- 您現在的位置：買賣IC網 > PDF目錄374746 > sda 2526-5 (SIEMENS AG) Nonvolatile Memory 1-Kbit EEPROM(非易失性存儲器1K位 EEPROM) PDF資料下載
參數資料
| 型號： | sda 2526-5 |
| 廠商： | SIEMENS AG |
| 英文描述： | Nonvolatile Memory 1-Kbit EEPROM(非易失性存儲器1K位 EEPROM) |
| 中文描述： | 非易失性內存1千位的EEPROM（非易失性存儲器每1000位的EEPROM） |
| 文件頁數： | 3/12頁 |
| 文件大小： | 267K |
| 代理商： | SDA 2526-5 |
Semiconductor Group
19
SDA 2526-5
Memory Reprogramming
The reprogramming cycle of a memory word comprises an erase and a subsequent write process.
During erase, all eight bits of the selected word are set into the "1" state. During write, "0" states are
generated according to the information in the internal data register, i.e. according to the third input
control word. After the 27th and last clock of the control word input, the active programming process
is started by the stop condition. The active reprogramming process is executed under on-chip
control.
The time required for reprogramming depends on component deviation and data patterns.
Therefore, with rated supply voltage, the erase/write process extends over max. 20 ms, or more
typically, 10 ms. In the case of data word input without write request (write request is defined as data
bit in data register set to "0"), the write process is suppressed and the programming time is
shortened. During a subsequent programming of an already erased memory address, the erase
process is suppressed again, so that the reprogramming time is also shortened.
Important: Switch-On Mode and Chip Reset
After the supply voltage
V
CC
has been connected, the data output will be in high-impedance mode.
As a rule,
the first operating mode
to be entered, should be the
read process of a word address
.
As a result of the built-in "power-on reset" circuit, programming requests will not be accepted
immediately after the supply voltage has been switched on.
Total Erase
Enter the control word CS/E, load the address register with address 0 and the data register with FF
(hex) to erase the entire contents of the memory. Switch input CS2 to "open" immediately prior to
generating the stop condition. The subsequent stop condition triggers a total erase. Upon
termination of "total erase", CS2 must be reconnected to either 0 V or
≥
4.5 V.
相關PDF資料 |
PDF描述 |
|---|---|
| sdA 30c263 | 8-Bit Microcontroller, ROMLESS(8位微控制器，無ROM) |
| sdA 30c264 | 8-Bit Microcontroller, ROMLESS(8位微控制器，無ROM) |
| SDA 4336 | PLL Frequency Synthesizer, IF Counter, 7 bit ADC, 7 & 4 bit DAC with two channel digital alignment(包含IF計數器,7位ADC,7及4位DAC和兩通道數字對齊的用于汽車收音機的鎖相環頻率合成器) |
| SDA 5273-3C | Powerful One-Chip VideoText Decoder(單片視頻圖文解碼器) |
| sda 5273 | TVTEXT Controller(TV圖文控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SDA2526-5 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Nonvolatile Memory 2-Kbit E2PROM with I2C Bus |
| SDA253DF | 制造商:SSDI 制造商全稱:Solid States Devices, Inc 功能描述:50A / 400 - 800V THREE PHASE BRIDGE RECTIFIER ASSEMBLY |
| SDA253EF | 制造商:SSDI 制造商全稱:Solid States Devices, Inc 功能描述:50A / 400 - 800V THREE PHASE BRIDGE RECTIFIER ASSEMBLY |
| SDA253F | 制造商:SSDI 制造商全稱:Solid States Devices, Inc 功能描述:50A / 400 - 800V THREE PHASE BRIDGE RECTIFIER ASSEMBLY |
| SDA253FF | 制造商:SSDI 制造商全稱:Solid States Devices, Inc 功能描述:50A / 400 - 800V THREE PHASE BRIDGE RECTIFIER ASSEMBLY |
發布緊急采購，3分鐘左右您將得到回復。