- 您現在的位置：買賣IC網 > PDF目錄271627 > SD-14592F3-505Q (DATA DEVICE CORP) SYNCHRO OR RESOLVER TO DIGITAL CONVERTER, CDFP36 PDF資料下載
參數資料
| 型號： | SD-14592F3-505Q |
| 廠商： | DATA DEVICE CORP |
| 元件分類： | 位置變換器 |
| 英文描述： | SYNCHRO OR RESOLVER TO DIGITAL CONVERTER, CDFP36 |
| 封裝： | CERAMIC, FP-36 |
| 文件頁數： | 15/16頁 |
| 文件大?。?/td> | 152K |
| 代理商： | SD-14592F3-505Q |
8
Data Device Corporation
www.ddc-web.com
SD-14590/91/92
D-02/02-250
be critically damped. FIGURE 8 shows the response to a step
input.
After initial slewing at the maximum tracking rate of the convert-
er, there is one overshoot (which is inherent in a Type II servo).
The overshoot settling to final value is a function of the small sig-
nal settling time. For Velocity output, the simple filter shown in
FIGURE 9 will eliminate the one overshoot for step velocity input
and will filter the carrier frequency ripple.
ANALOG OUTPUTS
The analog outputs are velocity (VEL) and AC error (e). Both out-
puts can swing ±3.5 V min. with respect to V.
The AC error, e, is proportional to the error (
θ - φ) with a scaling
of 6.310 mV/LSB (14-bit mode), and 3.125 mV/LSB (16-bit
mode). Velocity output characteristics are listed in TABLE 4.
STANDARD
PARAMETER
UNITS
TABLE 4. VELOCITY CHARACTERISTICS
Polarity
Output Voltage
Voltage Scaling
Scale Factor
Scale Factor TC
Reversal Error
Reversal Error TC
Linearity
Linearity TC
Zero Offset
Zero Offset TC
Load
V
RPS
%
PPM/°C
%
PPM/°C
% output
PPM/°C
mV
V/°C
k Ohm
Positive for increasing angle.
3.5
See Voltage Scaling Table 5.
10
15
100
200
12
25
50
12
25
50
15
35
25
50
—
3 min
TYP
MAX
RESOLUTION (VALUES IN RPS/VOLT)
BANDWIDTH
TABLE 5. VELOCITY VOLTAGE SCALING
HI
LO
2.8
0.71
0.17
Note: If the resolution is changed while the input is changing, then
the velocity output voltage and the digital output will have a transient
until it settles to the new velocity scaling at a speed determined by
the bandwidth. If additional information is required, consult the factory.
14
16
OVERSHOOT
SMALL SIGNAL
SETTLING TIME
MAX SLOPE EQUALS
TRACKING RATE
(SLEW RATE)
θ2
θ1
SETTLING TIME
FIGURE 8. RESPONSE TO A STEP INPUT
OUTPUT
91k
VEL
(pin 23)
0.1 F
RC = 1/A
FIGURE 9. VELOCITY FILTER
VELOCITY OUTPUT
The Velocity output (VEL) from the SD-14590 is a DC voltage
proportional to angular velocity d
θ/dt = dφ/dt. The velocity input is
the second integrator, as shown in FIGURE 6. Its linearity is
dependent solely on the linearity of the voltage controlled oscil-
lator (VCO). Due to the highly linearized VEL output, the electro-
mechanical tachometer can now be eliminated from motion con-
trol systems. Bandwidth (BW) and the acceleration constant (Ka)
can be determined from the formula shown:
BW(Hz) = BW(rad/sec)/2
π
Ka = A2
Outputs e and VEL are not required for normal operation of the
converter. V is used as an internal DC reference with the direct
input option. Maximum loading on V is 40k ohm; maximum load-
ing for e and VEL is 3k ohm. The velocity characteristics are
shown in TABLES 4 and 5. Output e is not closely controlled or
characterized. Consult the factory for further information.
相關PDF資料 |
PDF描述 |
|---|---|
| SDC-14567-231Z | SYNCHRO OR RESOLVER TO DIGITAL CONVERTER, DIP36 |
| SDC-14567-261L | SYNCHRO OR RESOLVER TO DIGITAL CONVERTER, DIP36 |
| SD-14590D3-535S | SYNCHRO OR RESOLVER TO DIGITAL CONVERTER, MDIP36 |
| SD-14591F2-324Q | SYNCHRO OR RESOLVER TO DIGITAL CONVERTER, CDFP36 |
| SD-14591F2-324S | SYNCHRO OR RESOLVER TO DIGITAL CONVERTER, CDFP36 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SD-14595D1-102 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Synchro-to-Digital Converter |
| SD-14595D1-104 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Synchro-to-Digital Converter |
| SD-14595D1-105 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Synchro-to-Digital Converter |
| SD-14595D1-112 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Synchro-to-Digital Converter |
| SD-14595D1-114 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Synchro-to-Digital Converter |
發布緊急采購，3分鐘左右您將得到回復。