參數資料
型號: SC80C32XXX-36SB
廠商: ATMEL CORP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, 36 MHz, MICROCONTROLLER, CDIP40
封裝: 0.600 INCH, SIDE BRAZED, DIP-40
文件頁數: 16/20頁
文件大?。?/td> 194K
代理商: SC80C32XXX-36SB
80C32/80C52/80C32E
5
Rev. J
July 03, 2000
Port Pin
Alternate Function
P3.0
P3.1
P3.2
P3.3
P3.4
P3.5
P3.6
P3.7
RXD (serial input port)
TXD (serial output port)
INT0 (external interrupt 0)
INT1 (external interrupt 1)
TD (Timer 0 external input)
T1 (Timer 1 external input)
WR (external Data Memory write strobe)
RD (external Data Memory read strobe)
Port 3 can sink/source three LS TTL inputs. It can drive CMOS inputs without external pullups.
4.7. RST
A high level on this for two machine cycles while the oscillator is running resets the device. An internal pull-down
resistor permits Power-On reset using only a capacitor connected to VCC. As soon as the Reset is applied (Vin), PORT
1, 2 and 3 are tied to one. This operation is achieved asynchronously even if the oscillator does not start-up.
4.8. ALE
Address Latch Enable output for latching the low byte of the address during accesses to external memory. ALE is
activated as though for this purpose at a constant rate of 1/6 the oscillator frequency except during an external data
memory access at which time one ALE pulse is skipped. ALE can sink/source 8 LS TTL inputs. It can drive CMOS
inputs without an external pullup.
4.9. PSEN
Program Store Enable output is the read strobe to external Program Memory. PSEN is activated twice each machine
cycle during fetches from external Program Memory. (However, when executing out of external Program Memory, two
activations of PSEN are skipped during each access to external Data Memory). PSEN is not activated during fetches
from internal Program Memory. PSEN can sink/source 8 LS TTL inputs. It can drive CMOS inputs without an external
pullup.
4.10. EA
When EA is held high, the CPU executes out of internal Program Memory (unless the Program Counter exceeds 1
FFFH). When EA is held low, the CPU executes only out of external Program Memory. EA must not be floated.
4.11. XTAL1
Input to the inverting amplifier that forms the oscillator. Receives the external oscillator signal when an external
oscillator is used.
Output of the inverting amplifier that forms the oscillator. This pin should be floated when an external oscillator is used.
相關PDF資料
PDF描述
SC80C52XXX-12 8-BIT, MROM, 12 MHz, MICROCONTROLLER, CDIP40
SJ80C32XXX-36SC 8-BIT, 36 MHz, MICROCONTROLLER, CQCC44
SJ80C52XXX-12 8-BIT, MROM, 12 MHz, MICROCONTROLLER, CQCC44
SJ80C32XXX-36/883 8-BIT, 36 MHz, MICROCONTROLLER, QCC44
SJ80C52XXX-12SC 8-BIT, MROM, 12 MHz, MICROCONTROLLER, CQCC44
相關代理商/技術參數
參數描述
SC80C451ACN64 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller
SC80C451AGN64 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller
SC80C451CCA68 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:80C51 8-bit microcontroller family 4K/128 OTP/ROM/ROMless, expanded I/O
SC80C451CCN64 制造商:NXP Semiconductors 功能描述:
SC80C451CGA68 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:80C51 8-bit microcontroller family 4K/128 OTP/ROM/ROMless, expanded I/O