,
LCS[5:0]
Direct Register 79
TIP Voltage Sense
0 to –95.88 V
0.376 V
VTIP[7:0]
Direct Register 80
RING Voltage Sense
0 to –95.88 V
0.376 V
VRING[7:0]
Direct Register 81
Battery Voltage Sense 1 (V
BAT
)
0 to –95.88 V
0.376 V
VBATS1[7:0]
Direct Register 82
Battery Voltage Sense 2 (V
BAT
)
0 to –95.88 V
0.376 V
VBATS2[7:0]
Direct Register 83
Transistor 1 Current Sense
0 to 81.35 mA
0.319 mA
IQ1[7:0]
Direct Register 84
Transistor 2 Current Sense
0 to 81.35 mA
0.319 mA
IQ2[7:0]
Direct Register 85
Transistor 3 Current Sense
0 to 9.59 mA
37.6
μ
A
IQ3[7:0]
Direct Register 86
Transistor 4 Current Sense
0 to 9.59 mA
37.6
μ
A
IQ4[7:0]
Direct Register 87
Transistor 5 Current Sense
0 to 80.58 mA
0.316 mA
IQ5[7:0]
Direct Register 88
Transistor 6 Current Sense
0 to 80.58 mA
0.316 mA
IQ6[7:0]
Direct Register 89
*Note:
The ProSLIC uses registers that are both directly and indirectly mapped. A “direct” register is one that is mapped
directly.
thermal LPF register
800
τ
----------------
2
3
=
PPT56
P
Resolution
------------------------------
2
7
0.0304
-----------------
2
7
5389
150Dh
=
=
=
=
相關PDF資料
PDF描述
SI3210-BT PROSLIC PROGRAMMABLE CMOS SLIC/CODEC WITH RINGING/BATTERY VOLTAGE GENERATION
SI3210-KT PROSLIC PROGRAMMABLE CMOS SLIC/CODEC WITH RINGING/BATTERY VOLTAGE GENERATION
SI3211-BT PROSLIC PROGRAMMABLE CMOS SLIC/CODEC WITH RINGING/BATTERY VOLTAGE GENERATION
SI3211-KT PROSLIC PROGRAMMABLE CMOS SLIC/CODEC WITH RINGING/BATTERY VOLTAGE GENERATION
SI3212 PROSLIC PROGRAMMABLE CMOS SLIC/CODEC WITH RINGING/BATTERY VOLTAGE GENERATION
相關代理商/技術參數
參數描述
SI3210-BT 功能描述:電信線路管理 IC CONTACT SILICON LABS FOR AVAILABILITY RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
SI3210-BTR 功能描述:電信線路管理 IC Sgl Ch SLIC/Codec w/ DTMF Decoder RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
SI3210DC1-EVB 功能描述:子卡和OEM板 Si3210M Daughter Crd W/ SI3201 INTERFACE RoHS:否 制造商:BeagleBoard by CircuitCo 產品:BeagleBone LCD4 Boards 用于:BeagleBone - BB-Bone - Open Source Development Kit
SI3210DCQ1-EVB 功能描述:子卡和OEM板 Si3210 QFN Daughter Card RoHS:否 制造商:BeagleBoard by CircuitCo 產品:BeagleBone LCD4 Boards 用于:BeagleBone - BB-Bone - Open Source Development Kit
SI3210DCQX-EVB 功能描述:子卡和OEM板 Si3210 QFN Daughter Card RoHS:否 制造商:BeagleBoard by CircuitCo 產品:BeagleBone LCD4 Boards 用于:BeagleBone - BB-Bone - Open Source Development Kit