參數資料
型號： SI3210-FT
廠商： Silicon Laboratories Inc
文件頁數： 87/148頁
文件大小： 0K
描述： IC SLIC/CODEC PROGRAMMBL 38TSSOP
標準包裝： 50
系列： ProSLIC®
功能： 用戶線路接口概念（SLIC），CODEC
接口： PCM，SPI
電路數： 1
電源電壓： 3.3V，5V
電流 - 電源： 88mA
功率（瓦特）： 700mW
工作溫度： 0°C ~ 70°C
安裝類型： 表面貼裝
封裝/外殼： 38-TFSOP（0.173"，4.40mm 寬）
供應商設備封裝： 38-TSSOP
包裝： 管件
包括： BORSCHT 功能，DTMF 生成和解碼，F(xiàn)SK 生成，脈沖測量生成，語音回送測試模式
其它名稱： 336-1168
Si3210/Si3211
Rev. 1.61
43
Not
Recommended
fo
r N
ew
D
esi
gn
s
Figure 21. Tone Generator Timing Diagram
2.3.4. Enhanced FSK Waveform Generation
Silicon revisions C and higher support enhanced FSK
generation capabilities, which can be enabled by setting
FSKEN = 1 (direct Register 108, bit 6) and REN = 1
(direct Register 32, bit 6). In this mode, the user can
define mark (1) and space (0) attributes once during
initialization by defining indirect registers 99–104. The
user need only indicate 0-to-1 and 1-to-0 transitions in
the information stream. By writing to FSKDAT (direct
Register 52), this mode applies a 24 kHz sample rate to
tone generator 1 to give additional resolution to timers
and frequency generation. “AN32: Si321x Frequency
Shift
Keying
(FSK)
Modulation”
gives
detailed
instructions on how to implement FSK in this mode.
Additionally, sample source code is available from
Silicon Laboratories upon request.
2.3.5. Tone Generator Interrupts
Both the active and inactive timers can generate their
own interrupt to signal “on/off” transitions to the
software. The timer interrupts for tone generator 1 can
be individually enabled by setting the O1AE and O1IE
bits (direct Register 21, bits 0 and 1, respectively).
Timer interrupts for tone generator two are O2AE and
O2IE (direct Register 21, bits 2 and 3, respectively). A
pending interrupt for each of the timers is determined by
reading the O1AP, O1IP, O2AP, and O2IP bits in the
Interrupt Status 1 register (direct Register 18, bits 0
through 3, respectively).
2.4. Ringing Generation
The ProSLIC provides fully-programmable internal
balanced ringing with or without a dc offset to ring a
wide variety of terminal devices. All parameters
associated with ringing (ringing frequency, waveform,
amplitude, dc offset, and ringing cadence) are software-
programmable. Both sinusoidal and trapezoidal ringing
waveforms are supported, and the trapezoidal crest
factor is programmable. Ringing signals of up to 88 V
peak or more can be generated, enabling the ProSLIC
to drive a 5 REN (1380
+ 40 F) ringer load across
loop lengths of 2000 feet (160
) or more.
2.4.1. Ringing Architecture
The ringing generator architecture is nearly identical to
that of the tone generator. The sinusoidal ringing
waveform is generated using an internal two-pole
resonance
oscillator
circuit
with
programmable
frequency and amplitude. However, since ringing
frequencies are very low compared to the audio band
signaling
frequencies,
the
ringing
waveform
is
generated at a rate of 1 kHz instead of 8 kHz.
The ringing generator has two timers that function the
same as the tone generator timers. They allow on/off
cadence settings of up to 8 seconds on and 8 seconds
off. In addition to controlling ringing cadence, these
timers control the transition into and out of the ringing
state. Table 30 summarizes the list of registers used for
ringing generation.
Note: Tone generator 2 should not be enabled concurrently
with the ringing generator due to resource sharing
within the hardware.
...
0,1
...
0,1
...
..., OAT1
..., OIT1
0,1
...
0,1
...
O1E
OSS1
Tone
G en. 1
Signal
O utput
相關PDF資料
PDF描述
VI-2N4-IX-S CONVERTER MOD DC/DC 48V 75W
SI3211-E-GMR IC PROSLIC/CODEC DTMF 38VQFN
SI3216M-C-GM IC SLIC/CODEC 1CH 38QFN
SI3216-C-GM IC SLIC/CODEC 1CH 38QFN
VE-2NT-IX-S CONVERTER MOD DC/DC 6.5V 75W
相關代理商/技術參數
參數描述
SI3210-FTR 功能描述:電信線路管理 IC Single-CH SLIC/Codec dc-dc RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
SI3210-GT 功能描述:電信線路管理 IC Single-Channel SLIC Codec RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
SI3210-GTR 功能描述:電信線路管理 IC Single-CH SLIC/Codec dc-dc RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
SI3210-KT 功能描述:電信線路管理 IC Single Channel SLIC /CODEC w/DTMF RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
SI3210-KTR 功能描述:電信線路管理 IC Sgl Ch SLIC/Codec w/ DTMF Decoder RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*