參數資料
型號： SI3024-KS
廠商： Electronic Theatre Controls, Inc.
英文描述： 3.3 V FCC/JATE DIRECT ACCESS ARRANGEMENT
中文描述： 3.3伏催化裂化/ JATE直接訪問安排
文件頁數： 19/54頁
文件大?。?/td> 1407K
代理商： SI3024-KS
Si3035
Rev. 1.2
19
delay, a higher Fs may be established prior to executing
the off-hook, such as an Fs of 10.286 kHz. The delay
allows line transients to settle prior to normal use.
Ring Detect
The ring signal enters the Si3035 through low value
capacitors connected to TIP and RING. RGDT is a
clipped, half-wave rectified version of the ringing
waveform. See Figure 18 for a timing diagram of the
RGDT pin.
The integrated ring detect of the Si3035 allows the
device to present the ring signal to the DSP, through the
serial port, with no additional signaling required. The
signal sent to the DSP is a clipped version of the original
ring signal. In addition, the Si3035 passes through the
caller ID data unaltered.
The system can also detect an occurring ring by the
status of the RDT bit of Register 5. This bit is a
read-only bit that is set when the line-side device
detects a ring signal at RNG1 and RNG2. The RDT bit
clears when the system either goes off-hook or 4.5 to 9
seconds after the last ring is detected.
If caller ID is supported in the system, the designer can
enable the Si3035 to pass this information to the SDO
output. Following the completion of the first ring, the
system should set the ONHM bit (Register 5, bit 3). This
bit must be cleared at the conclusion of the receipt of
the caller ID data and prior to the next ring burst.
The Si3021 can support a wake-up-on-ring function
using the RGDT signal. Refer to "Power Management"
on page 24 for more details
.
Improved JATE Support
The HYBD pin connects to a node on the internal hybrid
cancellation circuit providing a pin for a balancing
capacitor, C12. C23 adds the necessary transmit
out-of-band filtering required to meet JATE out-of-band
noise specifications. The addition of C23 alters the
transmit path frequency response which must be
balanced with capacitor C12 to obtain maximum hybrid
cancellation.
Products using the Si3035 which have been submitted
for JATE approval should document a waiver for the
JATE DC Termination specification. This specification is
met in the Si3034 global DAA device.
Digital Interface
The Si3035 has two serial interface modes that support
most standard modem DSPs. The M0 and M1 mode
pins select the interface mode. The key difference
between these two serial modes is the operation of the
FSYNC signal. Table 16 summarizes the serial mode
definitions.
Figure 18. Ring Detect Timing
Table 16. Serial Modes
Mode M1 M0
Description
0
0 0
FSYNC frames data
1
0 1
FSYNC pulse starts data frame
2
1 0
Slave mode
3
1 1
Reserved
DATA
DIGITIZED LINE SIGNAL
SDO
RNG1/
RNG2
First Ring
0.2–3.0 seconds
0.5–1.5 Sec.
> 0.2 Sec.
RGDT
相關PDF資料
PDF描述
SI3024-KT CABLE ASSEMBLY; BNC MALE TO N MALE; 50 OHM, RG174A/U COAX
SI3025-KS 3.3 V FCC/JATE DIRECT ACCESS ARRANGEMENT
SI3024 GLOBAL MC 97 SILICON DAA
SI3014 GLOBAL MC 97 SILICON DAA
SI3025 COOLER FOR TO-3 20 WATTS
相關代理商/技術參數
參數描述
SI3024-KT 制造商:未知廠家 制造商全稱:未知廠家 功能描述:GLOBAL MC 97 SILICON DAA
SI3025 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:LOW-VOLTAGE, HIGH-CURRENT 1.8 V LINEAR REGULATOR
SI-3025B 制造商:SANKEN 制造商全稱:Sanken electric 功能描述:5-Terminal, Multi-Function, Full-Mold, Low Dropout Voltage Dropper Type
SI-3025F 制造商:SANKEN 制造商全稱:Sanken electric 功能描述:5-Terminal, Multi-Function, Full-Mold, Low Dropout Voltage Dropper Type
SI-3025KM 制造商:SANKEN 制造商全稱:Sanken electric 功能描述:Surface Mount Low Current Consumption Low Dropout Voltage Linear Regulator ICs
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*