- 您現在的位置：買賣IC網 > PDF目錄271324 > SHL-W255 SNAP ACTING/LIMIT SWITCH, SPST, MOMENTARY, 10A, 14VDC, 11mm, PANEL MOUNT PDF資料下載
參數資料
| 型號： | SHL-W255 |
| 元件分類： | 開關 |
| 英文描述： | SNAP ACTING/LIMIT SWITCH, SPST, MOMENTARY, 10A, 14VDC, 11mm, PANEL MOUNT |
| 文件頁數： | 2/12頁 |
| 文件大?。?/td> | 435K |
| 代理商： | SHL-W255 |
Enclosed Switch
SHL
137
Tightening Torque
A loose screw may result in a malfunction. Be sure to tighten each
screw to the proper tightening torque as shown below.
When wiring, use M3 round solderless terminals and apply insulation
shielding to the connections. Tighten the terminals screws to 0.24 to
0.44 Nm.
Operating Stroke
Ensure that the operating stroke for roller plunger models is within
the set position display.
Micro Load Applicable Ranges
When using a Limit Switch for opening or closing micro-load circuit
(zones 1 through 3), contact failure may occur if a Limit Switch with
ordinary contact specifications is used. Therefore, when using Limit
Switches in the micro-load range, use ones with contact specifica-
tions that are suited to each zone.
Use the SHL-
@-01 micro-load models within the zones (1 through 3)
shown in the following diagram.
The above diagram is for standard conditions (5
°C to 35°C, 40% to
70%). Since the values vary depending on the operating environ-
ment conditions, contact your OMRON representative for further
details.
Others
The standard seal rubber for the lead wire outlet is one that allows 6-
to 8-dia. cables. The appropriate nominal cross-section of the lead
wire is 0.75 mm2. (When the sealing capability is required over a long
period of time, use mold specifications.)
No.
Type
Torque
1
Terminal screw (M3 screw) 0.24 to 0.44 Nm
2
Panel mounting screw
(M4 screw)
1.18 to 1.37 Nm
Operating stroke range
Reference
30
24
12
5
0
1
10
100
1,000
0.1
1 mA
26 mA
0.16 mA
800 mW
5 mW
100 mA 160 mA
Current (mA)
V
oltage
(VDC)
Operating range for
micro-load models
Operating
range for
standard
models
Unusable
range
相關PDF資料 |
PDF描述 |
|---|---|
| SWW248A-7X601ULU1716 | TOGGLE SWITCH, DPDT, LATCHED AND MOMENTARY, 4A, 30VDC, THROUGH HOLE-RIGHT ANGLE |
| SWW249A-7X601ULU1716 | TOGGLE SWITCH, DPDT, LATCHED, 4A, 30VDC, THROUGH HOLE-RIGHT ANGLE |
| SW244THA-7X601CECCU1711 | TOGGLE SWITCH, DP3T, LATCHED, 4A, 30VDC, THROUGH HOLE-RIGHT ANGLE |
| ST2-6L4S4V-1BJ12 | ROCKER SWITCH, DPDT, LATCHED, 0.02A, 20VDC, THROUGH HOLE-RIGHT ANGLE |
| SWW244THA-7X601CECCU1711 | TOGGLE SWITCH, DP3T, LATCHED, 4A, 30VDC, THROUGH HOLE-RIGHT ANGLE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SHLW25501 | 制造商:OMRON AUTOMATION AND SAFETY 功能描述:SWITCH LIMIT SPDT .1A ROLL LEVER 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:Switch Limit N.O./N.C. SPDT Short Hinge Roller Lever Cable 0.1A 125VAC 30VDC 3.92N Linear Screw Mount |
| SHL-W255-01 | 功能描述:基本/快動開關 LIMIT SWITCH RoHS:否 制造商:Omron Electronics 觸點形式:SPDT 執行器:Lever 電流額定值:5 A 電壓額定值 AC:250 V 電壓額定值 DC:30 V 功率額定值: 工作力:120 g IP 等級:IP 67 NEMA 額定值: 端接類型:Wire 安裝:Panel |
| SHL-W255-L4MR SFLEX 3M | 功能描述:基本/快動開關 LS S-HNG RLR LVR W LED RoHS:否 制造商:Omron Electronics 觸點形式:SPDT 執行器:Lever 電流額定值:5 A 電壓額定值 AC:250 V 電壓額定值 DC:30 V 功率額定值: 工作力:120 g IP 等級:IP 67 NEMA 額定值: 端接類型:Wire 安裝:Panel |
| SHLW255L4MRSFLEX3M | 制造商:OMRON AUTOMATION AND SAFETY 功能描述:SWITCH LIMIT SPDT 10A ROLLR LEVR 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:LS, S-HNG RLR LVR, W/LED |
| SHLW255L6MD11 | 制造商:OMRON AUTOMATION AND SAFETY 功能描述:SWITCH LIMT SPDT HINGE ROLL LEVR 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:LIMIT SWITCH |
發布緊急采購，3分鐘左右您將得到回復。