參數資料
型號： SI2404-D-GT
廠商： Silicon Laboratories Inc
文件頁數： 14/60頁
文件大小： 0K
描述： IC ISOMODEM GLOBAL DAA 24TSSOP
標準包裝： 62
系列： *
Si2457/34/15/04
Rev. 1.3
21
4.13. Overcurrent Detection
The Si2457/34/15/04 includes an overcurrent detection
feature
that
measures
the
loop
current
at
a
programmable time after the Si2457/34/15/04 goes off-
hook. This allows the Si2457/34/15/04 to detect if it is
connected
to
an
improper
telephone
line.
The
overcurrent detection feature may be enabled by setting
the OCDM bit (U70, bit 11). OHT (U77, bits 8:0) sets the
delay after off-hook until the loop current is measured.
See “AN93: ISOmodem Chipset Family Designer's
Guide” for details.
4.14. Global Operation
The Si2457/34/15/04 chipset contains an integrated
silicon direct access arrangement (Silicon DAA) that
provides a programmable line interface to meet
international telephone line interface requirements.
“AN93: Modem Designer’s Guide” gives the DAA
register settings required to meet international PTT
standards.
Additionally, the user-access registers (via the AT:U and
AT:R commands) may be programmed for country-
specific settings, such as dial tone, ring, ringback, and
busy tone. See AN93 for complete details.
4.15. Firmware Upgrades
The Si2457/34/15/04 contains an on-chip program ROM
that includes the firmware required for the features
listed in this data sheet. In addition, the Si2457/34/15/04
contains on-chip program RAM to accommodate minor
changes to the ROM firmware. This allows Silicon Labs
to provide future firmware updates to optimize the
characteristics of new modem designs and those
already deployed in the field. See AN93 for complete
details.
4.16. DTMF Detection / Generation
The Si2457/34/15/04 provides comprehensive DTMF
tone generation and detection. The ISOmodem can
generate single tones or DTMF tones using the +VTS
command. DTMF tones may also be generated during
dialing using the “ATDT” command. DTMF detection is
only available in voice mode (+FCLASS = 8). DTMF
digits are reported from the modem to the host using
<DLE> shielding.
4.17. SMS/MMS Support
Short Message Service (SMS) is a service that allows
text messages to be sent and received from one
telephone to another via an SMS service center.
Multimedia Messaging Service (MMS) extends the core
SMS
capability
to
send
messages
that
include
multimedia content. The Fax ISOmodem provides an
interface that offers a great deal of flexibility in handling
multiple SMS standards. This flexibility is possible
because most of the differences between standards are
handled by the host using the raw data itself. The
Si2457/34/15/04 performs the necessary modulation/
demodulation of the data and provides two options for
message packet structure (Protocol 1 and Protocol 2, as
defined in ETSI ES 201 912). The rest of the data link
layer and transfer layer are defined by the host system.
The content of the message is entirely up to the host
including any checksum or CRC. ETSI ES 201 912
describes two standard data and transfer layers that are
commonly
used.
SMS
typically
relies
on
caller
identification information to determine if the call should
be answered using an SMS device or not.
See “6.4. SMS Support” in AN93 for more information
on how to configure the modem for SMS support.
4.18. Codec Interface (24-Pin Version Only)
In order to support a full range of voice and data
applications, the Si2457/34/15/04 includes an optional
serial interface that connects to an external voice codec
(Si3000). See AN93 for complete details.
4.19. EEPROM Interface
(24-Pin Version Only)
The
Si2457/34/15/04
supports
an
optional
serial
peripheral interface (SPI) bus serial EEPROM Mode 3
with a 16-bit (8–64 kbit range) address. Upon powerup,
if a pulldown resistor
10 k is placed between D6 and
GND, the ISOmodem attempts to detect an EEPROM.
The EEPROM is intended first for setting custom
defaults, second for automatically loading firmware
upgrades, and third to allow for user-defined AT
command macros for use in custom AT commands or
country codes. See AN93 for complete details.
4.20. AT Commands
At powerup, the Si2457/34/15/04 is in the AT command
mode. In command mode, the modem monitors the
input (serial or parallel) checking constantly for a valid
command (AT commands are described in Table 8.)
相關PDF資料
PDF描述
PIC16C66/JW IC MCU OTP 8KX14 PWM 28CDIP
DS5000-32-16+ IC MPU 32KB 16MHZ 40-DIP
DS5000-32-16 IC MPU 32KB 16MHZ 40-DIP
DS2250-64-16# IC MCU 64KB 16MHZ 40-SIMM
DS2250T-32-16 IC MICROCNTRLR 32X8 16MHZ 40SIMM
相關代理商/技術參數
參數描述
SI2404-D-GTR 制造商:Silicon Laboratories Inc 功能描述:2400 BPS ISOMODEM WITH ERROR CORRECTION SYSTEM-SIDE - - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC ISOMODEM GLOBAL DAA 24TSSOP 制造商:Silicon Laboratories Inc 功能描述:2401 bps ISOmodem Error Correction
Si2404FS08-EVB 功能描述:網絡開發工具 16-pin Si2404+Si3008 ISOmodem Eval Board RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V
Si2404FS10-EVB 功能描述:網絡開發工具 16-pin Si2404+Si3010 ISO modem Eval Board RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V
SI2404-FT 功能描述:電信線路管理 IC CONTACT SILICON LABS FOR AVAILABILITY RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
Si2404FT08-EVB 功能描述:網絡開發工具 24-pin Si2404+Si3008 ISOmodem Eval Board RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*